-
Honeywell F52F - page 1
69-0419—2 Copyright © 1998 Honeywell Inc. All Rights Reserved F52F ELECTRONIC AIR CLEANER OWNER’S GUIDE 69-0419-2 ...
-
Honeywell F52F - page 2
69-0419—2 ...
-
Honeywell F52F - page 3
69-0419—2 CONTENTS PA G E THE SOLID ST A TE PERFORMANCE INDICA T OR 2 OPERA TING Y OUR ELECTR ONIC AIR CLEANER 3 GETTING THE MOST FROM Y OUR AIR CLEANER 5 CLEANING THE CELL(S) AND PREFIL TER 6 HOW ELECTR ONIC AIR CLEANING WORKS 15 BEFORE Y OU CALL FOR SER VICE 20 HONEYWELL 10 YEAR CLEAN COIL GUARANTEE 22 PERFECT CLIMA TE® 24 LIMITED TWO-YEAR W A ...
-
Honeywell F52F - page 4
69-0419—2 THE SOLID ST A TE PERFORMANCE INDICA TOR This air cleaner is equipped with a special solid state circuit that operates the optional W8600E Solid State Performance Indicator (see photo). The W8600E Indicator is designed to be mounted next to your thermostat, and to monitor the air cleaner performance. If you have ordered the W8600E Indic ...
-
Honeywell F52F - page 5
69-0419—2 OPERA TING Y OUR ELECTRONIC AIR CLEANER Set the ON-OFF switch to ON. The air cleaner will now operate whene ver your furnace/air conditioning system fan oper ates. F or maximum air cleaning benefit and cleaner air conditioner coils, lea ve the air cleaner switch on at all times and the f an switch on y our ther mostat on. Of course, con ...
-
Honeywell F52F - page 6
69-0419—2 ONE-CELL MODEL SHOWN. If you do not w ant the air cleaner to run, set the ON-OFF switch to OFF to turn off the air cleaner. Y our fur nace and air conditioner will still operate normally , b ut without the added benefit of air cleaning. Normally , this s witch should be ON at all times. When the f an stops, the neon light goes out, as d ...
-
Honeywell F52F - page 7
69-0419—2 GETTING THE MOST FROM Y OUR AIR CLEANER For g reatest efficiency , the air cleaner should run all the time. T o do this, set the f an switch on your thermostat to ON, and make sure the air cleaner is switched on. The f an and air cleaner will run ev en when the fur nace or air conditioner is off. Note: A man ual fan s witch may be b uil ...
-
Honeywell F52F - page 8
69-0419—2 CLEANING THE CELL(S) AND PREFIL TER T o ensure optim um perf ormance from the air cleaner , the cell(s) and prefilter m ust be cleaned regular ly—e v er y one to six months. W ashing frequency will vary depending on the number of f amily members, pets, activities (such as cooking, woodw or king, etc.) and smoking habits. Use the w ash ...
-
Honeywell F52F - page 9
69-0419—2 Removing the electronic cell(s) and prefilter TURN LATCH M7814 F52 ACCESS DOOR STEP 1 Open the door by turning the two door latches. A B SPRING CLIP PREFILTER SCREEN M7812 STEP 2 The prefilter is held in place by a spring clip and a U-shaped channel. Lift the prefilter at the spring clip end and slide it out of the U-shaped channel. 7 ...
-
Honeywell F52F - page 10
69-0419—2 STEP 3 The electronic cell(s) are held in the air cleaner by a latch at the top , and metal hooks on the bottom. Push the cell inward to release the latch and rotate the latch aw ay from the cell. See photo . STEP 4 Lift the cell and tip it slightly to release it from the cell hooks. The prefilter can be vacuumed, brushed, spra yed with ...
-
Honeywell F52F - page 11
69-0419—2 IMPORT ANT • Check y our dishwasher owner's manual. Some manuf acturers do not recommend washing electronic cell(s) in their dishwashers . • If the dishwasher has upper and low er ar ms, position the cell(s) carefully to allow good water circulation. • Use care to av oid damaging the cell(s) when placing them in the dishwashe ...
-
Honeywell F52F - page 12
69-0419—2 CA UTION Hazardous c hemical. Can cause personal injury . • Do not splash the detergent solution in ey es. W ear r ubber glo ves to a void prolonged de- tergent contact with skin. • K eep detergent and solution out of reach of children. NO TE: Alw ays w ash the cell(s) first, then the prefilter to keep hea vy lint from getting caugh ...
-
Honeywell F52F - page 13
69-0419—2 STEP 5 Rinse the cell(s) and prefilter with a hard spra y of very hot water; rinse the tub clean, then fill the tub with clean hot water and soak f or 5 to 15 minutes. Rinse until the w ater draining from the cell(s) and prefilter no longer feels slippery . STEP 6 Wipe the ionizer wires and contact board on the end of the cell with a cl ...
-
Honeywell F52F - page 14
69-0419—2 STEP 2 It is v er y impor tant that the electronic cell(s) be properly replaced: a. Electrical contact board must face the po wer supply contacts. b . Airflow arro ws on the cell(s) must point into the air duct. c. Hook the cell(s) on the metal hooks and rotate into the air cleaner . d. Rotate the cell latch to secure the cell(s). CELL ...
