Bedienungsanleitung Pelco TW3004AR

20 Seiten 0.43 mb
Download

Zur Seite of 20

Summary
  • Pelco TW3004AR - page 1

    INST ALLA TION TW3004AR Active Receiver Four Channels for UTP T ransmission C1667M (6/06) ...

  • Pelco TW3004AR - page 2

    ...

  • Pelco TW3004AR - page 3

    C1667M (6/06) 3 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near ...

  • Pelco TW3004AR - page 4

    4 C1667M (6/06) Regulatory Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RADIO AND TELEVISION INTERFERENCE This ...

  • Pelco TW3004AR - page 5

    C1667M (6/06) 5 Description The TW3004AR is a four-channel active receiver that can receive live video over unshielded twisted pair (UTP) cable. The adaptive technology in the TW3004AR automatically adjusts the low , medium, and high frequency components of the video signal, allowing for the best possible video transmission. The adaptive technology ...

  • Pelco TW3004AR - page 6

    6 C1667M (6/06) PARTS OF THE RECEIVER v Figure 1. TW3004AR Parts  Rubber Feet (4): For placing unit on a fl at surface, such as a desk or shelf.  Status LEDs (4): Light red when there is no UTP video being received. Light green when there is UTP video being received. Flash amber when Coaxitron pan/tilt/zoom (PTZ) control commands are being r ...

  • Pelco TW3004AR - page 7

    C1667M (6/06) 7 Installation The following parts are supplied: 1 Universal power supply (Part #PS04-1502-0512G) 1 Wall clip with screws and washers 1 Power connector 2-pin 1 UTP mating connector 1 Screwdriver MOUNTING The TW3004AR receiver is 3 rack units high and can be mounted into a fi ber rack, onto a wall using a fiber wall mount kit or into ...

  • Pelco TW3004AR - page 8

    8 C1667M (6/06) USING A WALL CLIP To attach the TW3004AR receiver to a wall using the supplied wall clip, refer to Figure 2 and do the following: 1. Attach the wall clip to a wall using two screws (not supplied). 2. Slide the receiver into the clip until the two holes on the bottom of the receiver align with the two holes on the lower fl ange of t ...

  • Pelco TW3004AR - page 9

    C1667M (6/06) 9 SETTING THE DIP SWITCHES The factory default switch positions are shown in Figure 3. Switches 2-5 are set to auto and switch 1 is set to H mode. These settings ensure that the adaptive technology in the TW3004AR automatically adjusts the low, medium, and high frequency components of the video signal, allowing for the best possible v ...

  • Pelco TW3004AR - page 10

    10 C1667M (6/06) APPLICATIONS Y ou can connect the TW3004AR active receiver to transmitters, such as the TW3001P passive transceiver , and the TW3001A T active transmitter, and to Pelco UTP cameras, such as the CC3710/ CC3610 series. Although you can connect these products using an unshielded twisted pair Cat3 and Cat5 cable, Cat5e and Cat 6 are re ...

  • Pelco TW3004AR - page 11

    C1667M (6/06) 11 Figure 4 shows a TW3004AR connected to a UTP camclosure. Figure 4. TW3004AR Connected to a UTP Camclosure = = 12 VDC OR 24 V AC POWER SUPPLY GRAY WIRE BLUE WIRE UTP POWER FROM RK5000PS-3U CAMCLOSURE MONITOR MONITOR MONITOR MONITOR OR TW3004AR ...

  • Pelco TW3004AR - page 12

    12 C1667M (6/06) Figure 5 shows a TW3004AR connected to a UTP fi xed camera. Figure 5. TW3004AR Connected to a UTP Fixed Camera - + POWER FROM RK5000PS-3U 12 VDC OR 24 V AC POWER SUPPLY FIXED CAMERA UTP MONITOR MONITOR MONITOR MONITOR TW3004AR PIN 4 PIN 5 8 PINS (4-/5+) 10 PINS (5-/6+) OR ...

