-
Sangean Sangean HDT-1 - page 1
381R20S-A HD Radio TM Component T uner User Manual 20070425_HDT-1&HDT-1X_381R20S-A_«Ê-±.p65 2007/4/27, ¤U¤È 03:58 1 ...
-
Sangean Sangean HDT-1 - page 2
HD Ra dio™ T echnology M anufa ctured Under Licen se From iBiquity Digital Corporation. iBiquity Digital a nd the HD Ra dio a nd HD logos are registered trade marks of iBiquity Digital Corporation. HD Ra dio TM is a trade mark of iBiquity Digital Corporation. U.S. a nd Foreign Patents. 20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤È 01 ...
-
Sangean Sangean HDT-1 - page 3
2 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this a pparatus near water . 6. Clea n only with dry cloth. 7. Do not block any ventilation openings. Install in a ccorda nce with the manufa cturer’s instructions. 8. Do not install near any heat ...
-
Sangean Sangean HDT-1 - page 4
3 Main Unit Controls (Front & Remote Control) Unit Button 1 2 3 4 5 6 7 8 9 10 11 12 Remote Button A C N/A N/A G H I D B E F N/A Action/Combination Turns unit on/off 10 Digit Keypad FREQ Preset Clock Set Remote Sensor LCD Display Tuning Adva nced Menu Options Seek Tuning HD Seek Tuning BAND INFO 2 sec. hold FREQ PRESET Sta ndby LED Indicator Fu ...
-
Sangean Sangean HDT-1 - page 5
4 20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤È 01:43 7 ...
-
Sangean Sangean HDT-1 - page 6
5 Main Unit Controls (Rear) 13. 14. 15. 16. External FM a ntenna socket External AM loop antenna socket Line Out socket SPDIF Optical Connection (Optional on HDT -1X) AC power cord socket 17. 18. 20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤È 01:43 8 ...
-
Sangean Sangean HDT-1 - page 7
6 Acce ssorie s Detacha ble power Cord x 1 FM Dipole Antenna x 1 AM Loop a ntenna x 1 20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤È 01:44 9 ...
-
Sangean Sangean HDT-1 - page 8
7 RCA type audio cable x 1 Remote control unit x 1 Instruction ma nual x 1 Warra nty cardSeek Function T o seek to another cle ar station, use the SEEK toggle button . Press 20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤È 01:44 10 ...
-
Sangean Sangean HDT-1 - page 9
8 Getting started Step 1. Inspect pa ckage to insure that all parts & acce ssorie s are included. Step 2. Find a proper location for your new HDT -1/HDT -1X HD Ra dio Tuner following the guidelines on table 1.1. Step 3. Connect the included or other external FM a ntenn a to Figure 2, #13. Step 4. Connect the included or other external AM antenn ...
-
Sangean Sangean HDT-1 - page 10
9 Navigating the Display There are ma ny display functions . This will help you understa nd what the display is telling you, making navigation a nd setup ea sier. (A)Radiotext, (B)Time, (C)Signal quality, (D)Frequency, (E)and Audio spectrum. : RDS Indicator : Progra m Station : Progra m T ype : Callsign : Radio T ext : HD RADIO Indicator : Siqnal I ...
-
Sangean Sangean HDT-1 - page 11
10 Setting up a nd Progra mming your HDT -1/HDT -1X Setting the clock Clock setting can be done when the tuner is in Standby (power off) 1. Press and hold “INFO” button for approx. 2 seconds until display flashes “clock set “to enter Clock Set mode. 2. Press Tuning UP or Down button to select AM or PM. 3. Press number keys to set required c ...
-
Sangean Sangean HDT-1 - page 12
11 Radio Controls T o turn the radio on, press the Sta ndby button. Pressing the Standby button again will put the unit into standby . In sta ndby , the tuner will display the time, dim the ba cklight and sta ndby LED will be on. Selecting the ra dio ba nd Press the BAND button to select the a ppropriate ba nd . At ea ch press of the BAND button, t ...
-
Sangean Sangean HDT-1 - page 13
12 Ma nual T uning Press the TUNING rocker switch UP or DOW N to tune up or down to select a radio station. Tuning step per press for AM band is 10 kHz a nd 100 kHz for FM ba nd. Direct T uning By using numbered key pad, you ca n directly tune to a radio station. For exa mple, to tune to station 93.30 FM, press BAND button to select FM ba nd f ollo ...
