Bedienungsanleitung Baumatic TECHNO

28 Seiten 1.51 mb
Download

Zur Seite of 28

Summary
  • Baumatic TECHNO - page 1

    TECHNO Cooker Hood ...

  • Baumatic TECHNO - page 2

    1 User Manual for your Baumatic TECHNO Cooker Hood 90 cm Chimney Hood in Stainless Steel NOTE : This User Instruction Manual co ntains important information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily availabl e for future reference. 1 ...

  • Baumatic TECHNO - page 3

    2 YOUR COOKER HOOD’S SPECIFICATIONS ….……………..………….3 IMPORTANT SAFETY INFO RMATION……………………………….…4-5 CARING FOR THE ENVI RONMENT…………………………………………6 USING YOUR COOKER HOOD………………………………..……………..7 MAINTAINING AND CLEANING YOUR COOKER HOOD …? ...

  • Baumatic TECHNO - page 4

    3 Congratulations on purchasing a Baumatic Cooker Hood! To fully enjoy using your app liance long into the future, please firstly familiarise yours elf with its specifications, safety advice and operational in structions included in this manual. You will also need this manual to ensure that your Cooker Hood has been installed properly. DIMENSIONS W ...

  • Baumatic TECHNO - page 5

    4 o Any installation work must be carried out by a qualified electrician or competent person. o The hood must be installed in accordance with the installation instructions and all measurements followed. o If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes ...

  • Baumatic TECHNO - page 6

    5 o Ensure the ducting for the extractor function has the same diameter as the outlet hole all the way through. o Keep young children from using, playing with or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood. o Your cooker hood is for domestic use only. o Please dispose of t ...

  • Baumatic TECHNO - page 7

    6 Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be under taken by a competent person. CONFORMITY TO W.E.E.E. DIRECTIVE Environmental Note ...

  • Baumatic TECHNO - page 8

    7 To use your cooker hood: 1) Make sure it has been properly installed. 2) Find the CONTROL PANEL. It is located centrally at the front of the canopy. 3) The CONTROL PANEL contains keys as shown in the Figure below. These perform separate functions. You will need to understand what the keys do before you attempt to use your cooker hood. * Note: The ...

  • Baumatic TECHNO - page 9

    8 SPECIAL FUNCTIONS : Your Baumatic Cooker Hood also has advanced features. These are: a) Reminder to clean t he Metal Grease Filters After every 30 hours of use, your cooker hood’s microprocessor will alert you to clean the metal grease filters. It does this by showing a flashing ‘A’ on the display for 5 seconds . Please ensure that you clea ...

  • Baumatic TECHNO - page 10

    9 IMPORTANT! : Before cleaning, always ensure that you have switched your cooker hood OFF at the omni-polar switch, set at the wall from t he cable: Cleaning  Clean the external p arts with mild liquid deterg ents on a damp cloth.  Never use abrasive powder, corrosive solvents or brushes.  Never insert pointed objects into the motor’s prote ...

  • Baumatic TECHNO - page 11

    10 First remove the grille by pu lling down on it. Undo the side catches. You can now clean the anti -grease filter grilles. 9 Soak them for about one hour in hot water with a grease-loosening detergent then rinse off thoroughly with hot water. 9 Repeat the process if needed . Refit the grease grille once it has dried. 9 Refit the grease grilles wh ...

  • Baumatic TECHNO - page 12

    11 a) Changing the light bulb 9 Before changing the light bulb, ensure th at the appliance is not live (i.e., ensure that you have switched it off so that it’s in the ‘0’ position). 9 Remove the metal anti-grease filters (se e Figure 2 below) and find the old bulb located in the light fixture up inside the exposed canopy. Ch ange the halogen ...

  • Baumatic TECHNO - page 13

    12 _____________________________________________ ____________________________________ _____ Installing / Changing the Carbon Filter . Your Baumatic Cooker Hood uses a CARBON FILTER to purify the air for the air recirculation function. You will find that on e filter will attach to the fan motor’s top cavity (please see figu res at bottom of page). ...

  • Baumatic TECHNO - page 14

    13 Before installation and usage, read all the instructions and make sure that the voltage (V) and th e frequency ( Hz) indicated on the identif ication plate (found inside your Cooker Hood) and all the dat a inside the ap pliance are exactly the same as the voltage and frequency in your home. NOTE: The manufacturer declines all responsibilit y in ...

