Bedienungsanleitung Spracht Voice Center cp-2010

20 Seiten 0.4 mb
Download

Zur Seite of 20

Summary
  • Spracht Voice Center cp-2010 - page 1

    V oice Center ™ Conference Phone CP-2010 model series User's Manual ...

  • Spracht Voice Center cp-2010 - page 2

    ...

  • Spracht Voice Center cp-2010 - page 3

    T able of Contents - V oice Center User’s Manual Introduction and Quick Start Guide Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Analog or Digital T elephone System? . . . . . . . . . . . . . . . . . . . . . ...

  • Spracht Voice Center cp-2010 - page 4

    Introduction Thank you for choosing the V oice Center Conference Phone, a high per formance audio conferencing system. Its features include: • Full duplex communication – the V oice Center’ s digital speech processing enables simultaneous two- way communication. This eliminates clipped sentences and awkward one-way conversations, allowing smo ...

  • Spracht Voice Center cp-2010 - page 5

    3 Quick Start Guide 3. Analog or Digital T elephone System? Caution: if the V oice Center is connected to a digital telephone system using the Analog T elephone System Inter face, it will not operate correctly , and may cause damage to the A T -101 Analog Interface and cause it to over heat. It is therefore impor tant to use the correct inter face ...

  • Spracht Voice Center cp-2010 - page 6

    Analog T elephone System Setup with Analog T elephone System If you are connecting the V oice Center Conference Phone to an analog telephone system, follow the instructions below . In Nor th America, use the A T -101 Analog T elephone System Inter face supplied with the conference phone; in Europe, use the A T -102 European T elephone System Interf ...

  • Spracht Voice Center cp-2010 - page 7

    W all Mounting of Analog Interface (Optional) • Install the two mounting screws supplied with the Analog Interface in the wall. Leave approximately 3/16 in. (0.5 cm) between screw head and wall. • Place the Analog Interface over the mounting screws and slide it down to fix it in position. Selection of T one or Pulse Dialing The user may select ...

  • Spracht Voice Center cp-2010 - page 8

    Keypad Functions with Analog Phone System ON/OFF Pressing the ON/OFF key turns the Conference Phone on to obtain a dial tone, or turns it off to terminate a call. The green LED just above the ON/OFF key illuminates when the Conference Phone is on. REDIAL If a dial tone is available, pressing the REDIAL key redials the last number dialed on the Conf ...

  • Spracht Voice Center cp-2010 - page 9

    Conference Phone Operation with Analog Phone System Answering a call When the Conference Phone rings, press the ON/OFF key to answer the call. The green LED illuminates to indicate the Conference Phone is on. Adjusting the speaker volume While a call is in progress use the ▼ (decrease volume) and ▲ (increase volume) keys to adjust the speaker v ...

  • Spracht Voice Center cp-2010 - page 10

    Digital T elephone System Setup of Conference Phone with Digital Phone System Note: The DT -102 Digital T elephone System Inter face is required for use of the Voice Center Conference Phone with a digital phone system. Follow the steps below to set up the system. Throughout the instructions, the V oice Center Conference Phone is referred to as “C ...

  • Spracht Voice Center cp-2010 - page 11

    4. Use Digital Inter face’s 4-position switch to adjust audio level by making a test call. • Lift digital telephone handset from its cradle, then press Conference Phone’ s “On/Off” key . Important: the digital telephone handset must be “off-hook” for the duration of the call; the Digital Interface disables the handset microphone when ...

  • Spracht Voice Center cp-2010 - page 12

    Keypad Functions with Digital Phone System ON/OFF Pressing the ON/OFF key turns the Conference Phone on to connect a call, or turns it off to ter- minate the Conference Phone conversation. The green LED just above the ON/OFF key illumi- nates when the Conference Phone is on. W ith a digital telephone system, Conference Phone calls go through the di ...

  • Spracht Voice Center cp-2010 - page 13

    Conference Phone Operation with Digital Phone System Answering a call 1. When the phone rings, pick up the digital telephone handset to accept the call. 2. Press the ON/OFF key to take the call on the Conference Phone. The green LED illuminates to indi- cate the Conference Phone is on; the microphone in the digital telephone handset is disabled whi ...

  • Spracht Voice Center cp-2010 - page 14

    General Setup T ips T ips for Obtaining Optimal Acoustic Performance •T o minimize echoes, place the Conference Phone at the center of the room, or at least away from walls (at least 20 inches/0.5 m from any wall). • It is impor tant to place the Conference Phone on the sur face where it will be used before applying power . When power is applie ...

  • Spracht Voice Center cp-2010 - page 15

    General Installation of External Microphones (Optional) The V oice Center Conference Phone has 3 built-in microphones for complete 360° coverage in areas up to 10 x 15 ft (3 x 4.5 m). The V oice Center Conference Phone has RJ-22 input jacks for two external microphones to extend coverage in larger areas and to allow for irregular layouts. V oice C ...

  • Spracht Voice Center cp-2010 - page 16

    Specifications Conference Phone Controls and Interface Switches Microphone switch to turn on 1, T one/pulse switch to select 2, or all 3 built-in microphones telephone dialing mode LED indication lights Green LED indicates unit is on 3 red LEDs (one on each arm) indicate mute is activated Speakerphone connections I nputs: Output: RJ-45 for telephon ...

  • Spracht Voice Center cp-2010 - page 17

    Spracht Limited W arranty Policy Spracht warrants it products against defects or malfunctions in material and workmanship under normal use and ser vice, with the exceptions stated below . This warranty lasts for one year from the original date of purchase. Coverage terminates if you sell o r other wise transfer the product. In order to keep this wa ...

  • Spracht Voice Center cp-2010 - page 18

    Federal Communications Commission Statement Note: The V oice Center Conference Phone equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Par t 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment g ...

  • Spracht Voice Center cp-2010 - page 19

    ...

  • Spracht Voice Center cp-2010 - page 20

    SPRACHT T el: 650-318-8061 Fax: 650-318-8060 2672 Bayshore Parkway , Bldg 900 Mountain View , CA 94043 USA www .spracht.com © 2001 Spracht Spracht and V oice Center are trademarks of ODI. SP1009 Rev . 4/02 Made in T aiwan ...

Produzent Spracht Kategorie Telephone

Dokumente, die wir vom Produzenten des Geräts Spracht Voice Center cp-2010 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Spracht
- Bedienungsanleitungen Voice Center cp-2010
- Produktkarten Spracht
- Informationsbroschüren
- oder Energieetiketten Spracht Voice Center cp-2010
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Spracht Voice Center cp-2010.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Spracht Voice Center cp-2010, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Spracht Voice Center cp-2010. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Spracht Voice Center cp-2010 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Spracht Voice Center cp-2010, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Spracht Voice Center cp-2010 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Spracht Voice Center cp-2010 verständlich ist.

Eine gänzliche Bedienungsanleitung von Spracht sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Spracht Voice Center cp-2010 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Spracht Voice Center cp-2010 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Spracht Voice Center cp-2010, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Spracht Voice Center cp-2010 - die uns die ersten Schritte während der Nutzung von Spracht Voice Center cp-2010 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Spracht Voice Center cp-2010 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Spracht Voice Center cp-2010 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Spracht Voice Center cp-2010?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Spracht Voice Center cp-2010 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Spracht Voice Center cp-2010 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)