Bedienungsanleitung CDA SK300

24 Seiten Betrifft nicht
Download

Zur Seite of 24

Summary
  • CDA SK300 - page 1

    Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .care@cda.eu W : www .cda.eu SK200 and SK300 Single Ovens Manual for Installation, Use and Maintenance ...

  • CDA SK300 - page 2

    2 Important This appliance must only be used for the purpose for which it is intended, i.e. domestic cooking. Any other use could be dangerous and may lead to premature failure of the appliance. The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserv ...

  • CDA SK300 - page 3

    3 Appliance Model Serial Number CE Declarations of Conformity: This oven has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (L ow voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legis ...

  • CDA SK300 - page 4

    4 Important • R ead the user instructions carefully before using the oven for the first time. • Follow the instructions for first use of the oven. • Clean the oven regularly . • R emove spills as soon as they occur . • Always use oven gloves when removing shelves and trays from the ovens. • Do not allow children near the oven when in ...

  • CDA SK300 - page 5

    5 • Do not attempt to repair the internal workings of your oven. • Do not cover the oven floor with aluminium foil. First Use of the Oven First use • The decorative metal finish of this appliance has been coated with a preservative to protect it during transport and storage. This should be removed during installation by using a non-abrasive ...

  • CDA SK300 - page 6

    6 Please note: • This oven has been fitted with a cooling fan to achieve maximum eciency and to maintain low surface temperatures. The cooling fan will switch on automatically when the oven switches on. It is normal for the cooling fan to run for an hour or more after use, depending on the duration, temperature and type of cooking programme u ...

  • CDA SK300 - page 7

    7 Internal shelf positions The shelves and grill pan can be inserted into any one of six dierent positions. T o refer to these they are numbered from “1” to “6” , with “1” nearest the grill elements at the top of the oven. Printing on the inside of the oven door is designed to remind you of this numbering (Fig. 1). SK200 Defrost (She ...

  • CDA SK300 - page 8

    8 Fan ned Gril l (Grill pan position 1, 2 or 3) This function uses the fan to circulate the heat from the grill element around the food. The temperature can be set between 50 ° C and 250 ° C. Full Grill (Grill pan position 1, 2 or 3) This function radiates the heat from the grill element. This fully temperature variable grill is ideal for grillin ...

  • CDA SK300 - page 9

    9 SK300 Defrost (Shelf position 3, 4 or 5) Using the fan only this oven function circulates the air around the oven cavity , speeding up the natural defrost process (1kg takes appro ximately one hour , depending on the type of food). Fan Oven (Shelf position 4 or 5) Using the circular element and the fan with a temperature between 50°C and 250°C, ...

  • CDA SK300 - page 10

    10 W armi ng O ven (Shelf position 5 or 6) Using heat produced only by the bottom element, this natural heat is perfect for dough proving and blind- baking. Fan Ass iste d O ven (Shelf position 3, 4 or 5) Using the circular element and the fan with a temperature between 50 ° C and 225 ° C, this cooking function blows the air into and around the o ...

  • CDA SK300 - page 11

    11 Fig. 2 1 2 3 4 5 6 7 1 Cooking time indicator 2 End of cooking time indicator 3 Minute minder indicator 4 Current time indicator 5 Decrease key 6 Mode key 7 Increase key Programming the Oven Please note: • The alert beep will cut o after two minutes if it is not switched o manually . Setting the clock The clock is preset to 12:00 , and w ...

  • CDA SK300 - page 12

    12 T o set the minute minder: • T ouch repeatedly until the minute minder indicator flashes. • Then touch or to select the required duration for the minute minder . When the correct duration shows on the display , either touch or wait for appro ximately five seconds. The minute minder indicator will remain lit to confirm the minute minder is ...

  • CDA SK300 - page 13

    13 Semi-automatic cooking The oven can be set to switch o automatically at a preset time up to a maximum of 10 hours. T o set a semi-automatic cooking programme: • Select the oven function and temperature (the oven will switch on). • T ouch until the cooking time indicator flashes. • Then touch or to select the required duration for the s ...

