-
Hotpoint EG71 - page 1
Instructions for Installation and Use EG71 This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated space. Read the instructions before installing or using the appliance and retain them for future use. The rating label is located below the oven door on the plinth panel. ...
-
Hotpoint EG71 - page 2
This appliance conforms to the following EEC Directives: Gas Appliances 90/396/EEC 93/68/EEC Low V oltage Equipment 73/23/EEC 93/68/EEC Electromagnetic Compatibility 89/336/EEC 92/31/EEC 93/68/EEC P AGE I ntroduction 3 For Y our Safety 4 - 5 Oven T imer Operation 6-1 1 Control Panel 12 Hotplate 13-14 Grilling 15 - 16 T op Oven 17 Main Oven 18 Eco S ...
-
Hotpoint EG71 - page 3
T o help you make the best use of your cooker , PLEASE READ THIS BOOKLET CAREFULL Y . Y our new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions. The cooker is designed specifically for domestic use and responsibility will not be ac ...
-
Hotpoint EG71 - page 4
Please read the precautions below before using your cooker . AL W A YS . . . AL WA YS make sure you understand the controls before using the co oker . AL WA YS check that all controls on the cooker are turned off after use. AL WA YS stand back when opening the oven door to allow heat to disperse. AL W A YS use dry , good quality oven gloves when re ...
-
Hotpoint EG71 - page 5
5 FOR YOUR SAFETY NEVER . . . NEVER leave children unsupervised where the cooker is installed as all surfaces will get hot during and after use. NEVER allow anyone to sit or stand on any part of the cooker . NEVER store items that children may attempt to reach above the c ooker . NEVER heat up unopened food containers as pressure can build up causi ...
-
Hotpoint EG71 - page 6
6 OVEN TIMER OPERA TION The oven can be controlled by the automatic timer . 1. Select foods which require the same cooking time and temperature. 2. T o ensure food does not cool down and require reheating, set the end time so the food is ready when you require it. 3. Always ensure that meat and poultry is defrosted before placing in the oven. 4. Wh ...
-
Hotpoint EG71 - page 7
7 KNOW YOUR TIMER CLOCKF ACE The timer incorporates a 24 hour clock. Ensure correct time of day is always set, before using your coo ker . PLEASE NOTE THA T THE DISPLA Y WILL DIM BETWEEN 22.00 HOURS AND 06.00 HOURS TO PREVENT GLARE. However , should you operate the timer during these hours the display will return to normal brightness for a few seco ...
-
Hotpoint EG71 - page 8
ELECTRONIC CLOCK & AUT OMA TIC OVEN TIMER OPERA TION 8 SETTING THE TIME OF DA Y Step 1 Make sure all oven controls are turned Of f. Step 2 Check the electricity supply to the cooker is turned on. Step 3 When switched on the display will show 0.00 and Auto symbol will be flashing intermittently . Step 4 Press & hold in both the “Minute Min ...
-
Hotpoint EG71 - page 9
ELECTRONIC CLOCK & AUT OMA TIC OVEN TIMER OPERA TION 9 Step 3 Press and hold in the Cook Period button. The display will read 0.00 with the cookpot ( ) symbol lit . Step 4 With the Cook Period button still held in, set the required Coo k Period using the “+” and “–” buttons. Release the buttons and the timer display will revert to the ...
-
Hotpoint EG71 - page 10
ELECTRONIC CLOCK & AUT OMA TIC OVEN TIMER OPERA TION 10 Step 4 Press & hold in the “Cook Period” button, the display will read 0.00 and the cookpot ( ) symbol will light up. With the Cook Period button still held set the required Cook Period using the “+” and “–” buttons. Example: 1hr 30 minutes (as shown). Note: Cook Period i ...
-
Hotpoint EG71 - page 11
ELECTRONIC CLOCK & AUT OMA TIC OVEN TIMER OPERA TION 11 OTHER NOTES ON TIMER OPERA TION 1. When cooking Automatically the Cook Period can be checked at any time simply by pressing the Cook Period button. 2. When cooking Automatically the End T ime can be checked at any time by simply pressing the End T ime button. 3. Having set a Cook Period an ...
