Bedienungsanleitung GE DEH-40417

18 Seiten 0.49 mb
Download

Zur Seite of 18

Summary
  • GE DEH-40417 - page 1

    g ASTAT ® -IBP Plus Solid State Starters DEH-40417 Service Instructions ...

  • GE DEH-40417 - page 2

    ...

  • GE DEH-40417 - page 3

    i DEH-40417 WARNINGS, CAUTIONS, AND NOTES AS USED IN THIS PUBLICATION WARNINGS Warning notices are used in this publication to emphasize that hazardous voltages, currents, or other conditions that could cause personal injury are present in this equipment or may be associated with its use. Warning notices are also used for situations in which inatte ...

  • GE DEH-40417 - page 4

    ASTAT ® -IBP Plus Service Instructions ii Prices and data subject to change without notice. Table of Contents Cover Removal and Replacement ............................................................................................ 1 Logic Board Replacement .......................................................................................... ...

  • GE DEH-40417 - page 5

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 1 WARNING: Power must be removed from the ASTAT- IBP before any servicing operation. AVERTISSEMENT: Le courant doit être enlevé du ASTAT-IBP avant de procéder à toute opération de service. Cover Removal and Replacement 1. Remove the two 12-point terminal ...

  • GE DEH-40417 - page 6

    ASTAT ® -IBP Plus Service Instructions 2 Prices and data subject to change without notice. Logic Board Replacement CAUTION: Always handle circuit boards by their edges and do not distort the parts on the circuit boards. ATTENTION: Il faut toujours manipuler les plaques de circuits par leurs côtés et ne pas déformer les pièces sur les plaques d ...

  • GE DEH-40417 - page 7

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 3 Power Supply Board Replacement The Power Supply Board is located as shown in Figure 5. It contains gray and orange transformers visible from the sides. 1. Remove the following components: a. The cover, as described in steps 1–2 of Cover Removal and Replace ...

  • GE DEH-40417 - page 8

    ASTAT ® -IBP Plus Service Instructions 4 Prices and data subject to change without notice. 7. Reconnect the red and white gate wires to the four- point Terminal Boards, one on the component side and two on the solder side of the Power Supply Board, as illustrated in Figures 8, 9, and 10. 8. Secure the Power Supply B oard with the four screws remov ...

  • GE DEH-40417 - page 9

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 5 Protection Board Replacement 1. Remove the following co mponents: a. The cover, as described in steps 1–2 of Cover Removal and Replacement . b. The Logic Board, as described in steps 2–3 of Logic Board Replacement . c. The Power Supply Board, as describe ...

  • GE DEH-40417 - page 10

    ASTAT ® -IBP Plus Service Instructions 6 Prices and data subject to change without notice. SCR Module Replacement (Sizes K, L, and Y) This procedure requires the following tools and materials: • #2 Philips-head screwdriver, 3 / 16 " Allen wrench, torque wrench • Scotchbrite or equivalent abrasive • Mild solvent to clean mounting surface ...

  • GE DEH-40417 - page 11

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 7 SCR Module Replacement (Sizes M, Z, and N) This procedure requires the following tools and materials: • #2 Philips-head screwdriver, 3 / 16 " Allen wrench, torque wrench • Scotchbrite or equivalent abrasive • Mild solvent to clean mounting surface ...

  • GE DEH-40417 - page 12

    ASTAT ® -IBP Plus Service Instructions 8 Prices and data subject to change without notice. SCR Module Replacement (Sizes P, Q, and R) This procedure requires the following tools and materials: • 1 / 2 " wrench, 3 / 16 " Allen wrench, torque wrench • Scotchbrite or equivalent abrasive • Mild solvent to clean mounting surfaces • El ...

  • GE DEH-40417 - page 13

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 9 SCR Module Replacement (Size S) This procedure requires the following tools and materials: • 9 / 16 " wrench, 11 / 16 " wrench, 3 / 16 " Allen wrench, torque wrench • Scotchbrite or equivalent abrasive • Mild solvent to clean mounting su ...

  • GE DEH-40417 - page 14

    ASTAT ® -IBP Plus Service Instructions 10 Prices and data subject to change without notice. 7. Lift out the SCR Module, as shown in Figure 21. Retain all parts and hardware for reassembly with the replacement Module. 8. Remove the threaded stud from the SCR Module and attach it to the new Module. Tighten to 200 in- lb torque. 9. Clean the heat sin ...

  • GE DEH-40417 - page 15

    ASTAT ® -IBP Plus Service Instructions Prices and data subject to change without notice. 11 Troubleshooting Guide This guide is provided for troubleshooting and isolating common problems. It does not cover every possible situation. Contact the Customer Support Center at 800-843-3742 if any problem is not resolved by these procedures. Symptom or Er ...

  • GE DEH-40417 - page 16

    ASTAT ® -IBP Plus Service Instructions 12 Prices and data subject to change without notice. Renewal Parts List The following parts and assemblies are available as replacement parts for ASTAT-IBP Solid State Starters. Renewal parts as furnished may not be identical to the original parts since design changes may have been made in the interim. The pa ...

  • GE DEH-40417 - page 17

    ...

  • GE DEH-40417 - page 18

    These instructions do not cover all details or variations in equipment nor do they provide for every possible contingency that may be met in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise that are not covered sufficiently for the purchaser’s purposes, the matter s ...

Produzent GE Kategorie Power Supply

Dokumente, die wir vom Produzenten des Geräts GE DEH-40417 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen GE
- Bedienungsanleitungen DEH-40417
- Produktkarten GE
- Informationsbroschüren
- oder Energieetiketten GE DEH-40417
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung GE DEH-40417.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen GE DEH-40417, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen GE DEH-40417. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts GE DEH-40417 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts GE DEH-40417, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von GE DEH-40417 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von GE DEH-40417 verständlich ist.

Eine gänzliche Bedienungsanleitung von GE sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von GE DEH-40417 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von GE DEH-40417 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich GE DEH-40417, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts GE DEH-40417 - die uns die ersten Schritte während der Nutzung von GE DEH-40417 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit GE DEH-40417 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von GE DEH-40417 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich GE DEH-40417?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit GE DEH-40417 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit GE DEH-40417 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)