Bedienungsanleitung Kyocera EcoLAN 3000E

20 Seiten 0.28 mb
Download

Zur Seite of 20

Summary
  • Kyocera EcoLAN 3000E - page 1

    Network Connectivity for Kyocera Printers Kyocera EcoLAN 3000E Quick Configuration Guide ...

  • Kyocera EcoLAN 3000E - page 2

    FCC Notice: This equipment complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. T rademarks Kyocera ® is a registered trademark of Kyocera Cor ...

  • Kyocera EcoLAN 3000E - page 3

    Content s Introduction ......................................................................... 4 Using the CD ROM ............................................................. 4 Supported Kyocera Printer Models ................................... 5 EcoLAN 3000E Hardware Inst allation ................................ 5 NetW are 2.x & 3.x Confi ...

  • Kyocera EcoLAN 3000E - page 4

    Introduction The EcoLAN 3000E is the next generation Kyocera internal network interface card allowing easy installation without removing the printer mainboard. Its features include: r Easy Slide-in Installation r Multiple Protocol Support r 10/100 Mbps Ethernet Interface r SNMP Support r 10BaseT / 100BaseT Auto Detection r Flash Upgrade Capability ...

  • Kyocera EcoLAN 3000E - page 5

    Supported Kyocera Printer Models The EcoLAN 3000E is compatible with the FS/LS-600, 680, 800, 1700+, 3700+, 5800C, 6700, 7000+, 9000 and any other Kyocera printer with the slide-in interface. The 3000E is compatible with the upper (hard disk) interface slot of an FS/LS-7000 with a Software version of 25.05 or later . The Software version is display ...

  • Kyocera EcoLAN 3000E - page 6

    6 NetW are 2.x & 3.x Configuration 1. Login as Supervisor and start PCONSOLE. 2. Define the Print Queue. ê If a Print Queue already exists that will be assigned to the 3000E, skip to step 3 ê Select Print Queue Information from the Available Options menu. ê Press INSERT , type a name for the new queue to be serviced by the 3000E and press EN ...

  • Kyocera EcoLAN 3000E - page 7

    7 NetW are 4.x & 5.x Directory Services Configuration NetW are Directory Services (NDS) configuration is accomplished using two utilities; 1) NetW ares NW Admin is used to define the required Directory Services objects, and 2) the 3000E parameters are configured with the Windows-based Management Access Program (MAP) if using IPX or with a we ...

  • Kyocera EcoLAN 3000E - page 8

    8 NetW are Directory Services Configuration continued... 3000E IPX Based Configuration IPX configuration is accomplished using the Management Access Program (MAP). 1. Install and Run MAP . ê Insert the CD included with the EcoLAN 3000E. ê In Windows 95, 98 or NT 4.0, click on Start and select Run , or in the Windows 3.1 or NT 3.51 Program Manager ...

  • Kyocera EcoLAN 3000E - page 9

    9 2. NetWare Configuration. ê Select Setup NetWare in the Protocols column. ê Enter the Print Server Name , Preferred NDS Context , and Print Server Password (if a password was defined) exactly as they were entered in NW Admin. Note: Entries are not case sensitive (except the sysadm pass- word). Preferred Bindery File Server and Preferred NDS T r ...

  • Kyocera EcoLAN 3000E - page 10

    10 Macintosh Configuration KPDL, Kyoceras PostScript compatible mode is required for Macintosh printing. KPDL is standard on many Kyocera printers, however , it is optional on the following models: FS-600, FS-680, FS-7000 and all LS (Japanese) models. If KPDL is installed, it will appear in the Emulation list in the following procedure and on th ...

  • Kyocera EcoLAN 3000E - page 11

    11 Inst alling the Driver and Selecting the Printer 1. The Macintosh LaserWriter Driver is installed from the CD provided with the printer . Insert the CD, open the Drivers folder , then the appropriate country folder , and double click on the FS-Series Installer program in the desired language. 2. Once installation is complete and your system has ...

  • Kyocera EcoLAN 3000E - page 12

    12 Windows Peer to Peer Printing Configuration Peer to Peer printing is available for Windows 95, Windows 98 and Windows NT 4.0. What is Windows Peer to Peer Printing? The peer to peer printing software which is included with the EcoLAN 3000E allows Windows PCs to communicate directly with network attached printers. A network server, such as NetW a ...