-
Sangean Sangean HDT-1 - page 14
13 Rece iving HD radio station s When the radio is tuned to a station broadca sting HD radio signal, the LCD will display a blinking “HD “logo. Once the tuner a cquires the HD ra dio signal, the “HD” logo will stay on and a Signal Strength indication will a ppear in the top right hand corner . Rece iving Multica st Stations When the radio i ...
-
Sangean Sangean HDT-1 - page 15
14 Seek Function T o seek to a nother clear station, use the SEEK toggle button. Press a nd relea se the SEEK UP or DOW N will go to the next availa ble station with good signal. Press a ny key to stop SEEK function. Using AM a nd FM presets Preset stations There are 20 preset stations for FM (10 x FM1, 10 x FM2) a nd 20 preset stations for AM (10 ...
-
Sangean Sangean HDT-1 - page 16
15 Recall preset stations T o recall preset stations, sele ct required ba nd by pressing BAND selection button. Press PRESET button to enter PRESET recall mode. Display will show “GO TO PRESET”. Then followed by using one of the following methods to recall the stations. 1. Press a nd relea se the number station you like to recall. 2. Press TUNI ...
-
Sangean Sangean HDT-1 - page 17
16 Advanced Information Long press INFO button for 2 se conds to enter Adva nced Inf ormation. Press a nd release INFO button will cycle through inf ormation of RESET , LCD Contra st Adjust, Ba cklight Brightness Control, (For HDT -1X: Stereo/Mono Mode, Analog Mode, Split Audio Mode), Bit Error Rate, The carrier to noise ratio, FUSE Bit Check , T r ...
-
Sangean Sangean HDT-1 - page 18
17 Advanced Menu Option s Menu Option Ba cklight Mono/Stereo Mode Analog Mode (HD OFF) Split Audio Mode Bit Error Rate Carrier to Noise Ratio Fuse Bit Check Tra nsmission Mode Station ID Software V ersion Controls Tuning Up to a ctivate option Tuning Down to de activate Tuning Up to a ctivate option Tuning Down to de activate Tuning Up to a ctivate ...
-
Sangean Sangean HDT-1 - page 19
18 T roubleshooting Issue Power Won’t Turn On Remote Doesn’t Work I don’t hear a ny audio I only hear audio in one spea ker I only hear static Poor audio quality Possible Solutions Check AC power cord connection Check circuit brea kers/fuses Call Sange a n Service De partment at 888-SANGEAN Remove pla stic piece located at bottom of remote Re ...
-
Sangean Sangean HDT-1 - page 20
19 Poor audio quality (Cont.) HD Sign al Keeps Fading in a nd Out Sta nge sound when radio is of f Antenna not correctly installed or oriented Radio station is broa dca sting poor signal Antenna not correctly installer or oriented Poor environmental conditions Malfunctioning component Using the signal strength indicator or the Carrier to Noise indi ...
-
Sangean Sangean HDT-1 - page 21
20 Specifications Power: Mains: AC 120 V olts 60 Hz only, 10 W att maximum Battery ( remote control ): 3.0V CR 2025 Frequency coverage: FM 87.50 - 108.10 MHz AM 520 - 1710 kHz HD FM 87.50 - 108.10 MHz HD AM 520 - 1710 kHz Antenna System: FM - D ipole type ( supplied ) AM - Loop type ( supplied ) Dimension ( W x H x D ): 430x70x256 mm W eight: 2.6 k ...
-
Sangean Sangean HDT-1 - page 22
21 HDT -1/HDT-1X Brief User Interfa ce: UI KEY function NO 1 2 3 4 5 Button sta ndby Band Info Info Info Action short short short long 2s (T o use info key to jump next status) short(T o use number key a nd tune select clock time, then to press Info button finish setting) long 2s(T o use info key to jump next status,when the status is RESET, to pre ...
-
Sangean Sangean HDT-1 - page 23
22 6 7 8 9 10 Preset Tune Seek HD Seek Freq 1.T o press preset button then to press number button finish setting 2.T o press number button long 2s store cha nnel 3.When preset memory is full. T o press number button long 5s store channel short short Push a nd Hold Push a nd Hold short short T o press Freqt button then to press number button select ...
Haben Sie eine Frage bezüglich Sangean Sangean HDT-1?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sangean Sangean HDT-1 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sangean Sangean HDT-1 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.