Bedienungsanleitung CDA FW381

20 Seiten Betrifft nicht
Download

Zur Seite of 20

Summary
  • CDA FW381 - page 1

    Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu FW381 integrated under counter freezer Manual for Installation, Use and Maintenance ...

  • CDA FW381 - page 2

    2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appliance is not designed to be used by people (in ...

  • CDA FW381 - page 3

    3 This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (L VD) and Electromagnetic interference compatibility (EMC). P arts intended to come into contact with food conform to EEC/89/109 .4 IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE W ...

  • CDA FW381 - page 4

    4 Important Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance. This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only , not for storage of blood, medicine and biological products. T o prevent risk of fire, keep the appliance aw ...

  • CDA FW381 - page 5

    5 Before first use Y ou must allow the freezer to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior . The freezer may have an odour to it at first u ...

  • CDA FW381 - page 6

    6 Use Freezer • The freezer compartments are designed to store only frozen food. • Never put hot or warm foods in the freezer , allow them to cool fully before putting them into the freezer . • Follow the instructions on the food packaging for storage of frozen food. If no information is provided, foods should not be stored for more than thre ...

  • CDA FW381 - page 7

    7 Control panel Thermostat dial The thermostat can be set between (least cold) and 5 (coldest) When introducing large amounts of fresh food into the freezer , turn the thermostat dial to position 5. After 24 hours, return the thermostat dial to its usual position. fig. 1 1 2 3 4 5 ...

  • CDA FW381 - page 8

    8 Defrosting the freezer Do not use heaters or defrosting sprays in this appliance. • Never use any metallic or sharp objects to remove the ice as this could damage the lining. • The freezer compartment should be defrosted regularly to ensure the most ecient running of the freezer . • Once the ice is more than 5mm thick, the freezer should ...

  • CDA FW381 - page 9

    9 T roubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CD A Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working • Chec k there is power to the appliance: • The house fuses are intact and the fuse in the plug has not blown. • The ...

  • CDA FW381 - page 10

    10 fig. 2 KIT 1 2 3 4 5 6 9 10 7 8 9 10 Installation This appliance must never be installed close to heat sources i.e. heating elements, radiators, cookers or in damp places. The appliance should be mounted on a piece of wood (for example a section of worktop or kitchen carcass) if a raised oor is to be tted, if the kitchen oor is to be t ...

  • CDA FW381 - page 11

    11 fig. 5 fig. 3 fig. 4 11 11 600 min 550 820- 890 595 548 min 25 819- 889 100- 170 5 6 11 11 Installation Fig. 3 - Dimensions of the appliance Fig. 4 - Fitting the worktop bracket R emove the screw (5) on the top of the appliance, locate the top bracket(6) and fix the bracket with screw(5). Fig. 5 - Fitting the spacer piece T ake out the space ...

  • CDA FW381 - page 12

    12 9 9 fig. 8 Installation Fig. 6 - Adjusting the appliance height The height of the appliance can be adjusted by the help of adjustable feet to fit the furniture height. Use a spirit level to ensure the appliance is level. Fig. 7 - Aligning the appliance Slide the appliance into the kitchen unit and align the hinge surface with front surface of ...

  • CDA FW381 - page 13

    13 2 1 B-C fig. 11 Installation Fig. 9 - Fitting the decor door bracket Unscrew and remove the nuts and washers from the appliance door . Place fixing bracket on the appliance door by inserting the holes to adjustment bolts. Dimension B= Measure from the underside surface of kitchen unit to the bottom of fixing bracket. Dimension C= Measure from ...

  • CDA FW381 - page 14

    14 fig. 14 Installation Fig. 12 - Aligning the decor door Close the door and check the alignment with the other unit doors. Adjust the decor door by screwing or unscrewing the adjustment bolts for vertical adjustment and by the help of the slots on the fixing bracket for other directions. L ock the screws into place as shown in 10 .2. Fig. 13 - F ...

  • CDA FW381 - page 15

    15 Installation Fig. 17 - Fitting the plinth Fit the plinth section, providing minimum 25 mm gap between the cabinet door and fix it. Never cover over the ventilation slots. Once installed the plinth must not block the ventilation slots in the appliance. This may require cutting the plinth down. Failure to ensure adequate ventilation may invalidat ...

  • CDA FW381 - page 16

    16 Electrical information W arning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. T o change a fuse in this type of plug, follow the steps below: 1. R emove the fuse cover and fuse. 2. Fit replacement 13A fuse, A ST A approved to BS 1362 type, into the fuse cover . 3. R eplace f ...

  • CDA FW381 - page 17

    17 As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: • The wire which is coloured GREEN and YELL O W must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELL O W . • T ...

  • CDA FW381 - page 18

    18 ...

  • CDA FW381 - page 19

    19 ...

  • CDA FW381 - page 20

    Please contact our Customer Care Department, or for Service on the details below . Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu ...

Produzent CDA Kategorie Freezer

Dokumente, die wir vom Produzenten des Geräts CDA FW381 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen CDA
- Bedienungsanleitungen FW381
- Produktkarten CDA
- Informationsbroschüren
- oder Energieetiketten CDA FW381
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung CDA FW381.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen CDA FW381, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen CDA FW381. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts CDA FW381 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts CDA FW381, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von CDA FW381 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von CDA FW381 verständlich ist.

Eine gänzliche Bedienungsanleitung von CDA sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von CDA FW381 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von CDA FW381 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich CDA FW381, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts CDA FW381 - die uns die ersten Schritte während der Nutzung von CDA FW381 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit CDA FW381 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von CDA FW381 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich CDA FW381?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit CDA FW381 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit CDA FW381 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)