-
England's Stove Works 12-FPG - page 1
INSTALLATION & OPERATION MANUAL MODEL NUMBERS: 12-FPP 50-SFP12P 50-TFP12P 12-FPL 50-SFP12L 50-TFP12L 12-FPG 50-SFP12G 50-TFP12G Thank you for purchasing this product from a fine line of heating equipment. We wish you many years of safe heating pleasure with your new heating appliance. Save These Instructions. IMPORTANT: IF YOU HAVE A PROBLEM WI ...
-
England's Stove Works 12-FPG - page 2
2 A letter from our Techni cal Support department : Thank you for purchasing this fine produ ct from England’s Stove Works! England's Stove Works was started, and is still owned by, a family that believes strongly in a "Do It Yourself" spir it – that’s one reason y ou found this product at your favorite “Do It Yourself” sto ...
-
England's Stove Works 12-FPG - page 3
3 CAUTION If you have any doubt concerning your ability to complete your installa tion in a professional- like manner after reading these instructions, you should obtain the services of an installer who is versed in all aspects as to the correct and safe installation. Do not use temporary, makeshift compromises during installation. BEFORE INSTALLAT ...
-
England's Stove Works 12-FPG - page 4
4 OPERATION WHY THE CORRECT FLUE SIZE IS IMPORTANT: 6” “Draft” is the force that moves air from the appliance up through the chimney. The amount of draft in your chimney depends on the length of the chim ney, local geography, nearby obstructions, and other factors. Too much draft may cause excessive temperatures in the app liance. An uncontro ...
-
England's Stove Works 12-FPG - page 5
5 FLUE SYSTEM 1. Existing Flue System If you have chosen a freestanding unit, this stov e is designed to conn ect to an existing flue system, such as masonry or a pre-manufactured Class A flue syste m. If you have a masonry flue system, the inner liner should be inspected carefully for cracks; if there is no liner in your chimney, we recommend you ...
-
England's Stove Works 12-FPG - page 6
6 INSTALLATION AP PLICATIO NS Illustration 1 10.5” Mi n. 10.5” Mi n. 10.5” Mi n. 18” Min. 18” Min. NOTE: 1 . Horizontal run not to exceed 6’. 2. Total flue length should not exceed 25’. 3. Floor protection required: Min. size 48” x 48”. 4. Always check local codes for clearances, installation, etc. Class “A” Chimney System See ...
-
England's Stove Works 12-FPG - page 7
7 INSTALLATION AP PLIC ATIO NS, Con t’d . Illustration 1b ...
-
England's Stove Works 12-FPG - page 8
8 8” Pre-Manufactured Flue System : In the past few years pre-manufactured flue systems have become very popular, because this type system is easily installed and, when done correctly, is very safe. There are many pre-manufactured flue systems on the market, and when making your choi ce it should be U.L., B.O.C.A. or I.C.B.O. approved. Any of the ...
-
England's Stove Works 12-FPG - page 9
9 Installation on a Combustible Floor If the appliance is to be installed on a combustible floor or a combustible floor covering, it must be installed on a 1” thick non-combustible millboard floor protector or a durable equivalent, with a “R” factor of no less than “2.” The pad must be installed beneath the unit, extending 16” (U.S.) on ...
-
England's Stove Works 12-FPG - page 10
10 3. Side Heat Shields This accessory item comes with the hardware (six (6) mounting screws) necessary to install it on the rear of the stove. This is a two-piece heat shield, but is installed one piece at a time. There are pre- punched holes on each side of the Rear Heat Shield; while holding each piece of the Side Heat Shield in place, align the ...
-
England's Stove Works 12-FPG - page 11
11 FREESTANDING PLACEMEN T AND INSTALLATION The first problem you may encounter is getting your stove into your home -- all of our stove products are well constructed, which makes them rather heavy. Three to four adults can norm ally handle a unit, but we still recommend using a handcart. Never attempt to handle a heating product alone !!! The door ...
