Deutsch dropdown-ico

Bedienungsanleitung Sumo SL001

32 Seiten 1.21 mb
Download

Zur Seite of 32

Summary
  • Sumo SL001 - page 1

    Sumo Robots T wo Robot Sumo W restlers with Artificial Intelligence SL001 Instructions Read and save these instructions. ...

  • Sumo SL001 - page 2

    ...

  • Sumo SL001 - page 3

    T able of Contents W arnings ................................................................................... 5 Important Battery Information .................................................... 6 Battery Installation ..................................................................... 7 Overview ................................................ ...

  • Sumo SL001 - page 4

    W arnings T roubleshooting ....................................................................... 25 Care and Maintenance ............................................................ 27 Specifications ........................................................................... 27 Statement of FCC Compliance ........................................ ...

  • Sumo SL001 - page 5

    • Do not expose units to water or moisture. • Do not expose units to extreme temperatures from any source. • Do not drop or subject the units to excessive force or shock. W arnings 5 ...

  • Sumo SL001 - page 6

    • Do not mix old and new batteries. • Do not mix Alkaline, standard (Carbon Zinc) or rechargeable (Nickel-Cadmium) batteries. • Use only batteries of the same or equivalent type as recommended. • Due to small parts, an adult should install and replace batteries. • Insert batteries, observing proper +/– polarities. • Do not short-circu ...

  • Sumo SL001 - page 7

    Remote Control 1. Ensure the power switch is in the OFF position. 2. T o open the battery compartment on the remote control, remove the screw using a Phillips screwdriver (not included), then lift off the cover . 3. Install 3 AAA batteries (purchase separately) into the battery compartment, observing proper +/– polarities as indicated. 4. Replace ...

  • Sumo SL001 - page 8

    Note: If remote control battery power is weak, the power LED indicator flashes. Replace the batteries. Charger 1. T o open the battery compartment on the charger , remove the screw using a Phillips screwdriver (not included), then lift off the cover . 2. Install 3 AA batteries (purchase separately) into the battery compartment, observing proper +/ ...

  • Sumo SL001 - page 9

    Overview Inspired by Sumo wrestling , the goal of the game is to push your robot Sumo opponent out of the Dohyo ring . Players use the infrared remote controls to execute various offensive or evasive maneuvers against an opponent, or a robot’s artificial intelli - gence. Advanced players may test their skill by creating exciting new user-define ...

  • Sumo SL001 - page 10

    Remote Control Operation The remote controls drive two-player (two -player mode) and one player vs. artificial intelligence (one-player mode). Note: During A.I. (artificial intelligence) mode, all remote- control functions are deactivated. 1. T o use a remote control, after battery installation, the unit must be calibrated. 2. T o calibrate a rem ...

  • Sumo SL001 - page 11

    T o pe rfo rm in div id ual c omm an ds an d p re pro gra mm ed ma neu ve rs wi th th e r emo te co nt rol , use t he re fer enc e cha rt be lo w . 11 Features Description ACTION 1 • Single click — F ront of Robot moves towards the other one. • Double click — Back of Robot moves to - wards the other one. ACTION 2 (Level 2) • Single click ...

  • Sumo SL001 - page 12

    ON/OFF • P owers the remote control on and off . A TT ACK 1 • Prote ctiv e Sh ell — R epe ls o ppo nent aw ay w ith the Doh yo b arr ier . N o di rec tion al limi tat ion. A TT ACK 2 • Thunder Shot — Opponent loses control and shakes. A TT ACK 3 • Laser Beam — An attack to the challenger behind you. Opponent is repelled away from you. ...

  • Sumo SL001 - page 13

    Commands and Maneuvers 13 ...

  • Sumo SL001 - page 14

    F ive LEDs on the front of each robot indicate matches played and won. The first to win 3 out of 5 matches wins the game. 1. During the first match, the far left LED on both robots blinks green and red. This indicates the match is in play . 2. When the match is finished, the LED blinks green on the winning robot and red on the losing robot. 3. S ...

  • Sumo SL001 - page 15

    A full charge yields approximately 5-6 minutes of robot action. A low battery is indicated when the robot’s second and fourth LED blink rapidly . 1. Before charging , ensure the robot is switched off. 2. Place the robot on the charger . The front of the robot aligns with the front of the charger . 3. Ensure two power connectors, two wheel slots a ...

  • Sumo SL001 - page 16

    The Dohyo is a bordered circular area where game matches are played. A match is won or lost when a robot is pushed out of the Dohyo. F or best results, always keep the Dohyo surface clean and level. Any debris on the surface may impair the robot’s localization system and cause a malfunction. F or added stability , we recommend taping down the out ...

  • Sumo SL001 - page 17

    There are three ways to play the game: • T wo player (two-player mode) • One player vs. artificial intelligence (one-player mode) • Artificial intelligence vs. artificial intelligence (demonstration mode) Robots “learn ” and retain tactical strategies in memory as moves are employed during a game. The more moves you use, the more skill ...

