Bedienungsanleitung NewerTech miniStack

24 Seiten Betrifft nicht
Download

Zur Seite of 24

Summary
  • NewerTech miniStack - page 1

    Owner ’ s Guide & Assembly Manual ...

  • NewerTech miniStack - page 2

    Newer T echnology miniStack T able of Contents 1 INTRODUCTION 1.1 SYSTEM REQUIREMENT S 1.1.1 Mac Requirements 1.1.2 PC Requirements 1.1.3 Supported Hard Drives 1.2 P ACKAGE C ONTENTS 1.3 USING THE NEWER TECHNOL OGY MINIST ACK 1.3.1 Connecting the Newer T echnology miniStack 1.3.2 Po wering on the Newer T echnology miniStack 1.3.3 LED Indicator 3 FO ...

  • NewerTech miniStack - page 3

    Newer T echnology miniStack Chapter 1 - Introduction 1 INTRODUCTION 1.1 System Requiremen ts 1.1.1 Mac Requirements •Minimum PowerPC G4 CPU , 128MB RAM •eSA T A interface - Mac OS X 10.3 or later •Fir eWire® int er face - Mac OS X 10.2 or later •USB 2.0 interface - Mac OS X 10.2 or later •USB 3.0 interface - see your interface card manuf ...

  • NewerTech miniStack - page 4

    Newer T echnology miniStack Chapter 1 - Introduction Cable Connections: The Newer T echnology miniStack has multiple inter faces to work with any computer system. ➀ On/O Switch - T urn the Newer T echnology miniStack on and o here . ➁ DC IN port - Plug the included DC power transformer here . ➂ USB 3.0 Port - Connect one of your compute ...

  • NewerTech miniStack - page 5

    Newer T echnology miniStack Chapter 2 - System Setup 2 SY STEM SETUP This guide will get you up and running quickly , demonstrating how to install your own drive int o the Newer T echnology miniStack enclosure. Y our computer is a static-sensitive device . It is susceptible to invisible damage if not protected during installation. W e recommend pro ...

  • NewerTech miniStack - page 6

    ➀ Newer T echnology miniStack Chapter 2 - System Setup 2.1 Hard Drive Assembly & Installation Remove the Newer T echnology miniStack from the box. Y ou will notice that there is a clear protective plastic sheet attached t o the top of the enclosure. T urn the Newer T echnology miniStack over placing the t op on a soft work surface, such as a ...

  • NewerTech miniStack - page 7

    ➂ ➃ T urn the miniStack over and place the bott om on the work surface. Lift the top cover o of the miniS tack, exposing the internal chassis. Untape the plastic bag with assembly screws from the inner chassis . Make sure that the hard drive y ou wish to install (sold separately) is handy and remove the scr ews from the bag. ...

  • NewerTech miniStack - page 8

    ➅ ➄ Place your drive int o the chassis of the miniStack. T here are 2 rubber coated mounting tabs with screwholes on the side closest t o you in this photograph, and a tab with a plastic detent on it that will lock the driv e into the chassis on the center of the drive on the opposite side . Y ou will need to set the drive into this detent in t ...

  • NewerTech miniStack - page 9

    ➆ ➇ T urn the enclosure over on to it’ s top again on a sof t work surface. Use the remaining 2 Phillips screw s from the plastic bag and insert them into the center of the driv e enclosure above the Newer T echnology label, securing the hard drive into the chassis . Replace the 4 Phillips screws that y ou removed initially t o secure the top ...

  • NewerTech miniStack - page 10

    Newer T echnology miniStack Chapter 3 - F ormatting 3 FORMA TTING 3.1 Forma tting your New er T echnology miniStack on a Macin- tosh with OS X (F or a new drive , or to reforma t an old drive) If you are not formatting a brand new har d drive, you will ha ve to manually Open Disk Utility, which is f ound in your /Applications/Utilities folder . Sel ...

  • NewerTech miniStack - page 11

    Once you ’ve selected the Newer T echnology device, you will notice the above change in the Disk Utility application. Click on the “P artition” tab in this picture. Y ou then need to choose how many partitions you wish your Newer T echnology miniStack to have. F or ease of use we’ re selecting one par tition here but of course you c ould se ...

  • NewerTech miniStack - page 12

    Newer T echnology miniStack Chapter 3 - F ormatting ➃ ➀ Choose a name for the volume . Y ou will need to repeat this step f or each volume if you selected multiple partitions. ➁ Click on the Customize button and the f ollowing dialog box will appear: Choose the partition scheme appropriate for your computer; most will choose GUID Partition T ...

  • NewerTech miniStack - page 13

    Newer T echnology miniStack Chapter 3 - F ormatting Once the formatting proc ess has completed, you will ha ve a popup box appear asking if you wish to use the new device as a Time Machine volume . This is up to you to decide; if y ou don ’t want to make that decision right now , you can click “Decide Later” and use the Time Machine pref eren ...

