-
Linksys WAP51AB - page 1
Instant Wireless TM Series Dual-Band Wireless Access Point Use this guide to install: W AP51AB User Guide ...
-
Linksys WAP51AB - page 2
COPYRIGHT & TRADEMARKS Copyright © 2002 Linksys, All Rights Reserved. Linksys is a register ed trademark of Linksys. Instant Wireless is a trademark of Linksys. Micr osoft, Windows, and the Windows logo are r egistered trademarks of Microsoft Corporation. All other trademarks and brand names are the pr operty of their respective proprietors. L ...
-
Linksys WAP51AB - page 3
Dual-Band Wireless Access Point Chapter 1: Introduction The Instant Wireless TM Dual-Band Wir eless Access Point Install an access point that protects your infrastructure in vestment without lim- iting you to a single type of wireless technolo gy . The Instant W ireless™ Dual- Band W ireless Access P oint w orks simultaneously with both 802.11a a ...
-
Linksys WAP51AB - page 4
Dual-Band Wireless Access Point 3 Chapter 2: Planning Y our Wireless Network A wireless LAN is a group of computers, each equipped with one Instant W ireless™ Series adapter . Computers in a wireless LAN must be conf igured to share the same radio channel. The Instant W ireless™ Series adapters pro vide access to a wired LAN for wire- less w or ...
-
Linksys WAP51AB - page 5
Dual-Band Wireless Access Point Instant Wireless TM Series Chapter 3: Getting to Know the Dual-Band Wireless Access Point The Access P oint’ s por ts, where a netw ork cable is connected , are located on the Access P oint’ s back panel. LAN This LAN (Local Area Netw ork) port connects to Ethernet network de vices, such as a hub, switch, or rout ...
-
Linksys WAP51AB - page 6
Chapter 5: Setting Up the Dual- Band Wireless Access Point No w that you’ ve connected the Access P oint to your wired netw ork, you are ready to begin setting it up. This Setup W izard will take you through all the steps necessary to conf igure the Access P oint. 1. Insert the Setup W izard CD into your PC’ s CD-R OM driv e. Y our PC must be o ...
-
Linksys WAP51AB - page 7
9 3. The follo wing screen, shown in F igure 5-2, displays ho w the Access P oint is conf igured in this Setup W izard. Optimally , you should perform this setup through a PC on your wired netw ork. Click the Next button to con- tinue or Exit to exit the Setup Wizard. 8 4. The next screen to appear , sho wn in Figure 5-3, will displa y a list of ac ...
-
Linksys WAP51AB - page 8
The WEP key can consist of the letters “ A” through “F” and the numbers “0” through “9” and should be 10 characters in length for 64-bit encryption, 26 characters in length for 128-bit encryption, or 32 characters in length for 152-bit encryption. All points in your wireless netw ork must use the same WEP key to utilize WEP encr ypt ...
-
Linksys WAP51AB - page 9
9. As shown in F igure 5-8, the Basic Settings screen for your 2.4 GHz/802.11b wireless products will appear . Enter your wireless netw ork’ s SSID and select the channel at which the netw ork broadcasts its wireless signal. Then, click the Next button to continue or Back to return to the pre- vious page. • SSID. The SSID is the unique name sha ...
-
Linksys WAP51AB - page 10
Dual-Band Wireless Access Point 13. At this point, the conf iguration performed with the Setup W izard is com- plete, as sho wn in F igure 5-12. T o conf igure any other Access P oints in your netw ork, you can run this Setup W izard again. Click the Exit button to exit the Setup W izard. 15 Instant Wireless™ Series 11. The follo wing Security sc ...
-
Linksys WAP51AB - page 11
16 • Static IP Addr ess. This IP address must be unique to your netw ork. (The default IP address is 192.168.1.250. As this is a priv ate IP address, there is no need to purchase a separate IP address from your service pro vider .) V erify the address and click the Appl y button to sav e changes. • Subnet Mask. The Access P oint’ s Subnet Mas ...
-
Linksys WAP51AB - page 12
From the pull-do wn menu, select the type of WEP encr yption you wish to use. If you are using 5GHz/802.11a wireless technolo gy , you will need to enter the ke y manually . If you are using 2.4GHz/802.11b wireless technolo gy and wish to use a WEP Passphrase, it can be a maximum of 16 alphanumeric characters. This passphrase ma y not w ork with no ...
-
Linksys WAP51AB - page 13
Dual-Band Wireless Access Point The “Status” tab, sho wn in Figure 6-8, will displa y cur rent information on the Access P oint, its settings and perfor mance. • Firmw ar e V ersion. This displays the current version of the Access P oint’ s f irmw are. Firmware should onl y be upg raded if you e xperience problems with the Access P oint and ...
-
Linksys WAP51AB - page 14
Dual-Band Wireless Access Point UPGRADING FIRMW ARE: Before upgrading the Access P oint’ s f ir mware, be sure to do wnload the f ir mware from Linksys’ s website at www .linksys.com. Once that is done, click the Upgrade Firmw ar e link on the Help T ab. This will bring up the screen sho wn in Figure 6-10. T ype in the location of the f ir mwar ...
