Bedienungsanleitung Shark S1215C

19 Seiten 8.74 mb
Download

Zur Seite of 19

Summary
  • Shark S1215C - page 1

    REPLACEMENT PAR TS IMPORT ANT SAFETY INSTRUCTIONS NAME OF EACH P ART PREPARA TION BEFORE USE USING THE VACUUM CLEANER USING THE A TTACHMENTS EMPTYING THE DUST COMP ARTMENT CLEANING THE FILTERS CLEARING BLOCKAGES IN THE SUCTION HOSE AND CLEANING THE AGITA TOR ASSEMBLY REPLACEMENT INSTRUCTIONS TROUBLESHOOTING LIMITED WARRANTY Contents 1 3 4 6 8 9 10 ...

  • Shark S1215C - page 2

    ...

  • Shark S1215C - page 3

    IMPORT ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - T o reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use ...

  • Shark S1215C - page 4

    16. Do not touch the agitator while it is spinni ng. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pul l it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth wh ich lo oks as though they may cause the hose to become bl ocked. 20. Do not clean or store the vacuum cl eaner in ...

  • Shark S1215C - page 5

    Set the O N/OFF switch to " ON " to light the headlight. 3 NAMES OF EACH P ART W ARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Cleaning Utensil Headlight Handle Suction Hose A Dust Compartment Carrying Handle Duster Kno b ON/OFF Switch Release Button A Release Button B Release Button C Suction Hose ...

  • Shark S1215C - page 6

    Caution : Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the ha ndle PREP ARA TIONS BEFORE USE Attaching th e suction hose A & attachments 4 1 2 Set the vacuum cleaner to the upright position. lnsert the handle as shown in the illustration. Handle Wa nd Crevice T ool Upholstery T ool & Dusting B ...

  • Shark S1215C - page 7

    R E L E A S I N G T H E P O W E R C O R D S e c u r e t h e p o w e r c o r d p l u g o n t h e p o w e r c o r d . 1 1 2 2 5 PREPARATIONS BEFORE USE W I N D I N G T H E P O W E R C O R D H o o k t h e p o w e r c o r d o v e r t h e c l i p w h i c h is lo c a t e d on t h e u p p e r co r d s t o r a g e h o o k a s s h o w n . W i n d t h e po w ...

  • Shark S1215C - page 8

    ON/OFF Switch 6 USING THE V ACUUM CLEANER ON/OFF SWITCH Start or st op vacuum cleaner by pushing on the swi tch. ADJUSTING THE HANDLE Upright po sition The handle is normally locked in this The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel. Place your foot on handle release lever as shown and pull bac ...

  • Shark S1215C - page 9

    1 2 RUG/FLOOR (T OOLS)SELECTOR The RUG/FLOOR(TOOLS)selector should only be adjusted while the vacuum cleaner is turned on and in the upright position. When cleaning a rug or carpet,first turn the ON/OFF switch to the ON position,and then set the RUG/ FLOOR(TOOLS)selector to the RUG position. When cleaning a bare floor or when using one of the attac ...

  • Shark S1215C - page 10

    Caution: When using one of the attachments during cleaning,set the vacuum cleaner to the upright position. 1 2 3 USING THE A TT ACHMENTS Press the release button C to disconnect the handle from the vacuum cleaner . Remove the attachments from the vacuum cleaner. Caution: When removing the attachments, pull them in the directions shown in the illust ...

  • Shark S1215C - page 11

    1 3 2 4 1 2 1 3 2 4 1 2 Trapdoor Projection Groove Release Lever Duster Handle Turn the duster handle several times in the direction shown to empty the dust compartment. EMPTYING THE DUST COMP ARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning. Empty ...

  • Shark S1215C - page 12

    Remove the dust compartment.(refer to page 9) Clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter Dust Compartment Ribs Main Filter 1 1 CLEANING THE FIL TERS 2 Set the dust compartment to the parallel position.Open the trapdoor,then push the release button E and pull out the main filter. 3 Clean the main f ...

  • Shark S1215C - page 13

    Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect Cleaning the agitator assembly 1 2 3 CLEARING BLOCKAGES AND CLEANING THE A GIT A T OR ASSEMBL Y the power cord from the wa ll outlet before clearing any blockages in the suction hose and cleaning th e agitator assembly . Cleaning blockages Remove the bottom pl ...

  • Shark S1215C - page 14

    REPLACING THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below . 1 Set the vacuum cleaner to the parallel position. 2 Loosen the screws to remove the lens. 3 When removing the headlight lamp, be ...

  • Shark S1215C - page 15

    Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 Bearing Holder Groove Nozzle Head REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the O N/OFF swit ch to the"OFF" position and disconnect the po wer cord fro m the wall outlet before repla cing an y of the parts be low . REPLACING THE FLA T BEL T Remove the bottom plate. ( ...

  • Shark S1215C - page 16

    14 2 4 1 3 1 2 3 REPLACEMENT INSTRUCTIONS REMOVING THE BOTT OM PLA TE Set the vacuum cleaner to the parallel position and turn it over . Slide the latch in the direction of the arrow. Remove the bottom plate by pulling the tabs as illustrated. REA TT ACHING THE BOTT OM PLA TE Insert the projection on the bottom plate into the groove on the nozzle h ...

  • Shark S1215C - page 17

    Caution: Be sure that seal on the HEPAfilter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down. 3 Insert a new HEPAfilter with the seal to the inside of the vacuum cleaner. Reattach the filter cover. Caution: Always replace the old filter with a ...

  • Shark S1215C - page 18

    9BF-D-P11 1-00722 0308- If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord f ...

  • Shark S1215C - page 19

    Model S1215C FIVE ( 5 ) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this p roduct to be fr e e from defects in material and workmanship for a period of five ( 5 ) year s from the date of the original purcha s e when utilized for normal commercial or household use, subject to the following conditions, exclusions and exceptions. Should your ...

Produzent Shark Kategorie Vacuum Cleaner

Dokumente, die wir vom Produzenten des Geräts Shark S1215C erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Shark
- Bedienungsanleitungen S1215C
- Produktkarten Shark
- Informationsbroschüren
- oder Energieetiketten Shark S1215C
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Shark S1215C.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Shark S1215C, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Shark S1215C. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Shark S1215C ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Shark S1215C, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Shark S1215C hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Shark S1215C verständlich ist.

Eine gänzliche Bedienungsanleitung von Shark sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Shark S1215C bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Shark S1215C befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Shark S1215C, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Shark S1215C - die uns die ersten Schritte während der Nutzung von Shark S1215C erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Shark S1215C hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Shark S1215C im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Shark S1215C?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Shark S1215C nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Shark S1215C hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)