-
Honeywell F52F - page 15
69-0419—2 STEP 3 Slide the prefilter into the U-shaped channel and push the other end past the spring clip. B SPRING CLIP M7813 A PREFILTER SCREEN INSERT TOP OF SCREEN INTO U-SHAPED CHANNEL 13 ...
-
Honeywell F52F - page 16
69-0419—2 STEP 4 Close the door and f asten it with the two door latches. TURN LATCH M7814 F52 ACCESS DOOR STEP 5 T urn on system fan. If the cell(s) and prefilter are wet, the neon light ma y not come on and you ma y hear arcing. If the arcing is annoying, simply turn off the air cleaner for 2 to 3 hours or until the cell(s) are dry . If your ai ...
-
Honeywell F52F - page 17
69-0419—2 HO W ELECTRONIC AIR CLEANING WORKS The par ticles remov ed by the electronic air cleaner tend to be very small—less than ten microns. But what is a 10 micron particle? The ey e of an aver age sized sewing needle has a diameter of about 750 microns, and the dot in the “i” in the w ord micron is about 400 microns. Generally , par ti ...
-
Honeywell F52F - page 18
69-0419—2 First, large par ticles (lint, hair) are caught b y the prefilter . Then, as the dir ty air passes through the intense high voltage electric field surrounding the ionizer wires , all par ticles, e ven the smallest par ticles do wn to 0.5 microns, are given an electric charge. The air then passes into the collector where the alternate pa ...
-
Honeywell F52F - page 19
69-0419—2 The air cleaner vs. the standard furnace filter The regular fur nace filter collects mainly large , visible particles that reach the filter. Its main pur pose is to protect the furnace and air conditioner blo wer . The electronic air cleaner collects these large par ticles, plus man y of the smaller , mostly invisib le par ticles. Its p ...
-
Honeywell F52F - page 20
69-0419—2 Air ionizers ha ve been marketed with claims about purifying the air and promising medical benefits. It should be noted that supporting tests, if a vailable , are controversial and incomplete. Air ionizers can generate a bit of oz one, and can generate some ions (bits of material carrying some electr icity). This is what y our electroni ...
-
Honeywell F52F - page 21
69-0419—2 If desired, the ozone generated b y the air cleaner can be reduced by asking y our dealer to adjust the air cleaner power supply to reduce ozone production. This adjustment will reduce ozone production about 20 to 25 percent, but will also reduce air cleaning efficiency about 7 to 10 percent. White dust is made up of par ticles that set ...
-
Honeywell F52F - page 22
69-0419—2 If your air cleaner is equipped with the optional W8600E Solid State P erformance Indicator , the W ASH and CHECK LEDs on the W8600E will remind you that cell and prefilter w ashing is past due and tell you when the system is not operating properly . Whether or not your air cleaner has a Solid State P erformance Indicator , perform thes ...
-
Honeywell F52F - page 23
69-0419—2 1. Make sure the furnace or air conditioner blo wer is r unning. 2. On models without the Solid State P erformance Indicator , if the electronic cells are wet, check again in 2 to 3 hours . 3. Make sure the appropriate fuse or circuit breaker is ok. 1. Cell and prefilter washing is past due; wash as soon as possible . 2. Make sure cell( ...
-
Honeywell F52F - page 24
69-0419—2 Honeyw ell guarantees your indoor heating/ cooling coil will maintain optimum efficiency and energy savings f or a minimum of ten years if your ne w Honeywell Electronic Air Cleaner is installed and properly maintained a on either: •A new heat pump , air conditioner , or high efficiency furnace, or • A heat pump , air conditioner , ...
-
Honeywell F52F - page 25
69-0419—2 ...on new equipment or equipment less than one year old ...in newly constructed homes ...on existing equipment more than one year old For Hone ywell Electronic Air Cleaners installed on a heat pump , air conditioner or high efficiency fur nace that is either ne w or less than one year old , send copies of in voices verifying: • Purcha ...
-
Honeywell F52F - page 26
69-0419—2 24 Sa ve Even More Ener gy With These Honeywell Accessories A Honeyw ell Chronother m® Programmab le Thermostat can sav e you 9 to 30 percent in heating and cooling costs—not just the first year , b ut e ver y y ear! ■ Can be programmed to automatically r aise and lower home temperatures. ■ Makes energy sa vings convenient. ■ O ...
-
Honeywell F52F - page 27
69-0419—2 LIMITED TWO-YEAR W ARRANTY Honeywell w arrants this product to be free from defects in the workmanship or materials, under nor mal use and service, f or a per iod of two (2) years from the date of purchase b y the consumer . If, at an y time during the warranty period, the product is defectiv e or malfunctions, Honeywell shall repair or ...
-
Honeywell F52F - page 28
69-0419—2 69-0419—2 L.C. Rev . 2-98 www .honeywell.com Home and Building Control Honeywell Inc. Honeywell Plaza P.O. Box 524 Minneapolis, MN 55408-0524 Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. ...
Haben Sie eine Frage bezüglich Honeywell F52F?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Honeywell F52F nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Honeywell F52F hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.