  • Baumatic TECHNO - page 15

    14 : The cooker hood must not be fitted above stoves with a radiant top plate. : We recommend that at least two people install this hood. NOTE: Your Baumatic Cooker Hood shou ld only be fitted on a wall. Do NOT position it any less tha n 700 mm (70 cm) above the hob. 1) Remove the metal anti-grease filters (See figure at right). 2) Position the chi ...

  • Baumatic TECHNO - page 16

    15 4) Work screws into the ho les until there is 10mm of screw still stuicking out. Affix the chimney to the wall by working its holes onto the screws. Then tighten the screws the rest of th e way in. ---------------------------------------------------------------------------- ---------------------------------------------------------------- ------- ...

  • Baumatic TECHNO - page 17

    16 6) Once you have latched the tongues into the slots , secure the hood to the fixed chimney through the screw holes. 7) Next, connect the spigot to the exhaust port of the chimney section. Ensure that your ducting has a di ameter of 150mm and that the cross section of the exhaust is 150 sq cm. INSTALLATION INSTRUCTIONS – Fittin g the Pi p e ...

  • Baumatic TECHNO - page 18

    17 8) Then, take the decorati ve telescopic exterior section of the chimney and raise it so that its upper sect ion touches your ceiling. BE VERY CAREFUL AS YOU HANDLE THIS – THE EDGE S ARE EXTREMELY SHARP! 9) Take a pencil and mark out the po sition of the securing bracket (see above). It is best to stick the penc il through the final grille gap ...

  • Baumatic TECHNO - page 19

    18 Installing the Intake Silencer STEP 1: Find the grease filter grille up inside the cooker hood & remove it. STEP 2: Turn the two fastening lu gs (top left and bottom right of figure on left) anticlockwise to open the plate. STEP 3: Affixing the sile ncer to the inside of the plate just removed, put it up inside the opening. STEP 4: Check the ...

  • Baumatic TECHNO - page 20

    19 EXTRACTION OPERATION – Installation Instructions  Ensure that you have fitted the union (‘N’) to the upper part of the hood using the packaged t wo screws supplied inside the packing (Fig. 1 – on r ight). Using a 150 mm diameter pipe, connect the union (N) on the upper part of the hood (see Fig. 1) to the discharg e outlet for cooking ...

  • Baumatic TECHNO - page 21

    20 If something has gone wrong with your Cooker Hood, checking against this chart might keep you from having to call for service. Symptom Solution The cooker hood will not start! • Check that the hood is connected to the electricity supply. • Check that the fan speed control is set properly. The cooker hood is not working effectively! • The f ...

  • Baumatic TECHNO - page 22

    INSTRU CTION TO INS TALL CARBON FILTER 1. Unhook the metallic filter. 2. Take out the metallic filter by side of crossbar. ...

  • Baumatic TECHNO - page 23

    3.Put in the c arbon filter betw een crossbars, close the hole. 4. Lay the carbon filter on the hole, without fix ing it. ...

  • Baumatic TECHNO - page 24

    5. Put again the metallic filter. ...

  • Baumatic TECHNO - page 25

    Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Ba umatic appliance com es complete with a free 12 month guarantee cove ring bot h parts an d labour costs resulting from defective materials or workmanship. Baumatic also gives you the opportun ity to automatically extend the guarantee period for a further 12 months at no extra cost, gi ...

  • Baumatic TECHNO - page 26

    Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Advice Telephone +44 118 933 6933 E-mail : sales@baumatic.co.uk technical@b ...

  • Baumatic TECHNO - page 27

    ...

  • Baumatic TECHNO - page 28

    23 ...

Produzent Baumatic Kategorie Hoods

Dokumente, die wir vom Produzenten des Geräts Baumatic TECHNO erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Baumatic
- Bedienungsanleitungen TECHNO
- Produktkarten Baumatic
- Informationsbroschüren
- oder Energieetiketten Baumatic TECHNO
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Baumatic TECHNO.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Baumatic TECHNO, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Baumatic TECHNO. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Baumatic TECHNO ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Baumatic TECHNO, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Baumatic TECHNO hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Baumatic TECHNO verständlich ist.

Eine gänzliche Bedienungsanleitung von Baumatic sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Baumatic TECHNO bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Baumatic TECHNO befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Baumatic TECHNO, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Baumatic TECHNO - die uns die ersten Schritte während der Nutzung von Baumatic TECHNO erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Baumatic TECHNO hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Baumatic TECHNO im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Baumatic TECHNO?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Baumatic TECHNO nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Baumatic TECHNO hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)