-
La Crosse Technology WS-6020U-IT - page 1
1 Battery cover Wall mount location Model WS-6020U- IT Solar Powered Wireless Temperature Station MANUAL/QUICK SETUP GUIDE Solar panels MIN/MAX key ...
-
La Crosse Technology WS-6020U-IT - page 2
2 FEATURES Receives wireless outdoor temperature Solar cell powers the in cluded 2 "AA" rechargeable alkaline ba tteries Works with regular Alkaline batteries with a flip of a switch Stores solar power for con tinuous operation High-efficiency modern solar panel maintains full charge with minimal light Outdoor/Indoor tempe ...
-
La Crosse Technology WS-6020U-IT - page 3
3 3. Next, slide the bat tery switch to the S OLAR (UP) position. WARNING Do NOT recharge the included solar -rechargeabl e batteries outside of this product because it will damage the batteries and other charging devices. Battery Compartment SWITCH UP (SOLAR OPERATION) (SOLAR- RECHARGEABLE BATTERIES) Slide switch UP once solar- rechargeable batter ...
-
La Crosse Technology WS-6020U-IT - page 4
4 4. Continue to section labeled " ACTIVATE SOLAR-POWERED OUTD OOR TRANSMITTER " 5. If the solar panel is facing a permanent strong light source (eg., on top of a refrigerator with halogen lamp) , please switch the clock to alkaline battery mode to avoid over-charging re-chargeable alkaline battery Model TX62U-IT Solar-powered Transmitter ...
-
La Crosse Technology WS-6020U-IT - page 5
5 ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER 1. Press the RESET key on the Sensor to activate the solar-po wered transmitter and link it to the T emperature station. NOTE: The solar panel need s light from a 60W light bulb or brighter during the activation proce ss. Do not cover solar panel w ith hands or other objects. TX62U-IT transmitter RE SET ...
-
La Crosse Technology WS-6020U-IT - page 6
6 It checks the brightnes s level of the surrounding environment ev ery 5 seconds. It measures / transmits ev ery 16 seconds if it detects a dark environm ent or if the battery voltage drops below 2.5V. (2) IDLE MODE: If the battery v oltage drops below 2.4V, it commences IDLE MOD E; the LCD turns off and it does not measure / transmit ...
-
La Crosse Technology WS-6020U-IT - page 7
7 60W light bulb or sim ilar condition) and press the RESET key to r eturn to NORMAL MODE (bat tery voltage is higher than 2.5V). MIN/MAX: Press and release the M IN/MAX button to v iew: Outdoor Temperature minim um and maximum. Indoor temperature minimum and maximum. Outdoor minimum Temperate and Indoor humidity. RESET MIN/MA X : Press ...
-
La Crosse Technology WS-6020U-IT - page 8
8 LOW BATTERY INDICA TOR: • RX Low battery indicator is displayed on the LCD when the receiver batte ry voltage is low . • TX Low battery indicator is displayed on the LCD when the transmitter ba ttery voltage is low . SOLAR-POWERED OUTDOOR TRANSMITTER (915MHZ RECEPTION) The Temperature Station re ceives outdoor data every 48 seconds. If it doe ...
-
La Crosse Technology WS-6020U-IT - page 9
9 Temperature Station, as the batteries may spring free from the contact s and force a false reset. Should this happen acciden tally then reset all uni ts (see “ TO INSTAL L / REPLACE BATTERY IN THE SOLAR STAT ION ” and “ INITIAL SETUP ” above) otherwise transmission problems may occur. The maximum transmis sion range is 200 feet (60.96 m) ...
-
La Crosse Technology WS-6020U-IT - page 10
10 solar panel) or 2 x AA standard alkaline ba tteries (non -rechargeable; not inclu ded). The Temperature Station com es with special solar- rechargeable batteries that shou ld provide many years of service. If t he batteries lose their abili ty to hold a charge, please d ispose of them responsibly . Do NOT attempt to recharge the included solar- ...
-
La Crosse Technology WS-6020U-IT - page 11
11 2. Slid e the battery sw itch to the DOWN to select the alkaline battery . 3. Insert new, 2 x standard al kaline batteries into the compartment, observ ing the correct polarity (see marking in side battery compartment or on the ca se). 4. Replace battery cov er NOTE : For best performan ce, standard alkaline batteries should be replaced at least ...
-
La Crosse Technology WS-6020U-IT - page 12
12 the batteries back into the Temperature station (slide the sw itch to the up if using the included solar-rechargeable batterie s), press the RESET key on the Sen sor and follow the set up process again. 3. The distance betw een the Temperature Station and the Sensor sh ould not be more than 200 feet (60.96m ) to ensure sufficien t 915 MHz transm ...
-
La Crosse Technology WS-6020U-IT - page 13
13 Ensure that the Temperature Station continuously receives the 915MH z signal from the Sensor before mounting it in th e desired location. The Temperature Station should be placed in a bright environment for the sol ar cell to collect enough light to recharge the in cluded solar-rechargeable batteries. WALL MOUNTING 1. Install a mounting screw (n ...
-
La Crosse Technology WS-6020U-IT - page 14
14 light to recharge the int ernal power cell. It is bes t mounted on an East w all to receive cool morning sun to charge. Under an overhang will provide protection from the ov erhead sun, which can cau se temperature inaccuracie s. The Sensor can be placed onto any flat surfa ce or wall mounted using the bra cket which doubles as a stand or wall m ...
-
La Crosse Technology WS-6020U-IT - page 15
15 SPECIFICATIONS: Indoor Temperature: Measuring range: 16°F to 14 0° ( “ -- .- “ or “ -- .0” is dis played when the indoor temperature is outside this rang e) Measured period: ev ery 2 minutes Indoor Humidity : Humidity measuring range : 20% to 95% (19%RH will be display ed if the reading is lower than 20%, 96% will be di splayed if the ...
-
La Crosse Technology WS-6020U-IT - page 16
16 Warranty service can only be performed by a La Crosse Technology, Ltd authorized servic e center. The original dated bill of sale must be presented upon request as proof of purchase to La Cross e Technology, Ltd or La Crosse T echnology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our opti ...
-
La Crosse Technology WS-6020U-IT - page 17
17 accessory or decorative surfa ce; (4) damage resulting from failure to follow instructio ns contained in your owner’ s manual; (5) damage result ing from the performance of repai rs or alterations by someone other than an authori zed La Crosse Technology, Ltd authorized service center; (6 ) units used for other than home use (7) applications a ...
-
La Crosse Technology WS-6020U-IT - page 18
18 La Crosse Technology , Ltd 2817 Losey Blvd. S. La Crosse, WI 54601 The complete instruction manu al is available at: www.lacrossetechnology .com/6020 Le manuel d'instruction comple t est disponible sur: www.lacrossetechnology .com/6020 El manual de instrucciones completo está disponible en: www.lacrosse technology.com/6020 Product Registra ...
-
La Crosse Technology WS-6020U-IT - page 19
19 FCC ID: OMO -M-10 (transmitter) FCC DISCLAIMER RF Exposure mobile: The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8 inches) from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter." Statement according to FCC part ...
-
La Crosse Technology WS-6020U-IT - page 20
20 Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help All rights reserved. This handbook must not be reproduced i ...
Haben Sie eine Frage bezüglich La Crosse Technology WS-6020U-IT?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit La Crosse Technology WS-6020U-IT nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit La Crosse Technology WS-6020U-IT hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.