Bedienungsanleitung Boca Research None

14 Seiten 0.42 mb
Download

Zur Seite of 14

Summary
  • Boca Research None - page 1

    Muon Liquid Handling System User Guide C. Johnson, S.P. Cottrell et al Version 0.2 - 1 - ...

  • Boca Research None - page 2

    Contents 1 Getting Started 3 1.1 Layout of the liquid handling system 3 1.2 Layout of the in situ sample stick 4 1.3 Layout of the pump 4 2 General procedures 6 2.1 Sample loading 6 2.1.1 Loading Vessel 1 6 2.1.2 Loading Vessel 2 6 2.2 Evacuation of the system 6 2.2.1 Removing air from Vessel 1 7 2.2.2 Removing air from Vessel 2 7 2.2.3 Removing ai ...

  • Boca Research None - page 3

    1 Getting S t arted This manual describes the liquid handling system and the in situ sample cell as use d on the DEVA instrument with the “RF” spect rometer, for either norm al muon spins relaxation or RF resonance experiments. 1.1 Layout of the liquid handling sy stem The Muon Liquid Handling System has been designed to facilitate the in situ ...

  • Boca Research None - page 4

    1.2 Layout of the in situ sample stick The liquid sample stick is designed to fit into the DEVA f low cryostat, details of which can be found in the DEVA manual. It consists of a shapol target cell 30 mm x 30 mm with a mylar window upon which may be mounted an RF coil. Two stainless steel capillaries provide a mean s of flowing liquid into and out ...

  • Boca Research None - page 5

    Roughing/ Turbo switch Off/Run switch Pressure reading Turbo control panel Turbo Pump Rotary Pump Figure 2 The lay out of the fr ont panel o n the vacuum pump use d with the muon liqui d handlin g system. - 5 - ...

  • Boca Research None - page 6

    2 General procedures 2.1 Sample loading At this point, the system will be open to the atm osphere, ensure that valve V2 is closed to prevent air cond ensation in the cold trap. 2.1.1 Loading Vessel 1 • Open the tap on the right-hand side of Vessel 1. • Open tap A and valve V11. • The liquid should be poured into the system very slowly to avoi ...

  • Boca Research None - page 7

    2.2.1 Removing air from Vessel 1 Once the system has been pressuris ed, tap A on Vessel 1 can be opened. It is possible to bubbled helium gas through the sample liqui d against the non-retu rn valve, V13. If this is required, first ensure th at valves V 5, V7 and V8 are closed. Open valves V10 and V6, finally opening tap B slowly in order to regula ...

  • Boca Research None - page 8

    2.3 Freeze-Pump-Thaw cycle Using this system it is possible to o perat e freeze-pump-thaw cycles on sam ple liquids held in any of the three vessels. Procedur es appropriate to ea ch vessel are outlined below. 2.3.1 Sample in Vessel 1 • All taps and valves should be closed. • Open valve V2 and tap A on Vessel 1, and freeze the sample liquid by ...

  • Boca Research None - page 9

    2.3.3 Sample in Vessel 3 • All taps and valves should be closed. • Open valves V2 and V3 along with tap C on Vessel 3 and freeze the sample liquid by slowly raising a dewa r of liquid nitrogen around it. • When it has been determined that the liquid ha s completely frozen switch the pump to roughing mode and open valve V1. • Switch the pump ...

  • Boca Research None - page 10

    2.4.2 Vessel 3 to sample cell The transfer of liquid from Vessel 3 to the sample cell is brought about by the difference in pressure between that in the Vessel and a vacuum in the cell. However, in order to control the transfer of liquid th e pressure difference shou ld be as small as possible but not so low that the liquid starts to boil. • Swit ...

  • Boca Research None - page 11

    2.4.4 Recovery of liquid in sample cell to Vessel 1 The liquid in the sample cell cannot be recovered to Vessel 1 using the liquid handling rig as presently configured. 2.4.5 Recovery of liquid in sample cell to Vessel 2 The liquid in the sample cell can be r ecovered to Vessel 2 using the following procedure. • Vessel 2 should be under vacuum al ...

  • Boca Research None - page 12

    • All the liquid may not return in a single pass and repea ting the evacuation procedure may be required. However, some liquid m ay be present in the system and care should be taken during evacuation that th e trap does not become blocked. The liquid may also be encouraged to leave the sample cell by using a small amount of gas. • Close valve V ...

  • Boca Research None - page 13

    3 Example Experiment The paramagnetic signal in liquid n-hexane is difficult to observe because the muonium polarisation is found to decay on a microsecond time scale, which is further reduced by the presence of dissolved oxygen. A series of commi ssioning experim ents were carried out using n-hexane in order to gauge the ability of the liquid hand ...

  • Boca Research None - page 14

    0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) 0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 Initial asymmetry (%) Time ( µ s) 1.5 2.0 2.5 3.0 0.0 0.5 1.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) a) b) c) Figure 1 Muonium precessi on signal at 2G in n- hexane after a) 4, ...

Produzent Boca Research Kategorie Heat Pump

Dokumente, die wir vom Produzenten des Geräts Boca Research None erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Boca Research
- Bedienungsanleitungen None
- Produktkarten Boca Research
- Informationsbroschüren
- oder Energieetiketten Boca Research None
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Boca Research None.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Boca Research None, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Boca Research None. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Boca Research None ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Boca Research None, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Boca Research None hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Boca Research None verständlich ist.

Eine gänzliche Bedienungsanleitung von Boca Research sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Boca Research None bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Boca Research None befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Boca Research None, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Boca Research None - die uns die ersten Schritte während der Nutzung von Boca Research None erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Boca Research None hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Boca Research None im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Boca Research None?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Boca Research None nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Boca Research None hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)