-
Power Acoustik PTID-6250B - page 1
PTID-6250B In-Dash 6.2” Monitor Touch Screen DVD/CD/MP3/MP4 AM/FM Radio With Bluetooth Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures wi ll help you obtain the best Performance from your new DVD-receiver. ...
-
Power Acoustik PTID-6250B - page 2
2 WARNING! To promote safety, certain functions are disabl ed unless the parking brake is on. The Unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. Improper connection or use of his connection may violate applicable law and may result in serious injury or damage. To avoid the risk o ...
-
Power Acoustik PTID-6250B - page 3
3 CONTENTS WARNING ! ................................................................................................................. 2 OPERATION PREC AUTIONS .................................................................................... 2 CONTENTS .............................................................................................. ...
-
Power Acoustik PTID-6250B - page 4
4 Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring Washer, M5 Nut 1 each (2) Mounting Strap 1 (3) Bolt 1 (4) Screw 5*20 1 (5) Screw 4*6 4 1x AV-IN Cable Warranty card User Manual Remote Control RCA Cable Trim ring 1 ISO Cable Trim ring 2 ...
-
Power Acoustik PTID-6250B - page 5
5 INSTALLATION Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudd ...
-
Power Acoustik PTID-6250B - page 6
6 WIRING CONNECTIONS NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be c onnected to break signal. 2 cables is connected to a Hands- ...
-
Power Acoustik PTID-6250B - page 7
7 Note: - Only use groundless loud spea kers. - Use only loudspeakers of minimal 40Watt, using fewe r watts may result in damaging your loudspeakers at higher volumes. - Use 4~8 (Ohm impedance) loud sp eakers only; using hi gher or lesser impedance may damage the unit . - Do not use 3-cable loudsp eakers and do not connect the loudspeakers mi n ...
-
Power Acoustik PTID-6250B - page 8
8 Front panel 1 . EJECT Button Press it to eject a disc. If t he disc is not removed for about 10 se conds after eject, the disc is reinserted automatically. 2. IR Sensor IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels. 3.POWER Button Press it to turn on the unit. Pr ess and hold for 2 seconds to turn the unit off . ...
-
Power Acoustik PTID-6250B - page 9
9 USB slot, for Multimedia playback files only. Inse rt a USB into this slot and the unit will automatically start reading and playback the card. * Supported Music File Format: MP3, WMA Files 9. RESET Button Press it with a thin, sharp objec t. The device will then be reset to factory default settings. 10. DISC slot 11. Info Display Information Dis ...
-
Power Acoustik PTID-6250B - page 10
10 6. EJECT button Press it to eject the disc. 7.STEREO/MONO/* Press STEREO button to se lect STEREO or MONO. In BLUETOOTH mode, press it to make a * symbol. 8.P.SCN/ RPT /# In SD CARD/ USB mode, press to repeat REP 1 => REP DIR => REP ALL In DVD mode, press to start repeat REP OFF=>REP Chapter=>REP Title=>REP Off. In Radio mode: PS ...
-
Power Acoustik PTID-6250B - page 11
11 In BLUETOOTH mode, press to reject a coming call or hang up while calling 21. VOL+ button Press to increase volume level. 22. A-B/ZOOM button During playback, press it at the starting point of section you want to repeat(A), press this button again at the ending point of the se ction you want to repeat (B), section A-B repeating starts. Press it ...
-
Power Acoustik PTID-6250B - page 12
12 28. OPEN/TILT button: (O ption without function) REMOVE BATTERY Note: The distance may vary according to the brightness of ambient light. If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion. Do not place any objects between the remote control unit ...
-
Power Acoustik PTID-6250B - page 13
13 MAIN MENU The best way to discover the program is to explor e each screen in detail, and to find out how to move from one to another. Read th is chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of t he screen hierarchy, and you can simply a cces s all features by tapping on the touch screen buttons. Tap the ic ...
-
Power Acoustik PTID-6250B - page 14
14 Touch this button to select stereo or mono s ound reception. Touch this button to select reception of local station or DX fo r distance station. ◆ DVD PLAYER To start DVD Player, tap on DVD button from main menu screen. TOUCH SCREEN MEN U You will not see any buttons while DVD is played. Buttons will appear when you tap on TFT screen. Tap the ...
-
Power Acoustik PTID-6250B - page 15
15 In VCD mode touch it can choose PBC ON or OFF. In DVD mode touch it to enter TITLE MENU (Enable only if the DVD disc with title menu). ◆ Insert USB/SD/MMC and play tr ack will display as follows: mute the sound volume button. press to decrease the volume, press to increase the volume. stop button. Press it to Stop pl ayback from the current po ...
