Bedienungsanleitung Radio Shack ET-007

24 Seiten 1 mb
Download

Zur Seite of 24

Summary
  • Radio Shack ET-007 - page 1

    Cat. No. 43-0 07 OWNER’S MANUAL Please read before using this equ ipment. ET-007 900 MHz Handsfree Cordless Headset System 43-007.fm Page 1 Wedn esday, March 22, 2000 11:24 AM ...

  • Radio Shack ET-007 - page 2

    2 FEATURES Your RadioShack ET-007 900 MHz Handsfree Cordless Headset System gives you commu nication with both port- ability and convenience. It includes a corded base te lephone, a 900 MHz digi- tal wireless headset, a wireless headset charger and an infrared rem ote dial card. The Corded Base Telephon e combines advanced te lephone tech nology wi ...

  • Radio Shack ET-007 - page 3

    3 Carry Strap — lets you hang the remote dial card from your neck for handsfree carrying. Your ET-007 is listed to UL stan dards and meets all applicable FCC stan- dards. READ THIS BEFORE INSTALLATION We have designed you r phone to con- form to federal regula tions and you can connect it to mo st phone lines. Ho wever, each device tha t you conn ...

  • Radio Shack ET-007 - page 4

    4 The ET-007 also complies with the limits for a Class B device as specified in Part 15 of FCC Rules. These limits provide reasonable prot ection against rad io and TV interference in a residential ar ea. However, your ET-007 migh t cause TV or radio interfere nce even when it is op- erating properly. To elimin ate interfer- ence, you can try one o ...

  • Radio Shack ET-007 - page 5

    5 CONTENTS Installation .. ................ ................ ................ ................. ................ ................ ............ 6 Selecting a Location .............. ................ ................. ................ ................ ............ 6 Connecting th e Han d se t ............... ... ............. ... ... .... ... ... ... ...

  • Radio Shack ET-007 - page 6

    6 INSTALLATION SELECTING A LOCATION You can plac e the ET-007 on a desk or table, mount it on a standard wall plat e, or mount it direct ly on a wall. Choose a location that is: • near an AC outlet • near a modular te lephone line jack • out of the way of norma l activities Note: Your ET-007 connects directly to a modular telephon e line jack ...

  • Radio Shack ET-007 - page 7

    7 4. Route the adap ter's cord through the strain relie f slot on the bottom of the phone. 5. Lift the b ase telephone's a ntenna to a vertical position . CONNECTING THE HEADSET CHARGER , WIRELESS HEADSET AND INFRARED REMOTE DIAL CARD To connect the h eadset charger, con - nect the headset char ger’s built-in AC cord to the AC outlet. T ...

  • Radio Shack ET-007 - page 8

    8 • The INTERCOM and HOLD in di- cators on the co rded phone stop flashing after th e headset charger and wireless headset are con - nected, even when there is no battery pack in the headset. If they flash, mo ve the headset an d charger clos er to the co rded phone. Remove the battery insulation strip from the infrare d remote dial c ard’s bat ...

  • Radio Shack ET-007 - page 9

    9 3. Route t he modular c ord into the right gr oove on the moun ting bracket and rou te the AC adapter's cord into the left groove . 4. Press up on the ha ndset holder to remove it, turn it over , then slide it back down into its slot. 5. Place the phone's tw o keyhole slots over the w all plate studs (or the screws, if you ar e mounting ...

  • Radio Shack ET-007 - page 10

    10 PREPARATION Follow the steps in “ Connecting the Headset Charger, Wire less Headset and Infrared Remote Dial Card” on Page 7 to install the battery in the he adse t. CHARGING THE BATTERY PACK After you inst all a battery pa ck, let the battery charge f or about 24 ho urs b ef or e you use the headset t he first time. The charging indicator o ...

  • Radio Shack ET-007 - page 11

    11 SETTING THE DIALING MODE Set TON E/ PU LS E on the bottom of the corded phone for the type of service you have, either tone or pulse (rotary). If you are not sur e which typ e you have, do this simple te st. 1. Set TONE/PULSE to TONE . 2. Lift the h andset and listen fo r a dial tone. 3. Press any nu m be r ex ce pt 0 an d 1. Note: If your phone ...

  • Radio Shack ET-007 - page 12

    12 SETTING THE RINGER VO L U M E To adjust the ringer volume on the cord- ed base phone, slid e the switch on the right side of t he base to RINGER OFF , LOW or HI . If you do not want the rin ger to sound, slide the switch to OFF . You can make calls with the ring er off, and y ou can an- swer calls if you hear another phone on the same phone line ...

  • Radio Shack ET-007 - page 13

    13 Listening Safely To protect your hearing , follow these guidelines when yo u use the headset. • Set the volume to th e lowest setting before you beg in listening. Afte r you begin listening, adjust the volume to a comforta ble level. • Do not listen at ext remely high vol- ume levels. Extended high volume listening can le ad to permane nt he ...

