Bedienungsanleitung Echo SRM-400

20 Seiten 0.38 mb
Download

Zur Seite of 20

Summary
  • Echo SRM-400 - page 1

    X750-002 74 0 X750216-0500 ECHO, INCORPORATED 400 Oakwood Road, Lake Zurich, Illinois 60047-1564 Phone : 847-540-8400 OPERATOR’S MANUAL ECHO TRIMMER/ BRUSHCUTTER SRM-400 W ARNING D ANGER READ INSTRUCTIONS CAREFULL Y AND FOLLO W RULES FOR SAFE OPERA TION. F AILURE T O DO SO COULD RESUL T IN SERIOUS INJUR Y . ...

  • Echo SRM-400 - page 2

    2 INTRODUCTION The ECHO Trimmer/Brushcutter, model SRM-400 is lightweight, high performance gasoline powered rotary trimmer which is designed for brushcutting, weed control and grass trimming in areas which are difficult to control by any other means. The trimmer is equipped with a safety shoulder harness, and the excellent balance characteristics ...

  • Echo SRM-400 - page 3

    3 SAFETY INSTRUCTIONS 1. Do Not operate the unit when you are fatigued. 2. Do Not operate if other people or animals are in the work area. 3. Do Not operate the unit without the shield correctly in position. 4. Do Not operate in a confined area. Carbon monoxide exhaust gas is highly poisonous. 5. Do Not operate the unit while you are smoking. 6. Al ...

  • Echo SRM-400 - page 4

    4 SRM-400 Dimension L × W × H cm 186 × 70 × 43 (73.2 in × 27.6 in × 16.9 in) Masses kg 9.9 (21.8 lb): without shoulder harness and cutter head Engine Type Air cooled two stroke single cylinder Displacement mL (cm³) 42.7 (2.6 cu in) Max revolution r/min 10,000 Carburetor Walbro diaphragm type WYK Ignition Flywheel magneto : CDI (Capacitor Dis ...

  • Echo SRM-400 - page 5

    5 ASSEMBLING DRIVE SHAFT • Stand engine uprignt on a level floor. • Loosen bolts at drive shaft end of the engine. • Fit drive shaft assembly ensuring that the drive shaft is correctly engaged. • Tignten bolts to fasten drive shaft assembly. WARNING DANGER NEVER START ENGINE WITHOUT DRIVESHAFT ASSEMBLY INSTALLED. THIS COULD RESULT IN SERIOU ...

  • Echo SRM-400 - page 6

    6 SHIELD Fit the shield on the gear housing and tighten screws with washers (Seven points) as shown. SHOULDER HARNESS • Fit the shoulder starp to the swivel hook, and adjust the length of starp and or the locaion clamps to maintain the cutter head parallel to the ground. Shoulder strap assembly Quick release latch Waist pad 2 4 5 6 7 3 1 Adjust e ...

  • Echo SRM-400 - page 7

    7 Oil 1 50 Gasoline GENERAL CHECK • Eneure that all nuts, screws and bolts installed are properly tightened. FUEL STATEMENT GASOLINE : Use 89 octane ( ) gasoline or gasohol known to be good quality. Gasohol may contain maximum 10% ethyl (grain) alcohol or 15% MTBE (methyl tertiary-butyl ether). Gasohol containing methyl (wood) alcohol is not appr ...

  • Echo SRM-400 - page 8

    8 OPERATING THE TRIMMER • Adjust handle to a convenient position for cutting as instructed on page 6. • Allow the engine to warm up at a fast idle for a few minutes. • Increase engine speed as necessary. • When mowing shrubs, weeds, or grass, swing the cutter head from right to left as you move forward. - Avoid striking any obstruction such ...

  • Echo SRM-400 - page 9

    9 WARNING DANGER DO NOT ALLOW EITHER PEOPLE OR ANIMALS INTO THE WORK AREA. ALWAYS WEAR SAFETY GOGGLES WHEN CUTTING. DRESS PROPERLY - AVOID LOOSE CLOTHING. WHEN GRASS OR WEEDS HAVE CLOGGED THE CUTTER HEAD AFFECTING NORMAL OPERATION, FIRST, STOP THE ENGINE AND THEN REMOVE THE DEBRIS. OPERATING INSTRUCTIONS (METAL BLADES and OPTIONAL NYLON LINE) Your ...

  • Echo SRM-400 - page 10

    10 INSTALLATION OF NYLON LINE HEAD(OPTION) Set the nylon line head to the drive shaft and tighten by turning as shown. CUTTING PROCEDURES Locking tool OPERATING INSTRUCTIONS NYLON LINE 1. Always use the end of the line for cutting. Forcing the cutter head too close to the work will result in reduced efficiency and broken line. 2. Maintain the line ...

  • Echo SRM-400 - page 11

    11 SHOULDER HARNESS • Install the harness over the both shoulders and adjust shoulder straps so that the quick release latch rests low on the right hand side. • Attach the trimmer/brushcutter to the harness by means of the quick release latch. • Make some practice sweeps as with a trimmer and readjust the harness as necessary for comfort and ...

