Bedienungsanleitung Intel IXP12xx

17 Seiten 0.13 mb
Download

Zur Seite of 17

Summary
  • Intel IXP12xx - page 1

    IXP12xx ATM OC12/Ethernet IP Router Example Design Performance and Headroom Analysis April, 2002 Document Number: 301144-001 ...

  • Intel IXP12xx - page 2

    Version 1.0 , 4/10/02 Page 2 of 17 Information in this document is provided in connection with Intel products. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document. Except as provided in Intel’s Terms and Conditions of Sale for such products, Intel assumes no li ability whatsoev ...

  • Intel IXP12xx - page 3

    Version 1.0 , 4/10/02 Page 3 of 17 IXP12xx ATM OC12/Ethernet IP Router Example Design Performance and Headroom Anal ysis OVERVIEW This documents details the performance and h eadroom analysis done on the IXP12xx ATM OC12 / Ethernet IP Router Example Design. It covers the general performance aspects of the protocols; cycle and instruction budgets; t ...

  • Intel IXP12xx - page 4

    Version 1.0 , 4/10/02 Page 4 of 17 KEY WORKLOADS & APPROACHES TO TESTING THE EXAMPLE DESIGN Protocol Performance of IP over ATM vs. Ethernet Figure 1 details the protocol processing required to carry an IP packet over ATM and Ethernet. . Figure 1 – Protocol Processing Figures 2 and 3 show that as the size of the IP packet varies so do the eff ...

  • Intel IXP12xx - page 5

    Version 1.0 , 4/10/02 Page 5 of 17 The result is that ATM is significantly more effici ent that Ethernet in terms of Mbps for carrying very small PDUs. Every Mbps of single-cell- PDUs on the ATM link requires (84/55) Mbps on the matching Ethernet link(s). 0 16 32 48 64 80 96 112 12 8 14 4 16 0 17 6 02 0 4 0 6 0 8 0 1 0 0 1 2 0 1 4 0 I P P a c ke t ...

  • Intel IXP12xx - page 6

    Version 1.0 , 4/10/02 Page 6 of 17 As shown graphically in Figure 3, 622Mbps of single- cell-PDU input requires 622*(84/55) = 949 Mbps of Ethernet output. This example design supplies 800Mbps of Ethern et bandwidth (IXP1240 configurations), so under a single cell/PDU workload the design can be e xpected to transmit Ethernet at line rate, and to dis ...

  • Intel IXP12xx - page 7

    Version 1.0 , 4/10/02 Page 7 of 17 bytes/minimum frame}. 84 bytes/frame * 8 bits/byte / 100Mb/sec = 6.72 usec/frame. 232MHz * 6.72 usec/frame = 1559 cycles/frame These cycle budgets specify how frequently a cell or frame goes over the wire. If multiple threads handle multiple frames on the same wire, then the budgets are multiplied accordingly. For ...

  • Intel IXP12xx - page 8

    Version 1.0 , 4/10/02 Page 8 of 17 One issue with running simulations unbounded to wi re-rate is that it can hide errors because there is no concept of device overflows or underflows. Further the design can become un-balanced, say for example if an efficient receiver races ahead of the rest of the design, hogging shared system resources and potenti ...

  • Intel IXP12xx - page 9

    Version 1.0 , 4/10/02 Page 9 of 17 Both the OC-12 and 4xOC-3 configurations experi ence an ATM overflow after 1M cycles. This indicates that under this system workload, the r eceiver is not keeping up with the wire, but has dropped a cell in the first 6,000 cells. Simulated 40-byte and 1500-byte packet perform ance 2 The OC-12 and 4xOC-3 configurat ...

  • Intel IXP12xx - page 10

    Version 1.0 , 4/10/02 Page 10 of 17 the number of times the PHY was not fed a cell in time to keep the wire busy, and thus had to manufacture an idle cell. The number reported here is from the 2 nd counters query when 2 “_VolgaGetChanCounters” are issued on the same line at the VxWorks prompt (this is because “_VolgaGetChanCounters” prints ...

