Bedienungsanleitung Apollo 1500

17 Seiten 2.01 mb
Download

Zur Seite of 17

Summary
  • Apollo 1500 - page 1

    APOLLO Gate Operators, Inc. Model 1500 / 1600 Swing Gate Operator INS TALLATION MANUAL 051104 ...

  • Apollo 1500 - page 2

    2 CONTENTS Safety Precautions ................................................... 3 Applications ............................... ............................... 4 Pre - Ins tallation Checklist ........................................ 5 Par ts Identification . .................................................. 6 Operator Ins tallation .............. ...

  • Apollo 1500 - page 3

    3 WARNING - To reduce the risk of injury or death: • READ AND FOLLOW ALL INSTRUCTIONS. • Installation should be performed by a professional installer. • Required welding should be performed by a qualified welder. • Should electricity be required, use a certified electrician only. • Any device that requires 120 Volts AC should be U.L. appr ...

  • Apollo 1500 - page 4

    4 APPLIC ATIONS The Apollo Model 1500/1600 Swing Gate Operator is designed to handle swing gates up to 14 feet in length and 400 pounds each. A professional fence or gate dealer is recommended to assure proper installation. Apollo Gate Operators are available only through qualified dealers with an outstanding reputation in the fence and gate indust ...

  • Apollo 1500 - page 5

    5 PRE - INS TALLATION CHECKLIST The following checklist should be used before beginning installation: Verify that the proper operator has been selected for this application. Verify proper installation and operation of the gate. 1. Are the hinges servicable? 2. Does the gate swing free and level? 3. Will the gate require a locking device? 4. Is the ...

  • Apollo 1500 - page 6

    6 PARTS IDENTIFIC ATION CAUTION Signs (2 each) (4 each with 1600) Gate Bracket (2 with 1600) Hardware Kit (2 with 1600) Automatic Battery Charger (optional) 5 Watt Solar Panel & Bracket (optional) (2 required with 1600) Actuator with 8’ cable (slave actuator with 38’ cable supplied with 1600) Control Box Pivot Arm (2 with 1600) Bolt On Pivo ...

  • Apollo 1500 - page 7

    7 OPER ATOR INSTALL ATION Location of Pivot Point. 1/2” Center Line of attachment point for gate bracket Hinge post Vertical position of pivot arm Measurements are taken from the center of the hinge. STEP 1 PIVOT ARM INSTALLATION (standard pull to open) Front View Pivot ArmMust be level Notes: PULL TO OPEN pulls gate open ( actuator is extended w ...

  • Apollo 1500 - page 8

    8 STEP 3 Control Box Installation Mount the control box within 4 feet of the pivot arm. Use mounting hardware capable of supporting the weight of the control box with the battery installed. Mounting holes are not provided since mounting surfaces will vary. STEP 4 Connecting the Actuator (s) Set battery inside of control box with terminals toward th ...

  • Apollo 1500 - page 9

    9 STEP 6 Limit Switch Adjustment To Retract More Turn Retract Limit Screw Clockwise To Retract Less Turn Retract Limit Screw Counter - Clockwise To Extend More Turn Extend Limit Screw Counter - Clockwise To Extend Less Turn Extend Limit Screw Clockwise Remove limit switch end caps Cycle the operator and adjust limits as required. If the operator op ...

  • Apollo 1500 - page 10

    10 635/636 CONTROL BOARD CONNECTIONS Emergency Bypass Connector Used when the control board is not functioning. Unplug the motor harness from the Master (or Slave) Connector and momentarily insert into the Emergency Bypass Connector to open the gate. In the event the motor is not disconnected quickly enough, the blue 15 amp fuse will protect the ci ...

  • Apollo 1500 - page 11

    11 635 /63 6 CONTROL BOARD ADJUSTMENTS PROGRAM SWITCHES Factory Description Setting #1 ON TIMER TO CLOSE - Automatically closes gate ON - Close timer enabled OFF - Close timer disabled #2 OFF CURRENT SENSITIVITY OPTION - Delays current sensing from start ON - 4 second delay OFF - 2 second delay #3 ON TIMER TO CLOSE OPTION ON - timer to close works ...

  • Apollo 1500 - page 12

    12 PUSH TO OPEN INS TALLATION Both measurements are taken from the center of the hinge. 11” 6” Direction of opening Gate (closed) Hinge post Top View Vertical position of pivot arm (s) Pivot arm must be level 1/2” Hinge post Center Line of attachment point for gate bracket Front View PIVOT ARM (s) INSTALLATION STEP 1 Location of pivot point R ...

  • Apollo 1500 - page 13

    13 APOLLO Gate Operators RECEIVER OPTIONS Do not confuse the receiver code switches with the red program switches on the gate control board. Never set all code switches to the same position. Transmitters must match code switches for proper operation. If power is taken directly from battery or connected as shown below, receiver should be configured ...

  • Apollo 1500 - page 14

    14 TROUBLESHOOTING OPER ATOR & ACCESSORIES SYMPTOM Some troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may be purchased at Radio Shack or a local electric supply company. Refer to the owners manual for instructions. Gate opens OK but after closing, opens back up. 1. Excessive closing pressure on gate. Re ...

  • Apollo 1500 - page 15

    15 SYMPTOM Gate will open using push button on side of box, but not with transmitter. 1. Code switches do not match. Check that the code switches in the transmitter and the receiver match. 2. Low or dead battery in transmitter. Replace battery. 3. Fuse blown on circuit board. Check fuses on gate control board. 4. Low battery in operator. Battery vo ...

  • Apollo 1500 - page 16

    16 SYMPTOM Gate will not open or close. Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and never drop below 11 volts when gate is operating. Reset program switches to factory setting. # 1,# 3,# 7,# 8 ON, all others OFF . Disconnect all accessories from the circuit board - receivers, push ...

  • Apollo 1500 - page 17

    17 LIMITED TWO - YE AR WARRANTY Apollo Gate Operators are warranted against defects for a period of 24 months from the date of purchase, providing recommended installation procedures are followed. This warranty is in lieu of all other warranties expressed or implied (some states do not allow limitations on how long an implied warranty lasts, so thi ...

Produzent Apollo Kategorie Safety Gate

Dokumente, die wir vom Produzenten des Geräts Apollo 1500 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Apollo
- Bedienungsanleitungen 1500
- Produktkarten Apollo
- Informationsbroschüren
- oder Energieetiketten Apollo 1500
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Apollo 1500.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Apollo 1500, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Apollo 1500. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Apollo 1500 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Apollo 1500, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Apollo 1500 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Apollo 1500 verständlich ist.

Eine gänzliche Bedienungsanleitung von Apollo sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Apollo 1500 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Apollo 1500 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Apollo 1500, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Apollo 1500 - die uns die ersten Schritte während der Nutzung von Apollo 1500 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Apollo 1500 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Apollo 1500 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Apollo 1500?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Apollo 1500 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Apollo 1500 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)