Bedienungsanleitung NEC NP03CM

16 Seiten Betrifft nicht
Download

Zur Seite of 16

Summary
  • NEC NP03CM - page 1

    Portable Projector NP03CM Ceiling Mount Unit Installation and Adjustment Manual Thank you for your purchase of the NEC portable projector ceiling mount unit. Please read this installation and adjustment manual carefully to ensure proper use. Special skills are required for the installation of the portable projector. This work should never be perfor ...

  • NEC NP03CM - page 2

    2 Heed the Follo wing • When installing the projector, be sure to do so as explained in this manual. The projector may fall and cause injury if it is installed improperly. • To prevent the projector from falling, install it in a place and fasten it in a way with sufficient strength to support the combined weight (4.9 kg) of the projector (2.9 k ...

  • NEC NP03CM - page 3

    3 CA UTION • Do not obstruct the projector's ventilation holes. Doing so will prevent the dissipation of heat and may result in fires. In particular, do not use the projector in the following ways: Do not install the projector in a wall or in a tight place where ventilation is poor, place a cover it, etc. • Do not install the projector in ...

  • NEC NP03CM - page 4

    4 • Distance to lens end Center line of fixed ceiling part Lens center 70 105.2 162.5 90 90 60 60 80.4 10 4 - Preparation List of P acka ged Parts Fixed ceiling part ...1 Projector mounting adapter ...1 Projector mounting screws (M 4)...3 Up-down angle adjustment screws (M5 ) ...4 Installation and adjustment manual ..........1 Required T ools Phi ...

  • NEC NP03CM - page 5

    5 Zoom adjustment range 25 0123456789 1 0 12(m) 40 60 80 100 120 150 180 200 240 300 11 Wide angle (Maximum) Telephoto (Maximum) Guide to Screen Size and Projector Mounting Position Screen Size and Projection Distance ··· (VT580/VT480/VT58/VT57/VT595/VT590/VT491/VT490/VT59) Use this guide when considering the distance to the screen and the scree ...

  • NEC NP03CM - page 6

    6 Guide to Screen Size and Projector Mounting Position 25 01234567 8 9 1 0 11(m) 40 60 80 100 120 150 180 200 240 300 ( 型 ) Screen Size and Projection Distance···VT48/VT49 Use this guide when considering the distance to the screen and the screen size. • The ceiling mount unit can be adjusted up and down a maximum of +/-10 ˚ , but if too ...

  • NEC NP03CM - page 7

    7 Guide to Screen Size and Projector Mounting Position Zoom adjustment range 25 0123456789 1 0 12(m) 40 60 80 100 120 150 180 200 240 300 11 Telephoto (Maximum) Wide angle (Maximum) Screen Size and Projection Distance···VT695 Use this guide when considering the distance to the screen and the screen size. • The ceiling mount unit can be adjuste ...

  • NEC NP03CM - page 8

    Guide to Screen Size and Projector Mounting Position 8 (m) 25 0 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0m 40 60 80 100 120 150 180 200 240 270 300 (Inches) Screen Size Con version T able Using the Table The dimensions of a 100 inch screen size according to the table will be approximately 2 m horizontally ...

  • NEC NP03CM - page 9

    9 1 Mounting the Pr ojector Attach the Fixed Ceiling P ar t to the Ceiling First, partially tighten the four screws, then tighten the screws firmly after positioning. Use M8 bolts for the fixed ceiling part. Use of types other than M8 could cause the projector to fall. W ARNING! Fixed ceiling part 2 Attach the Pr ojector Mounting Adapter to the Pro ...

  • NEC NP03CM - page 10

    10 3 4 Mounting the Projector Suspend the Projector fr om the Fixed Ceiling P ar t Slide the slotted part of the projector mounting adapter over the pin of the fixed ceiling part and push all the way to the back. The projector is temporarily suspended in this condition and attention must be paid so that the unit does not fall since it is not fixed ...

  • NEC NP03CM - page 11

    Mounting the Projector 11 NOTE : Mounting boards, M8-type anchor nuts, bolts, nuts and washers are commercially available. Mounting board (Strong enough to support the weight of the whole unit.) Nut and washer Beam Nut and washer Bolt (M8) Anchor nut (Purchase commercially-available M8-type anchor nuts that are strong enough to endure the weight of ...

  • NEC NP03CM - page 12

    12 1 2 3 Replacing the Lamp To replace the lamp, first switch off the power, wait for the cooling fans to stop and disconnect the power plug from the outlet. Now, wait about 60 minutes before replacing the lamp. Attempts to replace the lamp during operation or immediately after operation has stopped will cause burns because of the high temperature. ...

  • NEC NP03CM - page 13

    13 1 10 ˚  10 ˚  上下端 Upper and lower  edges Adjustment of the Pr ojection Angle Before the Adjustment • Refer to the instruction manual of the projector, switch on the power and project an image. • Refer to the section "Orientation " of Setup and select the projection orientation. Select "Ceiling/Front" when ...

  • NEC NP03CM - page 14

    10 ˚ 1 0 ˚  14 Left and right edges 10 ˚  10 ˚  2 3 Adjustment of the Projection Angle Adjust the Up-Down Angle Turn the projector up and down so that the left and right edges of the screen are parallel, then firmly tighten the four up-down angle adjustment screws. It is acceptable if the image extends beyond the screen. Maximum adj ...

  • NEC NP03CM - page 15

    15 Adjustment of the Projection Angle Fine Adjustment After the adjustments, chec k that the par ts are fixed securel y . Loosen the same screws that were used in the distortion adjustment and finely adjust the angle so that the projected image fits the screen, then tighten all the screws (i.e., a total of 14 including the inclination axis screws). ...

  • NEC NP03CM - page 16

    MEMO NP03CM_E 07.3.12 2:15 PM ページ 16 ...

Produzent NEC Kategorie Projector accessory

Dokumente, die wir vom Produzenten des Geräts NEC NP03CM erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen NEC
- Bedienungsanleitungen NP03CM
- Produktkarten NEC
- Informationsbroschüren
- oder Energieetiketten NEC NP03CM
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung NEC NP03CM.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen NEC NP03CM, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen NEC NP03CM. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts NEC NP03CM ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts NEC NP03CM, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von NEC NP03CM hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von NEC NP03CM verständlich ist.

Eine gänzliche Bedienungsanleitung von NEC sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von NEC NP03CM bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von NEC NP03CM befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich NEC NP03CM, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts NEC NP03CM - die uns die ersten Schritte während der Nutzung von NEC NP03CM erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit NEC NP03CM hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von NEC NP03CM im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich NEC NP03CM?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit NEC NP03CM nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit NEC NP03CM hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)