Bedienungsanleitung ADT Security Services Safewatch Plus Enterpreneur Security Systems

28 Seiten 0.76 mb
Download

Zur Seite of 28

Summary
  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 1

    ADT-1090-INT 7/25/00 3:12 PM Page 1 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 2

    ADT-1090-INT 7/25/00 3:12 PM Page 2 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 3

    Table of Contents * System Reference ................................................. 2 Operating Your System ......................................... 3 ARMING ....................................................................................... 3 Arming The System Prior To Leaving ..................................... 3 Arming The System Witho ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 4

    Zone Identification Card Space is provided for recording the areas of protection which are ;“““““““““‘““““““““’ : lndlvldual Zone Status i Ready status If lighted, zone is not secure. i ; /flight& the system is ready to be armed. Chedc doors, windows, etc. If not Iighted, one or more zones are faulted. i ! ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 5

    Operating Your System ARMING Before the control can be armed, all of the intrusion zones must be secure as indicated by the green READY indicator. If the READY indicator is off, one or more zones are faulted. The indicator(s) corresponding to the faulted zone(s) will light. Use the pull out zone I.D. card on the control station to determine the are ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 6

    ;I Turning Off the lnterlor Zones and Entrance Delay Control station key 4 may be used to turn the interior zones off prior to arming. This will allow the system to alarm instantly if the entrance door is opened, while armed. 1. Press the 4 key and hold for three seconds. 2. When interior defined zones are turned off, the corresponding Zone indicat ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 7

    DISARMING Your system is programmed with one or more entrance delay zones which allow time to enter the premises without causing an alarm. Each delay door may be programmed with a different entry time. Be sure to check with your installer. Note: If your system has the “Interior Follower” feature enabled, all interior designated zones automatica ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 8

    ALARM CONDITIONS Whenever an alarm occurs, the ALARM indicator will light, the audible alarm will sound (if applicable), and the control wilI communicate with the central station (if this option was purchased). NOTE: If upon returning to the premises it 1s discovered that an alarm has occurred, DO NOT ENTER THE PREMISES. Leave immediately and go to ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 9

    THE EMERGENCY KEYPAD PANIC ALARMS Your system may have been purchased with up to three emergency keypad panic alarms. These may be used to activate an alarm in the event of a Fire, Hold-up, or other emergency condition, as programmed by your installer. Each alarm is activated by pressing the appropriate emergency panic key (located below the numeri ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 10

    SPECIAL FEATURES The CHIME mode allows audible monitoring of zones while the system is disarmed. When the CHIME mode is active, the control station sounder will beep whenever a perimeter burglar defined zone (door, window, etc.) indicator is opened. For example, the CHIME feature will cause the control station to beep two times whenever the front d ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 11

    The bypass key (#) is used to bypass selected zones in your system. A bypassed zone will NOT be capable of activating an alarm as it is temporarily removed from your system. Bypassing (also referred to as shunting) is most commonly used to allow free movement of an area (zone or group of zones) while arming the rest of the system or to temporarily ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 12

    Your system may utilize a conventional key switch for arming and disarming the system. Arming and disarming with a key switch is performed as follows: cl 1. 2. 3. 0 1. 2. Arming Verify that the BEADY light is on. Insert your key into the key switch and turn. Hold for one second and release. The red ARMED light will blink during the exit delay cycle ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 13

    Programming Certain features of your system are programmable through the control station. The programming mode is entered by pressing key 9 and holding for three seconds, then entering the Master User Code. Other programming functions may be possible that are not detailed in this section. Consult your security representative for a list of the user ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 14

    Determine your desired new User Code or Master User Code sequence. If you make an error while programming, press the “ * ” key five times and start over from step 1. WARNING: Pressing the “ # ” or l4 * ” key while programmlng a code may result In Improper code operation, therefore you MUST return to step 1 when an error Is made. 0 1. 2. 3 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 15

    An optional feature of your system allows you to assign a certain number of valid uses to User Code 6. After the code has been used the programmed amount of times, it automatically becomes disabled. This code may be assigned to a maintenance person, a maid, or anyone who you would like to be able to arm and disarm the system for a selected number o ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 16

    Notes ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 17

    The TEST mode commands the control station to beep continuously and light the corresponding zone indicator, each time a zone is violated. The zone indicator of each tested zone will remain lighted while each succeeding zone is tested. Testing can be performed only while the system is disarmed. Testing the system should be performed in both ELECTRIC ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 18