-
Power Acoustik PTID-6250B - page 16
16 ◆ AV-IN Mode To start AV-IN Mode, tap on AV-IN button from main menu screen. Note: If there is no ex ternal video input, the TFT displays “NO VID EO SIGNAL” Press the icon to be back to main menu. ◆ SETTING CONTROL Your device has default system se ttings. You can customize the se ttings to suit your personal needs. Once you change setti ...
-
Power Acoustik PTID-6250B - page 17
17 RADIO CONTROL Tap RADIO button from setting menu screen. GENERAL CONTROL Tap GENERAL button from setting menu screen. Tap Down button from setting GENERAL 1 screen. SCREEN Screen setting 16:9, 4:3 ， FULL Backlight Backlight se tting LOW, MID, HIGH AREA Set AREA:EUROPE-U.S.A-SOUTH AMERICA-RUSSIA STEREO Set STEREO ON or OFF LOCAL Set LOCAL ON or ...
-
Power Acoustik PTID-6250B - page 18
18 DVD SET UP MENU Tap the DVD button in main menu to enter the DVD player. Press the SETUP button to enter into the system settings main menu; press t he up or down arrow buttons to move to the highlighted menu item and select one of the Setup Pages: [1]. Subtitle Lang setting: With this option you can select the preferred language for the subtitl ...
-
Power Acoustik PTID-6250B - page 19
19 [6] TV SHAPE: Set TFT screen mode to the correct ratio: Three screen ratio modes are availa ble, Normal/PS (4:3 Pan Scan), Normal/LB (4:3 Letterbox) and Wide (16:9). Different disc formats will display different images depending this setting and the screen size used. [7] NTSC/ PAL: Select this menu item to set up your preferred video output form ...
-
Power Acoustik PTID-6250B - page 20
20 BLUETOOTH SECTION Warning: Driving and having a Telephone conversation at the same time is dangerous, please park your car before having a telephone conversation. The supplier waves any and all liability when this warning is not followed. To enter Bluetooth mode, y ou can tap Bluetooth icon on Ma in menu or long press the mute/Bluetooth button o ...
-
Power Acoustik PTID-6250B - page 21
21 Voice Transfer During a call, you can change a call from Bluet ooth mode to phone by tapping Transfer button. To have a call in Bluetooth mode again, tap Transfer button. NOTE: the phonebook only supports Western Characters. Any difference in character will be shown such as “ + , * or # ”. 2.BT PHONE BOOK The unit can downloading the data fr ...
-
Power Acoustik PTID-6250B - page 22
22 NOTES ON DISC Only use groundless loudspeaker s. Use only loudspeaker s of minimal 40Watt, usi ng fewer watts may resu lt in damaging your loud speakers at higher volumes. Use 4~8 (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. Do not use 3-cable loudspeakers and do not connect the lou ...
-
Power Acoustik PTID-6250B - page 23
23 TROUBLESHOOTING Symptom Cause Remedy Fuse is blown Replace with fuse of the same amperage. If the fuse blows again, consult your store of purchase Power does not turn on. (No sound is produced.) In correct wiring Consult your local retailer. No sound output when operating the unit with amplifiers or power antenna attached. Power antennal lead is ...
-
Power Acoustik PTID-6250B - page 24
24 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION THE CAR IGNITION IS NOT ON. IF THE POWER SUPPL Y IS PROPERLY CONNECTED TO THE CAR ACCESSORY SWITCH THE IGNITION KEY TO “ACC”. NO POWER THE FUSE IS BLOWN. REPLACE THE FUSE. DISC CANNOT BE LOADED. PRESENCE OF DISC INSIDE THE PLAYER REMOVE THE DISC IN THE PLAYER THEN PUT A NEW UPWA RD. INSERTING THE DISC I ...
-
Power Acoustik PTID-6250B - page 25
25 TECHNICAL SPECIFICATIONS General Power supply: 11~16V DC Current consumption: max. 10 A Maximum power output: 52W x 4 channels (max) Compatible formats: DVD/SVCD/VCD/HDCD/MP3/MP 4/VIDEO/CDDA/Picture CDCD-R/-RW/DVD±R/±RW playback Dimensions (W x D x H) / weight: 165*178*100 mm/2 kg Working temperature range: -10 ℃ - +60 ℃ ESP function: 10 s ...
Haben Sie eine Frage bezüglich Power Acoustik PTID-6250B?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Power Acoustik PTID-6250B nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Power Acoustik PTID-6250B hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.