Bedienungsanleitung Ford 2004 Mustang

16 Seiten 0.12 mb
Download

Zur Seite of 16

Summary
  • Ford 2004 Mustang - page 1

    Introduction 2 Instrumentation 4 Servicing your vehicle 5 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company . Ford may change the contents ...

  • Ford 2004 Mustang - page 2

    ABOUT THIS SUPPLEMENT This booklet supplements your Owner Guide and is part of the owner’ s portfolio. It describes the operation of your natural gas vehicle (NGV) and how it differs from a standard gasoline powered vehicle. Therefore it is very important that you read this guide and thoroughly familiarize yourself and others operating the vehicl ...

  • Ford 2004 Mustang - page 3

    COMPRESSED NATURAL GAS (CNG) FUEL SYSTEM Y our vehicle is equipped with a dedicated compressed natural gas (CNG) fuel system that is under high pressure. Depending upon the application, the CNG fuel system is rated at a pressure of 20,700 kPa (3,000 psi) at 21 ° C (70 ° F) or 24,800 kPa (3,600 psi) at 21 ° C (70 ° F). Refer to the label on the ...

  • Ford 2004 Mustang - page 4

    FUEL GAUGE The fuel gauge in your NGV behaves similarly to a typical gasoline fuel gauge. However , the gauge operation is based on the pressure and temperature of the natural gas, not on the level of liquid gasoline. Depending upon application, a fuel gauge reading of Full will occur at a pressure of approximately 20,700 kPa (3,000 psi) or 24,800 ...

  • Ford 2004 Mustang - page 5

    CNG FUEL SYSTEM COMPONENT IDENTIFICATION The following illustrations depict the major unique components of the CNG fuel system. All of these unique components are constructed of special materials that withstand the effects of CNG. NEVER replace a unique CNG fuel system component with a standard gasoline fuel system component or any aftermarket comp ...

  • Ford 2004 Mustang - page 6

    E-450 Cutaway 1. Fuel rail sensors - An injection pressure sensor and an engine fuel temperature sensor provide engine fuel information to the powertrain control module. 2. Isolation solenoid valve - Blocks fuel flow from supply line to injection manifold when the engine is off. 3. Engine - A modified 5.4L gasoline engine with Sequential Electronic ...

  • Ford 2004 Mustang - page 7

    9. Aft axle fuel tanks - T wo steel fuel tanks located behind the rear axle. 10. Midship fuel tank - A steel fuel tank located underbody . 11. High pressure fuel lines - Delivers high pressure fuel to the fuel tanks and fuel pressure regulator . 12. Fuel pressure regulator/Coalescent fuel filter - Reduces fuel pressure and removes impurities from t ...

  • Ford 2004 Mustang - page 8

    vehicle ’ s inertia switch. If the engine cranks but does not start after a collision, the fuel solenoid valve inertia switch may have been activated. The inertia switch is a device intended to close the fuel solenoid valve when your vehicle has been involved in a substantial jolt. 6. Standard fuel tanks - T wo steel fuel tanks located in the bed ...

  • Ford 2004 Mustang - page 9

    2. Isolation solenoid valve - Blocks flow from the injection manifold when the engine is off. 3. Engine - Is a modified 4.6L engine with Sequential Electronic Fuel Injection (SEFI) and increased compression ratio. 4. Engine coolant lines - Provide required heat to high pressure regulator . 5. Powertrain control module - Required for NGV application ...

  • Ford 2004 Mustang - page 10

    ADAPTERS DO NOT use fuel receptacle adapters when refueling your vehicle. The profiles of both the natural gas vehicle receptacle and the fuel station nozzles are specified by ANSI/AGA NGV1-1994, CGA NGV1-M94. These profiles are specified for compressed natural gas vehicles and fuel stations for safety purposes. Three separate adapter profiles are ...

  • Ford 2004 Mustang - page 11

    indication that refueling is nearly complete. Also, the station compression equipment may turn on at any time during the refueling process. FUEL QUALITY Do not use liquefied natural gas (LNG) or a CNG that is derived from a process such as flashing (heating LNG). Failure to use the correct type of fuel may cause damage to the engine and fuel system ...

  • Ford 2004 Mustang - page 12

    SERVICING YOUR NATURAL GAS VEHICLE Service to the CNG fuel system should be conducted at a qualified dealership by a trained NGV technician only . Failure to do so may cause damage to components or cause bodily harm. FUELING Do not fuel your vehicle with the ignition on the ON position. Failure to do so may cause component damage. Fueling a NGV , w ...

  • Ford 2004 Mustang - page 13

    Use caution when fueling your vehicle. Make sure the engine is turned off and all flammable material is extinguished. Observe all Dispensing Equipment Safety Standards and Operating Procedures. The procedure is the same for both fast-fill and slow-fill fueling. 1. Open fuel door and determine the pressure rating of your vehicle ’ s fuel system. 2 ...

  • Ford 2004 Mustang - page 14

    E-Series Cutaway 158 ” Wheelbase (3600 psi) Fueling method Standard tanks W ith Extended Range - One In-body T ank W ith Extended Range - T wo In-body T anks Slow-fill 63.2L (16.7 gallons) 96.1L (25.4 gallons) 128.7 (34.0 gallons) Fast-fill 53.8L (14.2 gallons) 81.8L (21.6 gallons) 109.4L (28.9 gallons) E-Series Cutaway 176 ” Wheelbase (3000 ps ...

  • Ford 2004 Mustang - page 15

    Crown V ictoria (3600 psi) Fueling method Standard tanks W ith extended range system 1 Slow-fill 45.0L (11.9 gallons) 59.1L (15.6 gallons) Fast-fill 38.2L (10.1 gallons) 50.3L (13.3 gallons) 1 Police and T axi vehicles. Extended range fuel system Crown Victoria Police and T axi vehicles with the extended range fuel system have a 5 – passenger sea ...

  • Ford 2004 Mustang - page 16

    The purpose of the inspection is to check for exterior damage to the tank which would shorten its usable life span. This inspection should only be done by qualified NGV Ford service technicians. The expiration date for the tank replacement is stated on each tank label See instructions on fuel container for inspection and service life. Coalescent fu ...

Produzent Ford Kategorie Automobile

Dokumente, die wir vom Produzenten des Geräts Ford 2004 Mustang erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Ford
- Bedienungsanleitungen 2004 Mustang
- Produktkarten Ford
- Informationsbroschüren
- oder Energieetiketten Ford 2004 Mustang
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Ford 2004 Mustang.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Ford 2004 Mustang, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Ford 2004 Mustang. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Ford 2004 Mustang ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Ford 2004 Mustang, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Ford 2004 Mustang hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Ford 2004 Mustang verständlich ist.

Eine gänzliche Bedienungsanleitung von Ford sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Ford 2004 Mustang bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Ford 2004 Mustang befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Ford 2004 Mustang, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Ford 2004 Mustang - die uns die ersten Schritte während der Nutzung von Ford 2004 Mustang erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Ford 2004 Mustang hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Ford 2004 Mustang im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Ford 2004 Mustang?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Ford 2004 Mustang nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Ford 2004 Mustang hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (1)

Bernhard Wöhnl

ich suche eine deutsches Handbuch