Bedienungsanleitung Cisco Systems OL-3560-02

16 Seiten 0.5 mb
Download

Zur Seite of 16

Summary
  • Cisco Systems OL-3560-02 - page 1

    CHAPTER 1-1 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 1 Overview This chapter describes the P A-4T port adapter and contains the following sections: • Port Adapter Overvie w , page 1-1 • Synchronous Serial Overvie w , page 1-2 • LEDs, page 1-3 • Cables, Connectors, and Pinouts, page 1-4 • Port Adapter ...

  • Cisco Systems OL-3560-02 - page 2

    1-2 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Synchronous Serial Overview Synchronous Serial Overview The P A-4T supports the follo wing interface types: EIA/TIA-232, EIA/TIA-449, V .35, X.21, and EIA-530. EIA/TIA-232, which is by far the most common interface standard in the United States, s ...

  • Cisco Systems OL-3560-02 - page 3

    1-3 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Synchronous Serial Specifications Synchronous Serial Specifications The P A-4T provides up to four synchronous serial interf aces. Each interface allows a maximum bandwidth of 2.048 Mbps; the speed depends on the type of electrical interface used. ...

  • Cisco Systems OL-3560-02 - page 4

    1-4 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts The green enabled LED on the port adapter indicates that the motherboard is enabled and receiving power , and that the port adapter is ready for operation. The follo wing conditions must be met before the enabled LE ...

  • Cisco Systems OL-3560-02 - page 5

    1-5 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts The network end of the cable is an industry-standard connector for the type of electrical interface that the cable supports. For most interface types, the adapter cable for DTE mode uses a plug at the netw ork end, ...

  • Cisco Systems OL-3560-02 - page 6

    1-6 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts Figur e 1 -3 Ser ial P ort A dapter Cables Metric (M3) thumbscrews are included with each port adapter cable to allo w connections to de vices that use metric hardware. Because the 4T port adapter uses a special, hi ...

  • Cisco Systems OL-3560-02 - page 7

    1-7 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts Figur e 1 -4 EIA/TIA -232 Adapt er Cable Connectors EIA/TIA-449 Connections The router (VIP) end of all EIA/TIA-449 adapter cables is a high-density 60-pin plug. The opposite (network) end of the adapter cable provi ...

  • Cisco Systems OL-3560-02 - page 8

    1-8 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts X.21 Connections The router (VIP) end of all X.21 adapter cables is a high-density 60-pin plug. The opposite (network) end of the adapter cable is a standard DB-15 connector . Figure 1-7 shows the connectors at the ...

  • Cisco Systems OL-3560-02 - page 9

    1-9 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts T able 1 -3 EIA/TIA -232 Adapt er Cable Signals DTE Cable (CAB-232MT=) DCE Cable (CAB-232FC=) VIP End, HD 1 60-Position Plug 1. HD = high density. Network End, DB-25 Plug VIP End, HD 60-Position Plug Network End, DB ...

  • Cisco Systems OL-3560-02 - page 10

    1-10 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts T able 1 -4 EIA/TIA -449 Adapt er Cable Signals DTE Cable (CAB-449MT=) DCE Cable (CAB-449C=) VIP End, HD 1 60-Position Plug 1. HD = high density. Network End, DB-37 Plug VIP End, HD 60-Position Plug Network End, DB ...

  • Cisco Systems OL-3560-02 - page 11

    1-11 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts T able 1 -5 EIA -530 DTE Adapt er Cable Signals (CAB-530MT=) VIP End, HD 1 60-Position Plug 1. HD = high density. Network End, DB-25 Plug Signal Pin Pin Signal Shield ground 46 1 Shield ground TxD/RxD+ 11 —> 2 ...

  • Cisco Systems OL-3560-02 - page 12

    1-12 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Cables, Connectors, and Pinouts T able 1 -6 V .35 Adapt er Cable Signals DTE Cable (CAB-V35FT= or CAB-V35MT=) DCE Cable (CAB-V35FC= or CAB-V35MC=) VIP End, HD 1 60-Position Plug 1. HD = high density. Network End, 34-Position Plug VIP End, HD 60-P ...

  • Cisco Systems OL-3560-02 - page 13

    1-13 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Port Adapter Slot Locations on the Supported Platforms Port Adapter Slot Locations on the Supported Platforms This section discusses port adapter slot locations on the supported platforms. The illustrations that follo w summarize slot location co ...

  • Cisco Systems OL-3560-02 - page 14

    1-14 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Port Adapter Slot Locations on the Supported Platforms Figur e 1 -9 P ort A dapter Slots in the Cisco 7206 VIP Slot Numbering Figure 1-10 shows a partial vie w of a VIP motherboard with installed port adapters. With the motherboard oriented as sh ...

  • Cisco Systems OL-3560-02 - page 15

    1-15 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Identifying Interface Addresses Figur e 1 -1 1 Interf ace Slot Numbers—Cisco 7505 Shown Identifying Interface Addresses This section describes how to identify interf ace addresses for the P A-4T in supported platforms. Interface addresses speci ...

  • Cisco Systems OL-3560-02 - page 16

    1-16 PA-4T Synchronous Serial Port Adapter Installation and Configuration OL-3560-02 Chapter 1 Overview Identifying Interface Addresses Cisco 7200 Series Routers Interface Addresses This section describes how to identify the interf ace addresses used for the P A-4T in Cisco 7200 series routers. The interface address is composed of a two-part number ...

Produzent Cisco Systems Kategorie Network Cables

Dokumente, die wir vom Produzenten des Geräts Cisco Systems OL-3560-02 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Cisco Systems
- Bedienungsanleitungen OL-3560-02
- Produktkarten Cisco Systems
- Informationsbroschüren
- oder Energieetiketten Cisco Systems OL-3560-02
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Cisco Systems OL-3560-02.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Cisco Systems OL-3560-02, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Cisco Systems OL-3560-02. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Cisco Systems OL-3560-02 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Cisco Systems OL-3560-02, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Cisco Systems OL-3560-02 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Cisco Systems OL-3560-02 verständlich ist.

Eine gänzliche Bedienungsanleitung von Cisco Systems sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Cisco Systems OL-3560-02 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Cisco Systems OL-3560-02 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Cisco Systems OL-3560-02, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Cisco Systems OL-3560-02 - die uns die ersten Schritte während der Nutzung von Cisco Systems OL-3560-02 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Cisco Systems OL-3560-02 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Cisco Systems OL-3560-02 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Cisco Systems OL-3560-02?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Cisco Systems OL-3560-02 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Cisco Systems OL-3560-02 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)