-
Hotpoint EG71 - page 12
12 CONTROL P ANEL ❍ ❍ ❍ ❍ ❍ ❍ ❍ Main oven Note: Always ensure that all the controls are in the OFF position, when the appliance is not in use. OPERA TING THE CONTROL WHEN THE GRILL IS IN USE. In common with all cookers having controls sited above the grill compartment, care must be taken when setting the controls, due to hot air being ...
-
Hotpoint EG71 - page 13
13 The hotplate lid is fitted with a safety device which cuts off the gas supply to the hotplate burners unless the lid is fully open. Do not use the safety device as a means of controlling the hotplate burners. The hotplate has two high speed burners and two simmering burners which will accommodate pans between 100mm (4”) and 230mm (9”) diamet ...
-
Hotpoint EG71 - page 14
SAFETY REQUIREMENTS FOR DEEP F A T FRYING 1. Never fill chip pans more than one third full with oil or fat . 2. Never leave oil or fat unattended during the heating or cooling period. 3. Never heat fat or fry with a lid on the pan. 4. Always dry food thoroughly before frying, and lower it slowly into the hot oil or fat. Frozen foods in particular w ...
-
Hotpoint EG71 - page 15
GRILLING GRILL P AN HANDLE The grill pan handle is detachable from the pan, to facilitate cleaning and storage. The han- dle can be either detachable from or fixed to the pan. For a fixed handle remove the screw and washers from the grill pan bracket, tilt the handle over the recess adjacent to the brack- et (1), slide it towards the centre of the ...
-
Hotpoint EG71 - page 16
GRILLING NEVER ALLOW YOUNG CHILDREN NEAR THE APPLIANCE WHEN THE GRILL IS IN USE AS THE SURF ACES GET EXTREMEL Y HOT . GRILLING SHOULD NEVER BE UNDERT AKEN WITH THE GRILL / T OP OVEN DOOR CLOSED OR WITHOUT THE REMOV ABLE ROOF . DO NOT LINE THE GRILL P AN WITH ALUMINIUM FOIL. NOTE: During use the grill compartment becomes hot. Care should be taken to ...
-
Hotpoint EG71 - page 17
The heat for conventional cooking in the T op Oven is provided by the grill element and the element under the floor of the oven. It is ideal for the slow cooking of cheaper cuts of meat in casseroles etc but can also be used for small joints of meat up to 1 .5kg (3lb). Detailed charts covering suggested temperatures and shelf positions for cooking ...
-
Hotpoint EG71 - page 18
MAIN OVEN – F AN COOKING The heat for Fan Cooking in the Main Oven is provided by an element situated at the back of the oven, around the fan. Fan cooking is ideal for large poultry or joints of meat, reducing cooking times and often eliminating the need for preheating the oven. It is also ideal for batch cooking where food is cooked on more than ...
-
Hotpoint EG71 - page 19
19 USING THE ‘ECO’ SETTING Points to bear in mind when preparing food:– 1. Make sure all dishes will fit into the oven before preparing the food. 2. All dishes cooked by the ‘Eco’ setting should be cooked for a minimum of 6 hours. They will 'hold' at this setting for a further hour but marked deterioration in appearance will be ...
-
Hotpoint EG71 - page 20
OVEN TEMPERA TURE CHARTS – MEA T Beef/ Lamb (slow roasting) Meat 170/180 35 mins per 450g (1lb) + 35 mins over . Runner 1 from bottom of oven. 35-40 mins per 450g (1lb) 40 mins per 450g (1lb) + 40 mins over 40 mins per 450g (1lb) 40-45 mins per 450g (1lb) + 40 mins over 40-45 mins per 450g (1lb) 25-30 mins per 450g (1lb) + 25 mins over 25-30 mins ...
