Bedienungsanleitung Haier XQB50-20

20 Seiten 1.01 mb
Download

Zur Seite of 20

Summary
  • Haier XQB50-20 - page 1

    XQB50-20 Part specialized code 0030504485 The product is used only in the Chinese continent..If other countries or areas need it, please contact us . Before using User's manual Fuzzy Logic Automatic Washing Machine Contents Names of the parts.........the 2nd cover Safety precautions ............................1 Special function introduction . ...

  • Haier XQB50-20 - page 2

    Adjustable foot Adjustable foot labal Cabinet Base Control panal Control panel film Pulsator T op lid component Power line Location for lint filter Fixed foot(3) Back cover Drain hose Cabinet handle Hanging hole for the drain hose Water absorption cushion Water valve Blance ring Inner tub Names of the par ts Honorable users, Thanks for your choosin ...

  • Haier XQB50-20 - page 3

    Before Using Before Using Safety precautions 1 The ventilation holes at the bottom In case the washing machine is installed on ground with carpet, be careful not to block the ventilation hole with carpet. Do not put the machine at damp place like the bathroom. Never wash it with water. Do not put wet laundries on the control panel coating. Do not l ...

  • Haier XQB50-20 - page 4

    Before Using Before Using Safety precautions Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items (such as the kettle with hot water ) on the washing machine . Do not wash laundries with volatile materials (such as thinner, petrol etc.) The handicapped or children without care shall not use the machine. Keep ...

  • Haier XQB50-20 - page 5

    After switching on the Power , select the memory programme(the tube on).Then select appropriate time of SOAK, WASH and SPIN and the time of rinse on need. After setting, the washing machine memorized the programme set by yourself. When switching on the Power again, press the PROGRAM button, and select the MEMORY p rogram, the program set by yoursel ...

  • Haier XQB50-20 - page 6

    1 Loosen the fastening screws of the back cover,unpack the back cover gently, avoiding to break the clip claw . Figure 1 3 Stretch out the drain hose to the right of the frame from the groove. Fasten it in the base frame with the drain hose support, and fasten the screws.Then hang the hook in the drain hose, and hang the drain hose in the hole of t ...

  • Haier XQB50-20 - page 7

    Water faucet, suitable Water faucet, not suitable It is required that the front end shall be longer than 10cm. The outlet end surface of the faucet shall be flat and smooth. If not please file it to avoid leakage. 2. Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If t ...

  • Haier XQB50-20 - page 8

    1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. 3.Fasten the nut. Swing it gently to confirm if it's suitable. 1.Close the water faucet. 2.Press the ...

  • Haier XQB50-20 - page 9

    Preparation before washing 1. Connect the water inlet hose. 2. Confirm that the washing machine is earthed reliably. Then inse rt the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose. Using process Using process 1 Pr epar a tion before washing Pay attention to followings ...

  • Haier XQB50-20 - page 10

    Reference weight of the laundries: working suit(up,down) Jeans(about 800g) The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition (as per the laundries stipulated in the A2 Attachment of GB4288-1992 standard) that can be washed or spun in one time. One time washing quantity shal ...

  • Haier XQB50-20 - page 11

    Detergent box Softner dispenser Location for liquid bleacher Control panal Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color. The whitener shall not touch the laundries directly. Refer to the user's manual ...

  • Haier XQB50-20 - page 12

    When the tube Press the RINSE button to set the process of RINSE. During the NORMAL or COTTON program, press the RINSE button to setdifferent times( 1234 times). During the QUICK program, press the RINSE button,the washing machine does not response. is on, it indicates that you have chosen the ELIMINATING FOAM RINSE PROGRAM, and perform eliminating ...

  • Haier XQB50-20 - page 13

    POWER ON / OFF START PAUSE RESERVE PROGRAM Reserve(hours later) XQB50-20 NORMAL MEMORY Fuzzy ON/OFF button Press the ON/OFF button to switch on the power After the power is on,another press will switch off the power. After the power is on, if not press the START/P AUSE button, the washing machine will be shut-off 5 minutes later automatically. Duri ...

  • Haier XQB50-20 - page 14

    ...

  • Haier XQB50-20 - page 15

    Time list of each program WITHOUT SELF-EDIT PROGRAM The soak program can be used as fitting of the STANDARD , COTT ON, JEANS and FIBRE automatic programs. Soak with slight stirring before wash. With SOAK Without SOAK Rinse twice, each about 2-3 Rinse thrice, each about 2-3 Rinse twice, each about 2-3 Rinse twice, each about 2-3 Rinse twice, each ab ...

  • Haier XQB50-20 - page 16

    Using process Using process * * * * Total time: including the normal water inlet time and drain time. Spin time: the time from intermittent run ning to finishing When selecting SOAK program, first soak for 10-40 minutes, then do wash, rinse, spin. The total washing time may be influenced by the water inlet pressure and water level. When selecting Q ...

  • Haier XQB50-20 - page 17

    Using process Using process 7 Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise, it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. The filter screen of the water inlet valve is likely to be blocked by foreign mat ...

  • Haier XQB50-20 - page 18

    Are the laundries put slantingly in spinning? Is the water pressure too low? Is the screw of the jointer of water inlet hose loose or awry? The water tap leaks There's abnormal sound inside the machine Fasten the screw of the jointer properly. The machine does not act Is the power plug inserted tightly? Is there power failure? Is the power plu ...

  • Haier XQB50-20 - page 19

    Packing list 17 User's manual Name Warranty card Quantity Storage position Lint filter Inside the document bag Bottom plate One One One One Five One Inside the document bag Inside the document bag Inside the accessory bag Between the upper cushion of the washing machine package and the upper seal of the package carton Inside the accessory bag ...

  • Haier XQB50-20 - page 20

    Specification Specification Model XQB50-20 Rated voltage frequency 220V-240V/ 50Hz Rated washing / spinning capacity 5 .0kg (weight of standard dry cloth) Water level/Water quantity (about) Max water consumption Injection pressure 0.03Mpa~0.78Mpa Rated washing power 350W Rated spinning power 255W Weight About 25kg Dimension L 537 mm W 520 mm H 890 ...

Produzent Haier Kategorie Washer

Dokumente, die wir vom Produzenten des Geräts Haier XQB50-20 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Haier
- Bedienungsanleitungen XQB50-20
- Produktkarten Haier
- Informationsbroschüren
- oder Energieetiketten Haier XQB50-20
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Haier XQB50-20.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Haier XQB50-20, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Haier XQB50-20. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Haier XQB50-20 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Haier XQB50-20, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Haier XQB50-20 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Haier XQB50-20 verständlich ist.

Eine gänzliche Bedienungsanleitung von Haier sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Haier XQB50-20 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Haier XQB50-20 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Haier XQB50-20, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Haier XQB50-20 - die uns die ersten Schritte während der Nutzung von Haier XQB50-20 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Haier XQB50-20 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Haier XQB50-20 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Haier XQB50-20?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Haier XQB50-20 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Haier XQB50-20 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)