  • NewerTech miniStack - page 14

    Newer T echnology miniStack Chapter 3 - F ormatting 2.2 Removing the GUID Partition Scheme Only for XP , 2000, ME and earlier. (XP 64-BIT , Vista & Windows 7 can continue t o the next section) ➆ T ype exit and hit enter . ➇ Close the command prompt window . Y ou ma y now proceed with f ormatting the drive . If you are not installing a brand ...

  • NewerTech miniStack - page 15

    Newer T echnology miniStack Chapter 3 - F ormatting 2.3 Forma tting your New er T echnology miniStack on W indows 2000 and later Instructions for other operating systems can be found at http://www.newertech.com/format . ① With the miniStack connected to the computer and pow ered on, right-click on the “My Computer” (“Comput er ” if runnin ...

  • NewerTech miniStack - page 16

    Newer T echnology miniStack Chapter 3 - F ormatting ④ Your drive will appear similar to how Disk 1 does below. Notice that the space on the lower right reads as “Unallocated.” Right click in this space and choose “New Partition.” ⑤ The “New Parti - tion Wizar d” will launch. Click “Next” to continue. ⑥ Specify your partition t ...

  • NewerTech miniStack - page 17

    Newer T echnology miniStack Chapter 3 - F ormatting ⑧ If you like, you can specify the drive letter designation f or your new drive . Other wise, one will automatically be assigned. Click “Next. ” ⑨ Before y ou can use the drive, it must be formatted . On most systems run- ning Window s 2000 or later , it is advisable to specify the le s ...

  • NewerTech miniStack - page 18

    Newer T echnology miniStack Chapter 3 - F ormatting ⑪ Once you hav e nished with the formatting wizard , you will see that your new drive (represent ed as “Disk E” in this case) will display a message of “F ormatting. ” This should only take a couple of min- utes if you chose the quick format option. ⑫ After a moment or two, the driv ...

  • NewerTech miniStack - page 19

    Newer T echnology miniStack Chapter 3 - F ormatting ⑬ At this point, you ma y close the Computer Management win - dow . Y our driv e is ready to use and can be found in “My Computer . ” Using your new St orage Solution on both Macs and PCs? MacDrive™ takes the guessw ork out of shar ing les . Whether you are transf er - ring les betwe ...

  • NewerTech miniStack - page 20

    Newer T echnology miniStack Chapter 4 - Troubleshooting & Tips 4 TROUBLESHOO TING & TIPS 4.1 T roubleshooting Some of the most simple problems can be traced to pow er or connectivity issues. V erify that your cables (both ends!) are pr operly plugged into the computer and storage solution. If they are , and the storage solution is still not ...

  • NewerTech miniStack - page 21

    Newer T echnology miniStack Chapter 5 - Appendix 5.1 F AQ Q: How do I format m y storage solution? A: OWC has detailed instructions online for most popular operating sys - tems, located at: http://www.newertech.com/format Q: What le system should I choose when f ormatting my drive? A: This will depend on how you wan t to use the drive, but in ge ...

  • NewerTech miniStack - page 22

    • Review Chapter 4: T roubleshooting & T ips. •T ry to conrm the problem is with the solution. If you have a second computer , move the miniStack solution to that system and v erify that the solution does not function with that machine. •Visit our tech cen ter for more support suggestions, including F AQs . http://eshop.macsales.com/Se ...

  • NewerTech miniStack - page 23

    ...

  • NewerTech miniStack - page 24

    Copyright ®2005-12 Newer T echnology All R ights Reserved. Newer T echnology ’ s Limited Warranty is not transferable and subject to limitations . Copyrights: Copyright © 2005-2012 Newer T echnology , Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any f orm or by any mean ...

Produzent NewerTech Kategorie External Hard Drive

Dokumente, die wir vom Produzenten des Geräts NewerTech miniStack erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen NewerTech
- Bedienungsanleitungen miniStack
- Produktkarten NewerTech
- Informationsbroschüren
- oder Energieetiketten NewerTech miniStack
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung NewerTech miniStack.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen NewerTech miniStack, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen NewerTech miniStack. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts NewerTech miniStack ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts NewerTech miniStack, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von NewerTech miniStack hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von NewerTech miniStack verständlich ist.

Eine gänzliche Bedienungsanleitung von NewerTech sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von NewerTech miniStack bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von NewerTech miniStack befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich NewerTech miniStack, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts NewerTech miniStack - die uns die ersten Schritte während der Nutzung von NewerTech miniStack erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit NewerTech miniStack hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von NewerTech miniStack im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich NewerTech miniStack?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit NewerTech miniStack nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit NewerTech miniStack hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)