Bedienungsanleitung Winegard MV-0500

12 Seiten 0.16 mb
Download

Zur Seite of 12

Summary
  • Winegard MV-0500 - page 1

    1 Movin’ View TM Automatic Digital Satellite Mobile Antenna Model MV-0500 Made in the U.S.A. Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2002 2451018 WINEG ARD ® ...

  • Winegard MV-0500 - page 2

    2 DIRECTV ® is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEM SATELLITE(S) Introduction Congratulations! Y ou have purchased one of W inegard’ s latest developments in the mobile satel- lite reception product ...

  • Winegard MV-0500 - page 3

    3 1 Cable entry plate 1 lar ge yellow spade connector 2 small red spade connectors All required screws and washers 1 base with electronics, dish, dual LNBF 1 tube silicone 1. Open box and remove packing material. 2. Lift unit out of box vertically . Do not turn box and “roll” out, or turn upside down to remove. ! USE 2 PEOPLE when removing the ...

  • Winegard MV-0500 - page 4

    4 Installation Diagram BACK OF VEHICLE FRONT OF VEHICLE GPS ANTENNA ADJUSTABLE BASE FOOT ADJUSTABLE BASE FOOT REAR BASEFOOT MUST DIRECTLY FACE REAR OF VEHICLE LEVELING SCREW LEVELING SCREW LEVELING SCREW CONTROL UNIT POWER SUPPLY REFLECTOR HEYCO ® CONNECTORS FIGURE 1 ...

  • Winegard MV-0500 - page 5

    5 6. On each foot, screw the flange nut to the base of the leveling screw on the mounting foot, flange up. Place rubber washer , with the rubber side up, on the nut, Figure 2. Push mounting foot under base. Push foot screw through the base and tighten lock nut to secure foot to base. Be sure the base feet are pointing away from the base. Base feet ...

  • Winegard MV-0500 - page 6

    6 10. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 1 1. Put approved sealant in the area under the base feet. Place base foot on top of the sealant and screw down using (2) #10 screws (provided) for each base foot. 12. Unscrew the locknuts in the base and remove the base from feet. Put the other (4) #10 ...

  • Winegard MV-0500 - page 7

    7 CABLE- ENTRY PLATE CABLE CLAMP - EVERY12”-16” 1. Decide the best location for the cables to enter the vehicle, and the location of the switch and r eceiver (see “Installing the switch and receiver” below .) Drill a 1/2” hole in the roof, push wires inside. Make proper connections ( remember you must have fil- tered +12 VDC power source ...

  • Winegard MV-0500 - page 8

    8 Initializing & replacing the dome after connecting the receiver(s) — 1. Be sure vehicle is in a location free of all obstruc- tions and with a clear view of the satellite. 2. DO NOT MOVE VEHICLE during the first initial- ization. Power up unit, turn on receiver . FOR THE FIRST TIME ONL Y , the unit may take up to 10 min- utes to initially f ...

  • Winegard MV-0500 - page 9

    9 Operation Your new MV-0500 features: • GPS technology • Fast signal acquisition times • Easy “one-button” operation • Ability to toggle between satellites using remote control, if subscribing to multi- satellite programming V ehicle must be parked. 1. T urn on receiver and television set. This unit will not operate unless r eceiver is ...

  • Winegard MV-0500 - page 10

    10 Signal strength screen meter shows some signal strength, but constantly moves up and down, and is never locked on satellite. Unit continues to move, but never finds any signal. The unit continues to move and the signal strength screen shows that it is finding the satellites, but will never lock onto any satellite. Continues to search. The unit m ...

  • Winegard MV-0500 - page 11

    11 Base Diagram CONTROL UNIT DETAIL TO RECEIVER DO NOT USE AZ MOTOR EL MOTOR 8-PIN POWER T A LIMIT SWITCHES PROGRAMMING PORT (F ACTOR Y USE ONL Y) BACK OF VEHICLE FRONT OF VEHICLE GPS ANTENNA CONTROL UNIT #1 POWER SUPPLY REFLECTOR TO PRIMARY RECEIVER TO LNBF AZ MOTOR TO +12 VDC POWER SOURCE EL MOTOR GROUND BLOCK TO SECOND RECEIVER AZ EL SWITCHES FI ...

  • Winegard MV-0500 - page 12

    12 Winegard Company • 3000 Kirkwood S treet • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www .winegard.com Printed in U.S.A. © 2002 Winegard Company 2451018 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in materials or workmanship within two (2) years from dat ...

Produzent Winegard Kategorie Satellite TV System

Dokumente, die wir vom Produzenten des Geräts Winegard MV-0500 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Winegard
- Bedienungsanleitungen MV-0500
- Produktkarten Winegard
- Informationsbroschüren
- oder Energieetiketten Winegard MV-0500
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Winegard MV-0500.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Winegard MV-0500, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Winegard MV-0500. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Winegard MV-0500 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Winegard MV-0500, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Winegard MV-0500 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Winegard MV-0500 verständlich ist.

Eine gänzliche Bedienungsanleitung von Winegard sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Winegard MV-0500 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Winegard MV-0500 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Winegard MV-0500, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Winegard MV-0500 - die uns die ersten Schritte während der Nutzung von Winegard MV-0500 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Winegard MV-0500 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Winegard MV-0500 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Winegard MV-0500?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Winegard MV-0500 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Winegard MV-0500 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)