Bedienungsanleitung Jensen BT250

18 Seiten 0.27 mb
Download

Zur Seite of 18

Summary
  • Jensen BT250 - page 1

    JENSEN BT250 B B l l u u e e t t o o o o t t h h C C a a r r K K i i t t U U s s e e r r ’ ’ s s M M a a n n u u a a l l Installation and User Manual ...

  • Jensen BT250 - page 2

    ...

  • Jensen BT250 - page 3

    i Preface This publication, includin g all photogra phs, illustrations and soft ware, is protected under international copyright la ws, with all rights reserved. Neither this manual, nor any of the material contained herei n, ma y be reproduced without the express written consent of the manufacturer. Version 2.0, March 2009 Trademarks Other product ...

  • Jensen BT250 - page 4

    Bluetooth Car Kit User Manual ii Preface .................................................................................................................... i Installation .............................................................................................................. 1 Identify ing co mponents ....................................... ...

  • Jensen BT250 - page 5

    B B l l u u e e t t o o o o t t h h W W i i r r e e l l e e s s s s C C a a r r K K i i t t Installation This section demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle. Identifying components Unpack the Car Kit package and ensure the following items are included. Wired Remote Part # 31092000 Microphone Part # 3109 ...

  • Jensen BT250 - page 6

    Bluetooth Car Kit User Manual 2 Installing the junction box This Car Kit is designed to work with a 12/24-volt vehicle po wer supply. Refer to the following to install the junction box in a vehicle. 1. Locate a suitable place inside the car to mount the jun ction box. Select a dry place that avoids excessive heat and mechanical vibration. Ideally, ...

  • Jensen BT250 - page 7

    Connecting the power supply The following illustration demonstrates how to conne ct the Car Kit’s power cable to the vehicl e’s electrical system. Power Cable Important! The Blue cable must be connected to the 12/24-volt switched ignition to enable the Car Kit to go into standby mode. Do not connect the Blue cable to the +12/24-volt constant co ...

  • Jensen BT250 - page 8

    Bluetooth Car Kit User Manual Connecting Components The following illustration shows wher e to connect the devices. Do not connect the components until you h ave followed the next steps and have finalized your installation. Ò CONNECT THE POWER HARNESS LAST. Junction b ox Speaker Microphone Remot e Contro l Remote Control The control module sho uld ...

  • Jensen BT250 - page 9

    Installing the Components Before installing the components, take n ote of the followin g: • Make sure that the cables can rea ch from the each component to the Junction Box. If the cable is too short, relocate the component. Do not lengthen the cable. • The supplied microphone is uni-directional. For be st results, place the microphone in front ...

  • Jensen BT250 - page 10

    Bluetooth Car Kit User Manual 6 G G e e t t t t i i n n g g S S t t a a r r t t e e d d Introduction The Bluetooth Wireless Car Kit is desig ned to help make your driving experience more convenient, safe, and provide you with years of trouble free use. Product overview and features The Car Kit is designed to make driving your car a nd talking on th ...

  • Jensen BT250 - page 11

    Using the remote control The Car Kit is operated using the remote control: Control Module Functions Volume up / down Press during operation to increase or l ower the volume. Answer / redial Press to answer a call. Call waiting: Press to answer a second call. Press again to return to the first call. Press & hold for 3 seconds to redial the last ...

  • Jensen BT250 - page 12

    Bluetooth Car Kit User Manual 8 Disconnect / voice recognition Press to disconnect a call. Press and hold for two seconds to activate the Voice Recognition function. After the tone, repeat your pre-recorded voice tag: t he num ber automatically di als . Press to reject an incoming call. *Phone MUST Support voice recognition. LED indicator Lights af ...

  • Jensen BT250 - page 13

    Turning off the BT250 & the Blue LED light When the BT250 is not co nnected to any phone the Blue LED ligh t will continue to flash. You can turn the unit off by pressing & holding the End button for 3 seconds (Pleas e note that the button backlight will still be on all the time) until you see the Blue LED light shut off. To reactivate the ...

  • Jensen BT250 - page 14

    Bluetooth Car Kit User Manual 10 Resetting the Car Kit The car kit may only conn ect to one phone at a time . However, it may be paired with up to 4 phones. Resetting the car kit deletes all pairings. To do so: Press and hold the Answer/redial and Volume down at the same time. You will hear a tone (pairing mode), continue holding the buttons until ...

  • Jensen BT250 - page 15

    the way you say the voice tag, but also record a familiar backgroun d noise. Since phones are in continual co ntac t with the Car Kit, it is possibl e to use the included Car Kit’s microphone to reco rd the voice tag. Locate the feature on your mobile phon e, and when prompted for the voice tag, speak clearly from a comfortable in the driver’s ...

  • Jensen BT250 - page 16

    Bluetooth Car Kit User Manual 12 Troubleshooting My mobile phone can’t make a connectio n. • Make sure the bluetooth function on your phone is enabled. • Make sure the car ignition i s on. If on and no power ch eck the fuses and wiring. • Re set the Car Kit and try again. • Turn your phone off and on again, and try the proceedure for conn ...

  • Jensen BT250 - page 17

    Warranty Information 12 MONTH LIMITED WARRANTY Applies to Je nsen Series Mobile Electronics. AUDIOVOX Electronics Corporation (the Company) warrants to the o riginal retail purchas er of this product that should this produ ct or any part thereof, (oth er than transmitters) under normal use and conditi ons, be proven defective in material or wo rkma ...

  • Jensen BT250 - page 18

    Bluetooth Car Kit User Manual © 2009 Audiovox Electronics Corp., 150 Marcu s Blvd., Hauppauge, N.Y. 11788 14 ...

Produzent Jensen Kategorie Automobile Accessories

Dokumente, die wir vom Produzenten des Geräts Jensen BT250 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Jensen
- Bedienungsanleitungen BT250
- Produktkarten Jensen
- Informationsbroschüren
- oder Energieetiketten Jensen BT250
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Jensen BT250.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Jensen BT250, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Jensen BT250. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Jensen BT250 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Jensen BT250, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Jensen BT250 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Jensen BT250 verständlich ist.

Eine gänzliche Bedienungsanleitung von Jensen sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Jensen BT250 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Jensen BT250 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Jensen BT250, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Jensen BT250 - die uns die ersten Schritte während der Nutzung von Jensen BT250 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Jensen BT250 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Jensen BT250 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Jensen BT250?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Jensen BT250 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Jensen BT250 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (1)

Manni Renzo

vorrei sapere come avere le istruzioni del DMR-eh50 in italiano anche in pdf grazie