Bedienungsanleitung White Rodgers P200

14 Seiten 2.31 mb
Download

Zur Seite of 14

Summary
  • White Rodgers P200 - page 1

    P200 Programmable Thermostat Installation Instructions & User Guide Congratulations on the purchase of your White-Rodgers ™ thermostat! Save these instructions for future use! Questions? Contact White-Rodgers ™ customer service at 1-877-654-9394 For Installation Help 1- 877-654-9394 White-Rodgers.co m F F F F F Fo r In stallation Hel p Fo r ...

  • White Rodgers P200 - page 2

    1 1 1 A TTENTION: MERCUR Y NO TICE This product does not contain mercury . However , this product may replace a product that contains mercur y . Mercury and products containing mercury must not be discarded in household trash. Do not touch any spilled mercury. Wearing non-absorbent gloves, clean up any spilled mercury and place in a sealed containe ...

  • White Rodgers P200 - page 3

    2 3 A B C P art 1 Before Getting Started 1.1 Check package contents Open the package and verify that the follo wing items are included: • Thermostat wallplate (A) and cover (B) • 2 mounting screws and wall anchors (C) • Wire Labels • Installation Instructions and User Guide Before getting started, please review the following pre-installatio ...

  • White Rodgers P200 - page 4

    4 5 C AUX G E L Y W RC R P art 2 Remove Old Thermostat and Install New Thermostat Do not disconnect wires from the old thermostat until you label all the wires according to this manual. 2.1.1 After turning off power to your heating & cooling system, expose wallplate with wires and wire terminals. The required steps vary depending on your old th ...

  • White Rodgers P200 - page 5

    6 7 ✔ Ignore wire colors. There is no standard color code for thermostat wires. ✔ Ignore existing wire labels, if they are present. ✔ Use the pro vided labels to label/re-label the thermostat wires. ✔ The new labels must remain on the wires a t least until the installation process is complete. ✔ No two wires can have the same label. 2.2.1 ...

  • White Rodgers P200 - page 6

    8 9 If the OLD thermostat’ s terminal is wired into the wall and identifi ed by this letter… …Then label its wire with this letter: Y ou’ll need this informa tion further in the installation process! 2.2.2 Label each wire that comes out of the wall and attaches to terminals on the old thermostat. Use labels provided with your new thermosta ...

  • White Rodgers P200 - page 7

    10 11 B GAS ELEC CGOY W RH B RC 2.3.1 Detach the new thermostat’ s wallplate from the rest of the thermostat and position the wallplate on the wall according to the illustration below, passing the labeled wires through the wire hole in the center of the wallplate. 2.3.2 With the wallplate fl ush against the wall, mark mounting holes with a penci ...

  • White Rodgers P200 - page 8

    12 13 1. Open the thermostat cover door . 2. Set the FA N switch to AUTO . 3. Set the SYSTEM switch to COOL (to turn on cooling) or HEA T (to turn on heating). 4. Press RUN . System Switch Cool - air conditioning Heat - heating Off - system turned off Fan Switch On - fan always on for air circulation Auto - fan runs only when system provides Heatin ...

  • White Rodgers P200 - page 9

    14 15 Press the PRGM and RUN buttons simultaneously . Y ou will be prompted to ans wer 8 “Options” questions, shown below. As each option is presented: ✔ Use the buttons to answer each question. ✔ Use HOLD button to advance to the next question and the TIME button to return to the previous question. When you have answered all 8 questions, p ...

  • White Rodgers P200 - page 10

    16 17 3.4 T urn on power to y our heating and cooling system 1. Press the TIME button. The display will show the hour . – Using the buttons adjust the hour . 2. Press the TIME button. The display will show minutes . – Using the buttons adjust the minutes. 3. Press the TIME button. The display will show the day of the week . – Using the button ...

  • White Rodgers P200 - page 11

    18 19 Y ou can change the day , time period or tempera ture settings of the pre-programmed schedule. 1. Set the SY STEM switch to COOL (to program the cooling schedule), or to HEA T (to program the heating schedule). 2. Press the PRGM button. The start time and temperature of the fi rst weekday (Monday through Friday) time period (Morning) is disp ...

  • White Rodgers P200 - page 12

    20 21 Y ou can manually override the currently-programmed tempera ture indefi nitely . 1. Use the buttons to raise or lower the desired temperature. 2. When the desired tempera ture is displayed, press the HOLD button. “HOLD” will be displayed at the bottom of the screen. 3. The override will last until you cancel it. Cancel the override by pr ...

  • White Rodgers P200 - page 13

    22 23 When the thermostat displays OR you need to replace batteries with 2 new AA alkaline batteries. Default setting – no temperature adjustment 4.5 Change batteries Y our thermosta t was accurately calibrated a t the factory . However , if you would like the displayed temperature to read higher or lower than the actual temperature, you can adju ...

  • White Rodgers P200 - page 14

    24 25 Problem Possible Cause Action Snowfl ake 5-minute lockout No action needed: should icon blinking enabled to protect stop blinking after compressor 5 minutes No Heat, No Cool, Blown fuse / Replace fuse or reset or No Fan tripped circuit breaker breaker Furnace power T urn switch to ON switch to OFF Furnace blower Replace door panel compartmen ...

Produzent White Rodgers Kategorie Thermostat

Dokumente, die wir vom Produzenten des Geräts White Rodgers P200 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen White Rodgers
- Bedienungsanleitungen P200
- Produktkarten White Rodgers
- Informationsbroschüren
- oder Energieetiketten White Rodgers P200
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung White Rodgers P200.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen White Rodgers P200, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen White Rodgers P200. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts White Rodgers P200 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts White Rodgers P200, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von White Rodgers P200 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von White Rodgers P200 verständlich ist.

Eine gänzliche Bedienungsanleitung von White Rodgers sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von White Rodgers P200 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von White Rodgers P200 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich White Rodgers P200, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts White Rodgers P200 - die uns die ersten Schritte während der Nutzung von White Rodgers P200 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit White Rodgers P200 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von White Rodgers P200 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich White Rodgers P200?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit White Rodgers P200 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit White Rodgers P200 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)