  • Intel IXP12xx - page 11

    Version 1.0 , 4/10/02 Page 11 of 17 degrade in these scenarios, a nd the design becomes subject to ATM overflows from running “_VolgaGetChanCounters”. Ethernet Input Ports ATM Transmit Rate [%] IXF6012 Transmit Idle ATM Receive Ports IXF6012 Overflows Ethernet Transmit KFrame/s Ethernet Transmit [MB/s] 8 84 N/A 1 0 138 - 147 8.8 – 9.4 7 73 N/ ...

  • Intel IXP12xx - page 12

    Version 1.0 , 4/10/02 Page 12 of 17 Ethernet Input Ports ATM Transmit Rate [%] IXF6012 Transmit Idle ATM Receive Ports IXF6012 Overflows Ethernet Transmit KFrame/s Ethernet Transmit [MB/s] 8 100 0 1 0 88,300 5.6 Figure 8 – Two-cell/PDU Perfor mance on 143MHZ DRAM Using 143 MHz DRAM, the 40-byte (2-cell/PDU) wo rkload perform ed perfectly, even wi ...

  • Intel IXP12xx - page 13

    Version 1.0 , 4/10/02 Page 13 of 17 Queue to Core Measurement Technique The performance of the queue-to-core path can be measured by modifying a nominal input data stream such that the entire stream is forwarded to core. For example, changing the IP version in the IP header from 4 to 5 will cause the packets to be forwarded to the core. The lab equ ...

  • Intel IXP12xx - page 14

    Version 1.0 , 4/10/02 Page 14 of 17 RESOURCE UTILIZATION AND HEADROOM ANALYSIS This section details system resource utilization, including per-microengine resources such as registers and microstore instructions; as well as shared resources such as Scratchpad RAM, SRAM, and DRAM. The memory utilization is shown using the default system memory map as ...

  • Intel IXP12xx - page 15

    Version 1.0 , 4/10/02 Page 15 of 17 Microstore utilization can be observed by openi ng a microengine list window with line num bers enabled, and recording the last line number plus 1. A vailable instructions = 2048 – used instructions. Figure 12 shows the results for each of the three configurations. The CRC Check and CRC Generate microengines ap ...

  • Intel IXP12xx - page 16

    Version 1.0 , 4/10/02 Page 16 of 17 SDRAM Capacity The IXM1240 Network Processor Base Card comes with 128MB of SDRAM. The project is configured to use less than 64MB: 32MB of Packet Data Buffers, 16MB for VxWorks, and the balance for IP Route Table Entries. This leaves over 50% available. The IP Route Table Entries live at 0x8100, simp ly because t ...

  • Intel IXP12xx - page 17

    Version 1.0 , 4/10/02 Page 17 of 17 APPENDIX Buffer Allocation in DRAM The microengines in this example design uses two DRAM command queues. The ordered queue is used by all sdram_crc[] commands to transfer packet data between DRAM and the receive and transmit FIFOs. The priority queue is used for all other microengine DRAM accesses, including acce ...

Produzent Intel Kategorie Network Router

Dokumente, die wir vom Produzenten des Geräts Intel IXP12xx erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Intel
- Bedienungsanleitungen IXP12xx
- Produktkarten Intel
- Informationsbroschüren
- oder Energieetiketten Intel IXP12xx
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Intel IXP12xx.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Intel IXP12xx, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Intel IXP12xx. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Intel IXP12xx ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Intel IXP12xx, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Intel IXP12xx hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Intel IXP12xx verständlich ist.

Eine gänzliche Bedienungsanleitung von Intel sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Intel IXP12xx bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Intel IXP12xx befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Intel IXP12xx, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Intel IXP12xx - die uns die ersten Schritte während der Nutzung von Intel IXP12xx erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Intel IXP12xx hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Intel IXP12xx im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Intel IXP12xx?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Intel IXP12xx nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Intel IXP12xx hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)