-
Linksys WAP51AB - page 15
Dual-Band Wireless Access Point • F ragmentation Length. This specif ies the maximum size a data packet will be before splitting and creating a new pack et and should remain at its default setting of 2,346. A smaller setting means smaller packets, w hich will create more packets for each transmission. If y ou ha ve decreased this v alue and exper ...
-
Linksys WAP51AB - page 16
Dual-Band Wireless Access Point Appendix A: T roubleshooting This chapter pro vides solutions to problems usuall y encountered during the installation and operation of the Access P oint. Read the description belo w to solve y our problems. If y ou can’ t f ind an ans w er here, check the Linksys w eb- site at www .linksys.com. Can the Access P oi ...
-
Linksys WAP51AB - page 17
Dual-Band Wireless Access Point What is ESSID? An Infrastructure conf iguration could also support roaming capability for mobile w orkers. More than one BSS can be conf igured as an Extended Service Set (ESS). Users within an ESS could roam freely betw een BSSs while main- taining a continuous connection to the wireless netw ork stations and Access ...
-
Linksys WAP51AB - page 18
Dual-Band Wireless Access Point Y ou ma y also try using different channels, as this ma y eliminate interference af fecting onl y one channel. Also, due to FCC regulations, more po w er ma y be transmitted , using 802.11a, on channels 52, 56, 60 and 64, than on the lo wer channels. Lastl y , check the Advanced tab of the W eb-Based Utility and make ...
-
Linksys WAP51AB - page 19
Dual-Band Wireless Access Point The follo wing instr uctions are pro vided as examples for reference only . F or complete instructions on installing and troubleshooting TCP/IP and IPX, con- sult your W indo ws operating system documentation. 1. Click the Start button, select Settings , and open the Control P anel . Inside the Control Panel, doub le ...
-
Linksys WAP51AB - page 20
Dual-Band Wireless Access Point 2. When the Netw ork windo w appears, click the Protocols tab . Then, click the Add button. 3. Find the IPX/SPX pr otocol in the Select Networ k Protocol f ield. Click it once and click the OK button. 1. At the W indo ws 2000 desktop, right click My Network Places and select Pr operties . Then, right click Local Ar e ...
-
Linksys WAP51AB - page 21
Instant Wireless™ Series 4. Select NWLink IPX/SPX/NetBIOS Compatible T ransport Protocol from the list and click the OK button. 5. When the Netw ork windo w reappears, click the OK button. Restar t your computer . NWLink IPX/SPX/NetBIOS Compatible Transport Protocol has no w been successfully installed. 1. Click the Start button and open the Cont ...
-
Linksys WAP51AB - page 22
quently . Using very shor t leases, DHCP can dynamicall y reconf igure netw orks in which there are more computers than there are a vailab le IP addresses. DHCP supports static addresses for computers containing W eb servers that need a permanent IP address. Do wnload - T o receiv e a f ile transmitted o ver a netw ork. In a communications session, ...
-
Linksys WAP51AB - page 23
The IEEE fosters the de velopment of standards that often become national and international standards. The organization pub lishes a number of journals, has man y local chapters, and sev eral large societies in special areas, such as the IEEE Computer Society . Infrastructur e - An infrastructure netw ork is a wireless netw ork or other small netw ...
-
Linksys WAP51AB - page 24
Dual-Band Wireless Access Point Serv er - Any computer w hose function in a network is to pro vide user access to f iles, printing, communications, and other ser vices. Softwar e - Instr uctions for the computer . A series of instructions that perfor ms a particular task is called a "program." The tw o major categories of softw are are &q ...
-
Linksys WAP51AB - page 25
Dual-Band Wireless Access Point Appendix D: Specifications Standards IEEE 802.3, 802.3u, 802.11a and 802.11b Channels 802.11a 8 Channels (US, Canada) 802.11b 11 Channels (US, Canada) 13 Channels (Europe) 14 Channels (Japan) P orts/Buttons One 10/100 RJ-45 Port, One P ow er P ort, One Reset Button, One P ow er Switch Cab ling T ype UTP CA T 5 or bet ...
-
Linksys WAP51AB - page 26
Dual-Band Wireless Access Point 47 Appendix E: W arranty Information BE SURE T O HA VE Y OUR PR OOF OF PURCHASE AND A BARCODE FR OM THE PR ODUCT’S P A CKAGING ON HAND WHEN CALLING. RETURN REQUESTS CANNO T BE PR OCESSED WITHOUT PR OOF OF PURCHASE. IN NO EVENT SHALL LINKSYS’S LIABILITY EXCEED THE PRICE P AID FOR THE PR ODUCT FR OM DIRECT , INDIRE ...
-
Linksys WAP51AB - page 27
Appendix F: Contact Information F or help with the installation or operation of this product, contact Linksys T echnical Suppor t at one of the phone numbers or Inter net addresses belo w . Sales Information 800-546-5797 (LINKSYS) T echnical Suppor t 800-326-7114 RMA Issues 949-261-1288 Fa x 949-261-8868 Email support@linksys.com We b http://www .l ...
-
Linksys WAP51AB - page 28
© Copyright 2002 Linksys, All Rights Reser ved. http://www .linksys.com ...
Haben Sie eine Frage bezüglich Linksys WAP51AB?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Linksys WAP51AB nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Linksys WAP51AB hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.