  • CDA SK300 - page 14

    14 seconds. The cooking time and end of cooking time indicators will remain lit to confirm the automatic programme is on. • The oven will switch o until the automatic programme starts. When the programme starts, the cooking time indicator will switch o • When the cooking time is complete, there will be an alert beep which will continue f ...

  • CDA SK300 - page 15

    15 Care and Maintenance IMPORT ANT • Before any maintenance is started involving electrical parts, the appliance must be disconnected from the power supply . • If the oven has been in use, let the oven cavity and the heating elements cool down before attempting any maintenance. • Steam cleaners must not be used when cleaning this appliance. ? ...

  • CDA SK300 - page 16

    16 Suitable proprietary chemical cleaners may be used after first consulting with the manufacturer’ s recommendations and testing a sample on a small area of the oven cavity . Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface. Oven door glass As the oven door is double glazed, the inner glass may be remove ...

  • CDA SK300 - page 17

    17 Oven Door R emoving the Oven Door The oven door can easily be removed as follows: • Open the door to the full extent (Fig. 4). • Open the lever A completely on the left and right hinges (Fig. 5). • Hold the door as shown (Fig. 8). • Gently close the door (Fig. 6) until left and right hinge levers A are hooked to part B of the door (Fig. ...

  • CDA SK300 - page 18

    18 Changing the bulb - Lateral lights (Figs 9 & 10) • Remove all shelves and the grill pan from the oven. • Gently unclip the side rack from its lower locating stud and unhook its top to remove it. Note: No tools are required and the stud should not be removed. • Carefully detach the glass cover from the lamp holder , by sliding it upward ...

  • CDA SK300 - page 19

    19 Changing the bulb - Back light (Fig. 11) Unscrew the protective cover . W e recommend that you wash and dry the glass cover at this point. Carefully remove the old bulb and insert the new bulb suitable for high temperatures (300ºC) having the following specifications: 230-240V , 50Hz, 25W , G9 fitting. R efit the protective cover . IMPORT AN ...

  • CDA SK300 - page 20

    20 Installation Important If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not installed as it could restrict ventilation. Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built-under oven housing unit it may be nece ...

  • CDA SK300 - page 21

    21 40 560 600 600 560 564 595 595 547 554 20 Fig. 12 Dimensions Oven Housing Height (mm) 595 600 Width (mm) 595 560 Depth (mm) 567 560 (min) housing should not be free standing but be secured to the wall and/or adjacent fittings. How to install your oven Y ou will need the following housing area to fit your oven correctly . The oven is designed t ...

  • CDA SK300 - page 22

    22 Electricity Supply to Y our Oven W arning! this appliance must be earthed. This appliance must be connected by a competent person, using fix ed wiring via a double pole switched fused spur outlet, protected by a 13A fuse. W e recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will ...

  • CDA SK300 - page 23

    23 E & O E. All instructions, dimensions and illustrations are provided for guidance only . CDA reserve the right to change specifications without prior notice. Attribute Symbol Units Model  Identification SK200 SK300 Mass  of  the  appliance M 34.0 34.0 kg Number  of  cavities 1 1 Heat  source  per  cavity  (elec ...

  • CDA SK300 - page 24

    Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .care@cda.eu W : www. cda.eu ...

Produzent CDA Kategorie Oven

Dokumente, die wir vom Produzenten des Geräts CDA SK300 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen CDA
- Bedienungsanleitungen SK300
- Produktkarten CDA
- Informationsbroschüren
- oder Energieetiketten CDA SK300
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung CDA SK300.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen CDA SK300, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen CDA SK300. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts CDA SK300 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts CDA SK300, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von CDA SK300 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von CDA SK300 verständlich ist.

Eine gänzliche Bedienungsanleitung von CDA sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von CDA SK300 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von CDA SK300 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich CDA SK300, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts CDA SK300 - die uns die ersten Schritte während der Nutzung von CDA SK300 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit CDA SK300 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von CDA SK300 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich CDA SK300?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit CDA SK300 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit CDA SK300 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)