  • Sumo SL001 - page 18

    1. T o s ele ct two-p lay er mod e, ens ure ea ch rob ot is s et to a c or - res pon din g r emo te con tro l f req uen cy . F or e xam ple , s ele ct R/C 1 to con tro l a ro bot wi th the re mot e s et to CHA NNEL 1 ; se lec t R/C 2 t o c ont rol a rob ot wit h t he rem ote se t to CH ANN EL 2 . 2. Place the robots in the shaded area of the Doyho, ...

  • Sumo SL001 - page 19

    1. T o play a game in demonstration mode, slide the switch located on the back of both robots to the A.I. (Artificial Intel - ligence) setting . 2. Place the robots in the shaded area of the Doyho, facing each other . Infrared communication begins immediately . F ive green LEDs on each robot blink to indicate a countdown sequence. The robots begin ...

  • Sumo SL001 - page 20

    1. T o select one -player mode, ensure one robot is set to a corre- sponding remote- control frequency . For example, select R/C1 to control a robot with the remote set to CHANNEL 1 . 2. Ensure the second robot is set to A.I. mode. 3. Place the robots in the shaded area of the Doyho, facing each other . 4. T o activate the A.I. robot, lift it up an ...

  • Sumo SL001 - page 21

    8. T o begi n the n ext ma tch, l ift up and s et dow n the robots facin g each other in the shade d area of the Doyho . Repe at ste p 5. 9. T o start a new game and clear the previous record, press and hold the ST ART/STOP button for two seconds. Red LEDs on each robot flash. Stunt Action Upgrade Y ou can create your own unique stunt action code ...

  • Sumo SL001 - page 22

    Barcode Reader Barcode Reader Stand Stunt Action Barcode 22 ...

  • Sumo SL001 - page 23

    Barcode Upload 1. Feed the barcode strip through the barcode reader stand, ensuring the paper lays flat and straight in the reader . 2. Slide the strip through until barcode is entering the reader ’s focal point. 3. Secure the Barcode Reader Stand on top of the charger . 4. Secure the robot on top the Barcode Reader Stand. 5. Slide the PLAY MODE ...

  • Sumo SL001 - page 24

    6. Pull the barcode through the stand, according to arrow direc- tion, at a slow , steady rate, taking no more than five seconds. The robot operates silently while scanning the code. 7. When the upload is complete, the robot sounds. If a sound is not heard, the upload process was unsuccessful. 8. T o restart, switch the robot off , then on. Begin ...

  • Sumo SL001 - page 25

    Problem Cause Solution Robot does not respond or responds poorly to remote control. • Infrared signal weak - ened by sunlight or other bright light source. • Out of operating range. • Interference with infrared signal. • Move away from light source. • Ensure remote is within 4 1 ⁄ 2 feet of robot. • Recalibrate remote control output. ...

  • Sumo SL001 - page 26

    Robot is slow , erratic or does not move. • Robot batteries are exhausted. • Remote control batter - ies are exhausted. • Remote control power switch is in OFF position. • Debris (hair , carpet fibers, dirt, etc.) is trapped between the robot’s wheels. • Recharge the robot with its charger . • Replace batteries. • Switch power to O ...

  • Sumo SL001 - page 27

    • Clean all parts with a soft, dry cloth. • If not being used, remove the batteries from the remote controls and charging station. Specifications P owe r: Rob ot run s o n t wo 1.2 V r ech arge abl e b att eri es (in clu ded ). Remote controls run on 3 AAA alkaline batteries each (purchase separately). Charging station runs on 3 AA alkaline ba ...

  • Sumo SL001 - page 28

    Statement of FCC Compliance WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user ’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to P art 15 of the FCC Rules. These limits a ...

  • Sumo SL001 - page 29

    Statement of FCC Compliance • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver . • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for assistance. FCC Label Compliance S ...

  • Sumo SL001 - page 30

    ...

  • Sumo SL001 - page 31

    ...

  • Sumo SL001 - page 32

    W arranty What Is Covered This warranty covers any defects in materials or workmanship, with the exceptions stated below . How Long Coverage Lasts This warranty runs for 90 days from the date of original purchase. What Is Not Covered This warranty does not cover damage caused by misuse or use other than as intended and described in the product inst ...

Produzent Sumo Kategorie Robotics

Dokumente, die wir vom Produzenten des Geräts Sumo SL001 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Sumo
- Bedienungsanleitungen SL001
- Produktkarten Sumo
- Informationsbroschüren
- oder Energieetiketten Sumo SL001
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Sumo SL001.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Sumo SL001, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Sumo SL001. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Sumo SL001 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Sumo SL001, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Sumo SL001 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Sumo SL001 verständlich ist.

Eine gänzliche Bedienungsanleitung von Sumo sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Sumo SL001 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Sumo SL001 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Sumo SL001, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Sumo SL001 - die uns die ersten Schritte während der Nutzung von Sumo SL001 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Sumo SL001 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Sumo SL001 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Sumo SL001?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sumo SL001 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sumo SL001 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Captcha
Neues Bild

Kommentare (0)