    FIRE DETECTION Your system may or may not include fire detection, depending upon what options were purchased, and the local codes and regulations for your area. Fire alarm systems are active 24 hours a day and cannot be turned off. A!! fire systems require regular testing and maintenance. Common household dust build-up in smoke detectors can cause ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 19

    Emergency Evacuation Plan Preparation and education are of prime importance in the prevention of fire. An emergency evacuation plan should be established BEFORE an emergency situation arises. Your system may or may not contain fire detection and notification equipment. Be sure to have your installer explain and that you fully understand exactly wha ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 20

    The purpose of heat and smoke detectors is to detect a fire in its earliest stages and sound an alarm, giving occupants more time to exit the premises before smoke reaches a dangerous level. Cl KNOW FIRE HAZARDS No detection device can protect life in all situations; therefore, safeguards should be taken to avoid such potentially dangerous situatio ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 21

    0 Smoke Detector Location Smoke detectors should be installed in accordance with theNational FireProtection Association (NFPA) Standard 74. The following is from NFPA 74: Smoke detectors shall be installed outside of each separate sleeping area in the immediate vicinity of the bedrooms and on each additional story of the family living unit includin ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 22

    Smoke Detector Placement 4 inches @lm) -_I NOTE: Allmae~~mmennts are to the closest edge of the dote&or A Smoke Detector should be located on each story. A Smoke Detector should be located between the sleeping area and the rest of the family living unit. l Indicates required smoke detector @ Indicates smoke detector is optional if door is not p ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 23

    Glossary Alarm Memory: A history of the alarm that last occurred. Arm: To turn the intrusion detection system on. Bypass: To temporarily remove a zone from operation. To Shunt a zone. Control Panel: The main system electronics housed in a metal enclosure. Control Station: The remote station used to enter instructions to the control panel such as to ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 24

    ADT-1090-INT 7/25/00 3:13 PM Page 12 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 25

    ADT-1090-INT 7/25/00 3:13 PM Page 12 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 26

    Notes 20 ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 27

    FCC COMPLIANCE This equipment ganerates and uses radio frequency energy and lf nU installed and used properly, that !a. In strict accordance with the rtwnufacturer’s instructions, may catae interference to radio and teledslon raceptlon. lt has been type tested and found to corrpiy with the llmks for a Class B corrputlng devtce In acwtdance with t ...

  • ADT Security Services Safewatch Plus Enterpreneur Security Systems - page 28

    MOOSE Sentrol, Inc resen~es the rtght to change specifmtmns wthout notice tJ1991 Sentrol. Inc ...

Produzent ADT Security Services Kategorie Home Security System

Dokumente, die wir vom Produzenten des Geräts ADT Security Services Safewatch Plus Enterpreneur Security Systems erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen ADT Security Services
- Bedienungsanleitungen Safewatch Plus Enterpreneur Security Systems
- Produktkarten ADT Security Services
- Informationsbroschüren
- oder Energieetiketten ADT Security Services Safewatch Plus Enterpreneur Security Systems
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung ADT Security Services Safewatch Plus Enterpreneur Security Systems.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen ADT Security Services Safewatch Plus Enterpreneur Security Systems, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen ADT Security Services Safewatch Plus Enterpreneur Security Systems. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts ADT Security Services Safewatch Plus Enterpreneur Security Systems ansehen.

Die komplette Bedienungsanleitung des Geräts ADT Security Services Safewatch Plus Enterpreneur Security Systems, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von ADT Security Services Safewatch Plus Enterpreneur Security Systems hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von ADT Security Services Safewatch Plus Enterpreneur Security Systems verständlich ist.

Eine gänzliche Bedienungsanleitung von ADT Security Services sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von ADT Security Services Safewatch Plus Enterpreneur Security Systems bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von ADT Security Services Safewatch Plus Enterpreneur Security Systems befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich ADT Security Services Safewatch Plus Enterpreneur Security Systems, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts ADT Security Services Safewatch Plus Enterpreneur Security Systems - die uns die ersten Schritte während der Nutzung von ADT Security Services Safewatch Plus Enterpreneur Security Systems erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit ADT Security Services Safewatch Plus Enterpreneur Security Systems hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von ADT Security Services Safewatch Plus Enterpreneur Security Systems im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich ADT Security Services Safewatch Plus Enterpreneur Security Systems?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit ADT Security Services Safewatch Plus Enterpreneur Security Systems nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit ADT Security Services Safewatch Plus Enterpreneur Security Systems hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)