  • Echo SRM-400 - page 12

    12 WARNING DANGER 1. SERIOUS INJURY MAY RESULT FROM THE IMPROPER USE OF STEEL BLADES. READ AND COMPLY WITH SAFETY INSTRUCTIONS LISTED IN THIS MANUAL. 2. THE EIGHT TOOTH BLADE IS DESIGNED SPECIALLY TO CUT WEED AND GRASS. TO AVOID INJURY DUE TO KICKBACK OR BLADE FRACTURE, DO NOT USE THIS BLADE TO CUT BRUSH OR TREES. 3. ECHO INC. WILL NOT BE RESPONSIB ...

  • Echo SRM-400 - page 13

    13 6. SHOULD THE BRUSHCUTTER BE OPERATED FOR AN EXTENDED PERIOD OF HIGH TEMPERATURES, THE GEAR BOX MAY BECOME VERY HOT. IF TOO HOT TO TOUCH, ALLOW THE UNIT TO COOL DOWN, CHECK THE LUBRICATION AS PER ‘MAINTENANCE’ AND CONTINUE TO OPERATE IF IN ORDER. 7. TO AVOID ENGINE DAMAGE, DO NOT RUN ON FULL THROTTLE WITHOUT LOAD. 8. DO NOT OPERATE THE BRUSH ...

  • Echo SRM-400 - page 14

    14 INSTALLING THE BLADE 1. The installation of the 8 tooth weed/grass blade (option) and the 80 tooth brush is exactly the same. Locking tool Box wrench TIGHTEN 3. Remove the nylon line line head, if fitted, by turning in a clockwise direction. 4. Install the blade ensuring that it is centered correctly on the fixing plate. 5. Fit the lower fixing ...

  • Echo SRM-400 - page 15

    15 HEAVY WEED CUTTING • Install the 8 tooth 20 cm (8 in) blade. (option) • Observing all precautions as listed in this manual, start the engine and using full throttle, swing the blade in an arc as you move forward slowly. The cutter rotates counter-clockwise and the debris will be pushed backwards so the work area will always be visible. SMALL ...

  • Echo SRM-400 - page 16

    16 MAINTENANCE AND CARE - ALWAYS KEEP THE UNIT CLEAN - Air filter Air cleaner cover AIR FILTER • Clean before using the unit. - Close choke. Disengage latch and remove air cleaner cover. - Remove air filter. - Brush off dust lightly or clean with compressed air. - Reinstall cover and engage latch. FUEL STRAINER • Check periodically. - Do not al ...

  • Echo SRM-400 - page 17

    17 CAUTION When strarting, idling adjustment speed should be adjusted not to rotate the cutting attachment. Correct idle speed is adjusted 2,900 to 3,100 r/min. Or 1/4 turn counter clockwise from the point the cutting attachment stops moving. When there is some trouble with the carburetor, refer to your distributor or dealer. Idle speed adjustment ...

  • Echo SRM-400 - page 18

    18 TR OUBLE SHOO TING Poor performance of the engine and/or trimming mechanism can normally be prevented by carefully following instructions. Poor performances can easily be corrected even by a beginner. When the engine does not function properly check the following three (3) points first. • Is engine compression adequate? • Is fuel system in g ...

  • Echo SRM-400 - page 19

    19 Fuel strainer clogged Clean. Fuel pipe clogged Clean. Suction insufficient Make sufficient. Strainer clogged Clean. Carburetor out of order Disassemble and check. C.D.I. module defective Remove and replace. Ignition coil defective Remove and replace. Wire connection defective Reconnect. High-tension cord connection Repair as necessary. defective ...

  • Echo SRM-400 - page 20

    20 Improper fuel used Use fuel with correct mixing ratio. Never use gasoline of poor quality. Spark plug defective (burnt) Replace. As cooling fins clogged, air Clean fins. does not pass well Excessive deposits in Disassemble and remove carbon. combustion chamber Plug damaged or fouled Replace or clean. Combustion poor due to Check wiring. defectiv ...

Produzent Echo Kategorie Trimmer

Dokumente, die wir vom Produzenten des Geräts Echo SRM-400 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Echo
- Bedienungsanleitungen SRM-400
- Produktkarten Echo
- Informationsbroschüren
- oder Energieetiketten Echo SRM-400
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Echo SRM-400.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Echo SRM-400, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Echo SRM-400. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Echo SRM-400 ansehen.

Die komplette Bedienungsanleitung des Geräts Echo SRM-400, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Echo SRM-400 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Echo SRM-400 verständlich ist.

Eine gänzliche Bedienungsanleitung von Echo sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Echo SRM-400 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Echo SRM-400 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Echo SRM-400, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Echo SRM-400 - die uns die ersten Schritte während der Nutzung von Echo SRM-400 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Echo SRM-400 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Echo SRM-400 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Echo SRM-400?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Echo SRM-400 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Echo SRM-400 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)