  • Radio Shack ET-007 - page 14

    14 OPERATION MAKING AND ANSWERING CALLS Using the Handset To make a call, p ick up the handset an d dial normally. The IN USE indicator flashes when you receive a ca ll and lights while the phone is in use. Pick up the ha ndset to answer a call and place the handset on the base to end a call. Note: The corded phone will not operate without AC power ...

  • Radio Shack ET-007 - page 15

    15 To switch from th e headset to the ha nd- set, press HOLD on the infrared remote dial card. The IN USE/BATT. LOW indi- cator flashe s. Pick up the handset to a n- swer the call. The headset sounds a tone if the hand set is not picked up wi th- in about 3 0 se conds. Using the Intercom To use the intercom to switch from the handset to the headset ...

  • Radio Shack ET-007 - page 16

    16 USING REDIAL You can quickly dial the la st number di- aled. Wh en you heard a dial tone, press REDIAL on the corded pho ne, or on the infrared remote dial card if you want to use the headset fo r dialing. Note: The base co rded phone a nd the headset record th eir own last nu mber d i- aled. You cannot r edial the last numbe r recorded in the c ...

  • Radio Shack ET-007 - page 17

    17 USING HOLD To put a caller on hold, press HOLD . The HOLD indicator on the corded phone flashes and you can hang up the hand- set without disconnectin g the call. Or, if you are using th e headset, pres s HOLD on the infr ared remote dial card. To resume th e call, lift th e handset, pu ll down on the microphone until it clicks, or pick up any e ...

  • Radio Shack ET-007 - page 18

    18 3. Enter the numb er you want to store (up to 20 digit s can be stored ), including any pause or to ne entries (see “Entering a Pause in a Memory Number” on Pa ge 18 or “Usin g T one Service on a Pulse Lin e” on Page 17). 4. Press MEMOR Y on the base. The phone rings to indicate that the number is stored successfully . Notes: • If you ...

  • Radio Shack ET-007 - page 19

    19 Chain-Dialing For quick recall of numbers for special services (such as b ank-by-phone or al- ternate long-dista nce), you can stor e each group of numbe rs in its own mem- ory location. Then, when calling special services, dia l the service's main number first. At the ap propriate place in th e call, press the me mory location button for t ...

  • Radio Shack ET-007 - page 20

    20 T ROUBLESHOOTING We do not expect you to have an y problems with your p hone, but if you do, the follo w- ing suggestions might help. If you still have problems, take the phone to your local RadioShack store for assist ance. Problem Suggestion Interference is severe . Move the wir eless headset closer t o the base. Keep the wirele ss headset aw ...

  • Radio Shack ET-007 - page 21

    21 If you still have problems, disconnect the phone. If other phones on the s ame line work properly, t he fault is in this ph one or its installat ion. If you ca nnot find the pr ob- lem, take the phone to yo ur local RadioShack store fo r assistance. The base’ s INTERCOM an d HOLD indi- cators flash. Move the wireless headset closer to the base ...

  • Radio Shack ET-007 - page 22

    22 CARE To enjoy your RadioSha ck ET-007 900 MHz Handsfree Cordless Headset Sys- tem for a long time: • Keep the ET-007 dr y . If it gets wet, wipe it dry immediately . • Use and store the ET-00 7 only in normal temperature environments. • Handle the ET-007 g ently and care- fully . Do not drop it. • Keep the ET-007 away from dust and dirt. ...

  • Radio Shack ET-007 - page 23

    23 NOTES 43-007.fm Page 23 Wednesday, M arch 22, 2000 11:24 AM ...

  • Radio Shack ET-007 - page 24

    RadioShack A Division of T andy Corporation Fort W orth, T exas 76102 03A00 Printed in China Limited One-Y ear W arranty This product is warranted by RadioShack against manufactu ring defects in material and workman- ship under normal use for one (1 ) year from t he da te of pu rchase from Radi oSha ck compan y- owned stores and authorized RadioSha ...

Produzent Radio Shack Kategorie Wireless Office Headset

Dokumente, die wir vom Produzenten des Geräts Radio Shack ET-007 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Radio Shack
- Bedienungsanleitungen ET-007
- Produktkarten Radio Shack
- Informationsbroschüren
- oder Energieetiketten Radio Shack ET-007
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Radio Shack ET-007.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Radio Shack ET-007, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Radio Shack ET-007. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Radio Shack ET-007 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Radio Shack ET-007, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Radio Shack ET-007 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Radio Shack ET-007 verständlich ist.

Eine gänzliche Bedienungsanleitung von Radio Shack sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Radio Shack ET-007 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Radio Shack ET-007 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Radio Shack ET-007, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Radio Shack ET-007 - die uns die ersten Schritte während der Nutzung von Radio Shack ET-007 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Radio Shack ET-007 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Radio Shack ET-007 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Radio Shack ET-007?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Radio Shack ET-007 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Radio Shack ET-007 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)