  • Pelco TW3004AR - page 13

    C1667M (6/06) 13 Figure 6 shows a TW3004AR connected to a UTP Spectra ® dome for Coaxitron PTZ control. Figure 6. TW3004AR Connected to a Spectra Dome 12 VDC OR 24 V AC POWER SUPPLY POWER FROM RK5000PS-3U OR TW3004AR COAXITRON VIDEO MONITOR SPECTRA UTP VC-UTP BOARD MATRIX ...

  • Pelco TW3004AR - page 14

    14 C1667M (6/06) Figure 7 shows a TW3004AR connected to a TW3001P passive transceiver . The TW3001P then connects to a non-UTP fi xed camera. Figure 7. TW3004AR Connected to a Single Passive Transceiver 12 VDC OR 24 V AC POWER SUPPLY TW3001P UTP POWER FROM RK5000PS-3U OR TW3004AR MONITOR MONITOR MONITOR MONITOR DIRECT CONNECTION FIXED CAMERA ...

  • Pelco TW3004AR - page 15

    C1667M (6/06) 15 Figure 8 shows a TW3004AR connected to a TW3032P passive transceiver . Figure 8. TW3004AR Connected to a 32-Channel Passive Transceiver 12 VDC OR 24 V AC POWER SUPPLY POWER FROM RK5000PS-3U TW3004AR MONITOR MONITOR OR MONITOR MONITOR FIXED CAMERA UTP TW3032P 1 2 34 5678 9 1 0 1 1 1 21 3 1 4 1 5 1 6 17 18 19 20 21 22 23 24 25 26 27 ...

  • Pelco TW3004AR - page 16

    16 C1667M (6/06) Figure 9 shows a TW3004AR connected to a TW3004P passive transceiver . The TW3004P then connects to a non-UTP fi xed camera. Figure 9. TW3004AR Connected to a 4-Channel Passive Transceiver 12 VDC OR 24 V AC POWER SUPPLY TW3004AR MONITOR MONITOR UTP POWER FROM RK5000PS-3U OR MONITOR MONITOR FIXED CAMERA TW3004P ...

  • Pelco TW3004AR - page 17

    C1667M (6/06) 17 Specifications ELECTRICAL Input Voltage 12 VDC or 24 VAC, 50/60 Hz Power Consumption 10 watts Wire T ype Unshielded twisted pair (24 AWG minimum) Wire Category Cat3 or better DC Loop Resistance 52 ohms per 1,000 ft (305 m) Differential Capacitance 19pF/ft max T ransient Immunity 300 W peak pulse power (8/20 US) Insertion Loss 72 d ...

  • Pelco TW3004AR - page 18

    18 C1667M (6/06) ...

  • Pelco TW3004AR - page 19

    PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FR/FT/FS Series fiber optic products and TW3000 Series unshielded twisted p ...

  • Pelco TW3004AR - page 20

    Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.com ISO 9001 United States | Canada | United Kingdom | The Netherlands | Singapore | Spain | Scandinavia | France | Middle East ...

Produzent Pelco Kategorie Pacemaker

Dokumente, die wir vom Produzenten des Geräts Pelco TW3004AR erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Pelco
- Bedienungsanleitungen TW3004AR
- Produktkarten Pelco
- Informationsbroschüren
- oder Energieetiketten Pelco TW3004AR
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Pelco TW3004AR.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Pelco TW3004AR, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Pelco TW3004AR. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Pelco TW3004AR ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Pelco TW3004AR, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Pelco TW3004AR hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Pelco TW3004AR verständlich ist.

Eine gänzliche Bedienungsanleitung von Pelco sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Pelco TW3004AR bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Pelco TW3004AR befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Pelco TW3004AR, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Pelco TW3004AR - die uns die ersten Schritte während der Nutzung von Pelco TW3004AR erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Pelco TW3004AR hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Pelco TW3004AR im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Pelco TW3004AR?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Pelco TW3004AR nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Pelco TW3004AR hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)