  • Kyocera EcoLAN 3000E - page 13

    13 IPX Printer Name: The IPX peer to peer printing software uses the NetW are Print Server Name to identify the 3000E. The default name is the serial number preceded by KYO, e.g., KYO_163495. If desired, this name can be changed to a more easily identifiable name with MAP . T o change the name, follow the MAP Configuration instructions in the NetWa ...

  • Kyocera EcoLAN 3000E - page 14

    Windows NT 4.0 Configuration There are several options for setting up printing in a Windows NT environment. u If a NetWare server is present, NetWare print services may be used by following the NetWare configuration instructions in this guide. u Peer to peer print services may be used by following the Windows Peer to Peer Printing instructions in t ...

  • Kyocera EcoLAN 3000E - page 15

    15 Configuring the Printer Driver for LPR Printing The printer driver should be installed from the CD which is shipped with the printer . Unfortunately , Windows does not make the Add LPR Port available to the Install Wizard on the CD. Therefore, the printer driver should be installed selecting a standard port such as LPT1. Once the driver installa ...

  • Kyocera EcoLAN 3000E - page 16

    16 DHCP Configuration (Dynamic Host Configuration Protocol) IMPORTANT: EcoLAN 3000E IP address assignment with DHCP will not work if the 3000E has an existing IP address and IP persistence is Permanent. DHCP provides a mechanism for delivering IP configuration parameters, including IP address, subnet mask, etc. to devices (hosts) on an IP network. ...

  • Kyocera EcoLAN 3000E - page 17

    17 WINS Configuration (Windows Internet Naming Service) WINS provides a mechanism for mapping NetBIOS (Windows) names to IP ad- dresses. WINS enables defining a printing configuration which references the printer by its name rather than by its IP address. Thus, even if the printer IP address is changed via DHCP , the printing configuration will sti ...

  • Kyocera EcoLAN 3000E - page 18

    18 UNIX Configuration UNIX printing utilizes a line printer daemon (lpd) to direct print jobs to the printer . The 3000E supports two modes of lpd printing, host-based lpd and printer-based lpd. With host-based lpd, the line printer daemon is run on one or more workstations (hosts) where print jobs are accepted and sent to the 3000E. With printer-b ...

  • Kyocera EcoLAN 3000E - page 19

    19 IP Address Setup with the Printer Front Panel Set the IP address and other 3000E parameters using the following procedure. Note: Setting the IP address with the front panel automatically sets IP Persistence to Permanent, that is, the IP address is maintained when the printer is turned off and on. 1. Press the MODE key . If the first line of the ...

  • Kyocera EcoLAN 3000E - page 20

    EcoLAN 3000E Quick Configuration Guide Re v . 1.0, June 1999 Part Number 8836056 Kyocera Corporation 2-14-9 T amagawadai, Set agaya W ard, T okyo 158 Japan Kyocera Communications Systems Co., Ltd. 2-14-9 T amagawadai, Set agaya W ard, T okyo 158 ww w .kccs.co.jp/ U.S.A. Kyocera Electronics, Inc. 2301-300 Cottontail Lane, Somerset, NJ 08873 www .kyo ...

Produzent Kyocera Kategorie Printer

Dokumente, die wir vom Produzenten des Geräts Kyocera EcoLAN 3000E erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Kyocera
- Bedienungsanleitungen EcoLAN 3000E
- Produktkarten Kyocera
- Informationsbroschüren
- oder Energieetiketten Kyocera EcoLAN 3000E
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Kyocera EcoLAN 3000E.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Kyocera EcoLAN 3000E, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Kyocera EcoLAN 3000E. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Kyocera EcoLAN 3000E ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Kyocera EcoLAN 3000E, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Kyocera EcoLAN 3000E hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Kyocera EcoLAN 3000E verständlich ist.

Eine gänzliche Bedienungsanleitung von Kyocera sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Kyocera EcoLAN 3000E bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Kyocera EcoLAN 3000E befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Kyocera EcoLAN 3000E, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Kyocera EcoLAN 3000E - die uns die ersten Schritte während der Nutzung von Kyocera EcoLAN 3000E erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Kyocera EcoLAN 3000E hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Kyocera EcoLAN 3000E im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Kyocera EcoLAN 3000E?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Kyocera EcoLAN 3000E nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Kyocera EcoLAN 3000E hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)