-
Hotpoint EG71 - page 21
Note: If soft margarine is used for cake making, temperatures recommended by the manufacturers should be followed. T emperatures recommended in this chart refer to cakes made with block margarine only . OVEN TEMPERA TURE CHARTS – BAKING 21 Scones Food Pre- heat Ye s 210/220 10-15 Runner 1 from bottom of oven. Runner 1 from bottom of oven. Runner ...
-
Hotpoint EG71 - page 22
Switch off the electricity supply and allow the cooker to cool before cleaning the appliance. Clean the cooker regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. Never use biological washi ng powder , caustic cleaners, harsh abrasives, scouring pads, aerosol cleaners or oven chemical cleaners of any kind. Bef ...
-
Hotpoint EG71 - page 23
23 CARE AND CLEANING COOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate, hotplate front trim, burner caps, roasting dish, grill pan, main oven base, inside of grill compartment, inside of doors. Cloth wrung out in warm soapy water . Stubborn stains can be removed with a cream paste, liquid cleaner or by rubbing with fine steel wool soap pads. C ...
-
Hotpoint EG71 - page 24
24 CARE AND CLEANING Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer . Do not use scouring pads, or abrasive powder , which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows. Stubborn stains can be removed by using a fine steel ...
-
Hotpoint EG71 - page 25
.... don’t panic Just quickly check these points before calling a Hotpoint engineer: 1. Check that the mains supply is switched on. 2. Check that the Automatic Cooking Symbol (Auto) on the T imer is not flashing, if it is switch the oven back to Manual control (see timer instructions). 3. If using the Grill in the T op Oven make sure that the T o ...
-
Hotpoint EG71 - page 26
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating label which is fitted behind the bottom of the main oven door seal. This appliance is not designed to be connected to a combusti ...
-
Hotpoint EG71 - page 27
TECHNICAL DA T A DIMENSIONS Height 900 - 915mm Width 600mm Depth 595mm (excluding door handles) GENERAL Gas connection Rp 1 / 2 ( 1 / 2 ” BSP female) Gas Supply Natural gas G20 at 20 mbar . Can be converted (with a service kit) for propane G31 at 37mbar and butane G30 at 28-30mbar Pressure test point Front left hotplate burner injector . Gas rate ...
-
Hotpoint EG71 - page 28
SP ACE FOR FIXING The cooker can be close fitted below hotplate level. This requires a minimum distance of 600mm between cupboard units of hotplate height. When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above hotplate level, allow a side clearance of at least 65mm. The diagram below illustrates the minim ...
-
Hotpoint EG71 - page 29
ST ABILITY BRACKET POSITION GAS BACKPLA TE POSITION 125mm 450 mm 635mm LEVELLING T wo rear wheels and two front feet are fitted which can be adjusted up or down to set the height ( 915mm) and level the cooker . 1. The rear wheels can be raised or lowered from the BACK of the cooker by adjusting the levelling screws ‘A ’ in the plinth. 2. The fr ...
-
Hotpoint EG71 - page 30
ELECTRICAL INST ALLA TION OPERA TIONAL CHECKS 30 W ARNING - THIS APPLIANCE MUST BE EARTHED Y our cooker should have been checked to ensure that the voltage corresponds with your supply voltage, which is stated on the rating plate. This is situated adjacent to the bottom left hand main oven door hinge. The cooker must be connected by a qualified ele ...
-
Hotpoint EG71 - page 31
Satisfaction Guaranteed or Y our Money Back Hotpoint gives you a unique ‘Satisfaction Guaranteed’ promise – valid for ninety days after you have purchased your Hotpoint product. If there is a technical problem with your Hotpoint appliance, just call Hotpoint Service (see back page). If necessary we will arrange for an engineer to call. If the ...
-
Hotpoint EG71 - page 32
PRINTED BY SIMLEX . FOUR ASHES, WOL VERHAMPTON. March 2001 Part No. 4866200082-01 Key Contacts Service Hotpoint has the largest appliance manufacturer ’s service team i n Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 200 Y ou will be asked for ...
Haben Sie eine Frage bezüglich Hotpoint EG71?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Hotpoint EG71 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Hotpoint EG71 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.