-
Lenoxx CD-102 - page 1
® COMP ACT DISC PLA YER AM/FM STEREO CASSETTE RECORDER MODEL CD-102 OPERA TING INSTRUCTIONS PLEASE READ CAREFULL Y BEFORE USE PLA YS ALL MUSIC COMP ACT DISCS FULL Y PROGRAMMABLE CD PLA YER WITH REPEA T RECEIVES AM/FM STEREO BROADCASTS RECORDS FROM CD, RADIO, OR BUIL T -IN MICROPHONE FM STEREO AND POWER LED INDICA T ORS 2 W ...
-
Lenoxx CD-102 - page 2
SAFETY INSTRUCTIONS The lightning flash and arrow head within the triangle is a warning sign alerting you of dangerous voltage inside the product. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE P A RTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PER ...
-
Lenoxx CD-102 - page 3
EXAMPLE OF ANTENNA GROUNDING AS PER NEC - NA TIONAL ELECTRICAL CODE It is the intent of Lenoxx that this product be used in full compliance with the copyright laws of the United States and that prior permission be obtained from copyright owners whenever recording songs from the RADIO or CDs. Do not apply oil or petroleum products or solvents to ...
-
Lenoxx CD-102 - page 4
1 . Use only the type and size of batteries mentioned in the operating instructions booklet (batteries are not included with this set, please buy the proper batteries). 2 . Do not dispose the batteries into a fire. The cells may explode. Check with local codes for possible special disposal instructions. 3 . Do not open or mutilate the batteries. Re ...
-
Lenoxx CD-102 - page 5
CHOOSING THE POWER SOURCES Y ou can use the AC power or batteries as a power source. TIP If the plug of the AC power cord does not match your outlet, do not force it. Reverse it and try again. The plugs are polarized and only fits one way into the wall outlet and back of the set. TIP Replace the batteries when the POWER lamp dims or when the player ...
-
Lenoxx CD-102 - page 6
1 Slide the FUNCTION switch to CD position (power on), the POWER lamp will be on. 3 Close the CD DOOR by pushing it down. The display will show the total tracks on that CD. 4 12 3 Lift the right corner of the CD DOOR to open it and place the CD in the CD compartment. The label side of the CD should face upward. 2 Press the CD PLA Y button. The PLA ...
-
Lenoxx CD-102 - page 7
USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS T o Press or Adjust Adjust the volume VOLUME control Stop playback Pause playback The PLA Y/P AUSE lamp will flash during pause. Press again to resume play after pause. Go to the next track Go back to the previous track Locate a point in a song or Press and hold down while playing until you find the poin ...
-
Lenoxx CD-102 - page 8
LISTENING TO THE RADIO Connect the supplied AC power cord or batteries (see page 4). Slide the FUNCTION switch to RADIO position, the POWER lamp will be on. 1 2 3 1 2 3 Slide the BAND switch to the proper band position (AM, FM, or FM STEREO) that you want. Tune into the station you prefer using the TUNING control (at the right side of the set). Adj ...
-
Lenoxx CD-102 - page 9
USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Slide or Adjust Adjust the volume VOLUME control (at the left side of the set) TIP • If the FM broadcast is noisy , slide the BAND switch from FM Stereo to FM position (MONO). Turn off the Radio Slide the FUNCTION switch to T APE position T o improve broadcast reception Change position of the antenn ...
-
Lenoxx CD-102 - page 10
PLA YI N G A T A P E Connect the supplied AC power cord or batteries (see page 4). Press the STOP/EJECT button to open the tape compartment and insert a recorded tape. Close the door . 3 2 2 3 Press the PLA Y button. The player turns on and starts playing. PLA Y Slide the FUNCTION switch to T APE position. 1 4 When the set finishes playing this sid ...
-
Lenoxx CD-102 - page 11
USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Stop playback Eject the cassette Press or Adjust Adjust the volume VOLUME control (at the left side of the set) Fast forward or rewind the tape F AST FORW ARD button or REWIND button Pause playback P AUSE button Press again to resume play after pause. STOP/EJECT button STOP/EJECT button VOLUME CONTROL ...
-
Lenoxx CD-102 - page 12
RECORDING ON A T APE Connect the supplied AC power cord or batteries (see page 4). Press the STOP/EJECT button to open the tape compartment and insert a blank tape. Select the program source (AM, FM, CD, or , built-in microphone) you want to record. 1 3 1 2 STOP/EJECT T o record from the CD player, insert a CD and follow the steps to play a CD (see ...
-
Lenoxx CD-102 - page 13
USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Turn off the power Press the STOP/EJECT button and slide the FUNCTION switch to T AP E position. TIP Press or Adjust Stop recording STOP/EJECT button P AUSE button Press the button again to resume recording. Pause recording • For best recording effect, use the AC power instead of batteries. • T o ...
-
Lenoxx CD-102 - page 14
PLA YING CD TRACKS REPEA TEDL Y (REPEA T PLA Y ) 1. Slide the FUNCTION switch to CD position. 2. Select the track by pressing or , and then press . 3. Press the CD REPEA T button. T o repeat Press a single track (song) Press the REPEA T button once all the tracks (all songs) Y ou can play CD tracks over and over in normal or program play modes (see ...
-
Lenoxx CD-102 - page 15
Y ou can make a program of up to 16 tracks in the order you want them to be played. 1. Slide the FUNCTION switch to CD position. 2. Press the PROGRAM button. The letters Pr and the PROGRAM lamp will flash. 3. Press or to select the tracks you want to program in the order you want. 4 . Press the PROGRAM button to confirm. The letters Pr ...
-
Lenoxx CD-102 - page 16
PRECAUTIONS On Safety As the laser beam used in the CD player section may be harmful to the eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only . Should any solid object or liquid fall into the player , unplug the player , and have it checked by qualified personnel before operating it any further . O ...
-
Lenoxx CD-102 - page 17
PRECAUTIONS (continued) Notes on CDs Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Do not use solvents such as benzene, thinner , commercially available cleaners or anti-static spray intended for vinyl LPs. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it ...
-
Lenoxx CD-102 - page 18
MAINTENANCE Cleaning the Lens If the lens becomes dirty , it may cause a skipping of sound during CD operation. Clean with a commercially available lens cleaner and blower . Cleaning the T ape Heads Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operati ...
-
Lenoxx CD-102 - page 19
TROUBLE SHOOTING Problem Remedy The power is not on. Connect the AC power cord to a wall outlet securely . Make sure the batteries are inserted correctly and they are fresh. There is no sound. Make sure the FUNCTION switch is at the right position as you want. Adjust the volume. Unplug the headphones when listening through speak ...
-
Lenoxx CD-102 - page 20
SPECIFICA TION General Description Power source: AC 120V , 60Hz 12W atts DC 12V (6 size C batteries) (Alkaline batteries are recommended) Speakers: 2 - 3 1 / 2 8 ohm Output power: 1.5W/channel Dimensions: Width: 14 1 / 2 Depth: 8 Height: 6 3 / 4 Weight: 5LBs (without batteries) CD Section Plays disc type: Any normal CD used in ...
Haben Sie eine Frage bezüglich Lenoxx CD-102?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Lenoxx CD-102 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Lenoxx CD-102 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.