Bedienungsanleitung Pella 80ED0101

8 Seiten 0.77 mb
Download

Zur Seite of 8

Summary
  • Pella 80ED0101 - page 1

    INST ALLA TION INSTRUCTIONS - INSTRUCCIONES DE INST ALACION FOR HURRICANESHIELD ® IMP ACT -RESIST ANT DOUBLE-HUNG, SINGLE-HUNG AND SIMULA TED-HUNG Part Number: 80ED0101 ©2008 Pella Corporation Instrucciones en español en el rev erso. Fin Corner Nailing Fin Window Bottom Sill Flashing T ape #2 Sill Flashing T ape #1 Water Resistive Barrier Sheath ...

  • Pella 80ED0101 - page 2

    REMEMBER T O USE APPR OPRIA TE PERSONAL PR O TECTIVE EQUIPMENT . 1 ROUGH OPENING PREP ARA TION A. V erify the opening is plumb and lev el. N ote: It is critical that the bottom is level. B. V erify the window will fit the opening. Measur e all four sides of the opening to make sure it is 1/2" larger than the window in both width and height. O ...

  • Pella 80ED0101 - page 3

    2 PREP ARE THE WINDOW A. Remo v e plastic wrap and cardboar d packaging from windo w . DO NO T cut the checkrail bands or remov e plastic shipping spacers located between the window sash and frame. The shipping spacers will help keep the window square during installation. DO NO T open the window until it is fully fastened. N ote: If screens, grille ...

  • Pella 80ED0101 - page 4

    4 INST ALLA TION CLIP METHOD A. F asten the window to the opening BYDRIVINGTWOXCORR OSION resistant screws into the pre-punched holes in the clips. I f clips are bent and fastened to the interior stud/block, install the screws as close to the bend as possible. N ote: DO NO T shim above the window . F ...

  • Pella 80ED0101 - page 5

    5 FRAME SCREW METHOD 5B A. Mark the location of the top of the lo wer sash on the rough opening. N ote: Marking this location is needed for the corr ect placement of the frame scr ews. Interior T op of lower sash 5A Finger slides are located on the top, back side of the lower sash. 5C B. S imulated-hung only: Remo ve the simulated-hung lock by remo ...

  • Pella 80ED0101 - page 6

    6 INTEGRA TING THE WINDOW TO THE WA TER RESISTIVE BARRIER N ote: The flashing tape must be applied approximately 1/2" onto the frame cladding at the jambs and head. Pr e-folding the tape at 1/2" befor e remo ving the paper backing will make it easier to apply the tape correctly . If the siding is less than 1/2" thick, adjust the dim ...

  • Pella 80ED0101 - page 7

    C. F old down top flap of water r esistive barrier (6C). D. Apply flashing tape to diagonal cuts. Cut pieces of flashing tape at least 1" longer than the diagonal cuts in the water resistive barrier . Apply the tape co vering the entire diagonal cut in the water resistive barrier at both upper corners of the window . N ote: Be sure to o ver ...

  • Pella 80ED0101 - page 8

    EXTERIOR FINISH The exterior frame and sash are protected by aluminum cladding with our tough EnduraClad ® or E nduraClad Plus baked-on factory finish that needs no painting. Clean this surface with mild soap and water . Stubborn stains and deposits may be remov ed with mineral spirits. DO NOT use abrasiv es. DO NO T scrape or use tools that migh ...

Produzent Pella Kategorie Window

Dokumente, die wir vom Produzenten des Geräts Pella 80ED0101 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Pella
- Bedienungsanleitungen 80ED0101
- Produktkarten Pella
- Informationsbroschüren
- oder Energieetiketten Pella 80ED0101
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Pella 80ED0101.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Pella 80ED0101, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Pella 80ED0101. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Pella 80ED0101 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Pella 80ED0101, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Pella 80ED0101 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Pella 80ED0101 verständlich ist.

Eine gänzliche Bedienungsanleitung von Pella sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Pella 80ED0101 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Pella 80ED0101 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Pella 80ED0101, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Pella 80ED0101 - die uns die ersten Schritte während der Nutzung von Pella 80ED0101 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Pella 80ED0101 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Pella 80ED0101 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Pella 80ED0101?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Pella 80ED0101 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Pella 80ED0101 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)