-
England's Stove Works 12-FPG - page 12
12 INSTALLATION 1. Remove all parts from inside the stove body. (If you purchased a leg unit, and it has the factory packaging, remove the body of the stove from the shroud that it is attached to, referring to Illustration 7 later in this manual. Those instructions detail how to exchange legs and pedestal, but removal of the shroud is accomplished ...
-
England's Stove Works 12-FPG - page 13
13 CHIMNEY OPERATION Do not use a grate or elevate the fire. Build the wood fire directly on the bricks. When the stove is used for the first time, solvents in the paint will smoke off as the stove “cures.” WOOD – This heater is designed to burn natural wood only. Higher efficiency and lower emissions generally result when burning air-dried s ...
-
England's Stove Works 12-FPG - page 14
14 FIRST FIRE – Remember to ventilate well. Allow the stove to cure before burning for long periods of time at high te mperatures. Flat spots on the painted surface are normal. Shiny spots on the painted surface (before burning) are normal. Call Technical Support at (800) 245-6489 if you have any questions. BUILDING A FIRE 1. ...
-
England's Stove Works 12-FPG - page 15
15 GLASS CARE The following use and safety tips should be observed: 1. Inspect the glass regularly for cracks or breaks. Surface scr atches are acceptable and normal, but if you detect a crack or a break, extinguish the fire immediately, and contact your dealer or Technical Support at (800) 245-6489 for replacement (or log on to www.englanderstoves ...
-
England's Stove Works 12-FPG - page 16
16 The following steps should be followed for replacement of the door gasket : 1. Ensure the appliance is not in operation and is thoroughly cooled. 2. Remove the old door gasket and clean the gasket channel. 3. Using an approved high-temperature gasket cement, apply a thin coat in the bottom of the channel. 4. Starting at the hinge side of the doo ...
-
England's Stove Works 12-FPG - page 17
17 ASH DISPOSAL Regularly inspect the ash build-up in your unit and remove as necessary. Ashes can be removed from the unit by shoveling them off the fir ebrick. This unit has an ash drawer plate (see Illustration 4 ) that can be removed from the stove; once removed, the ashes can be raked through the opening and into the ash pan. Caution: The ash ...
-
England's Stove Works 12-FPG - page 18
18 IMPORTANT: HELPFU L HINTS AND TIPS WORTH REVIEWING 1. What is the correct way to start a fire? You will need small pieces of dry wood (kindl ing) and paper. Use only newspaper or paper that has not been coated or that has had materials glued or applied to it. Never use coated or colored paper (such as advertising flyers). Open the door o ...
-
England's Stove Works 12-FPG - page 19
19 7. Is it normal for soot to cover the glass at the beginning of a fire? This stove has been built with an air wash system that will help keep the glass clear when the firebox has reached a good operating temperature, and also has a good dr aft. Cold firebox temperature and poor draft cause soot to form on the glass. Once the firebox temperat ...
-
England's Stove Works 12-FPG - page 20
20 PARTS, ACCESSORIES AND OPTIONS LIST (Options and trim (i.e. brass and nickel) interchange for variety. Gold door and legs may also be ordered to replace existing door and pedestal or regular cast legs.) REPLACEMENT PARTS AC-G17 DOOR GLASS KIT WIT H GASKET (16 ½ “ x 9 ¼ “ x .197”) AC-GGK DOOR GLASS GASKET KI T (gasket only, no glass) AC-D ...
-
England's Stove Works 12-FPG - page 21
21 You may write your unit’s Manuf actur e Date and Serial Num ber in the blank spaces on this sam ple tag, for future reference. This sample tag also shows the safety info. such as UL testing standard, etc. for your local officials, or anyone else wh o may need reference info rmation. ...
-
England's Stove Works 12-FPG - page 22
22 Have this information on hand if you phone the factory or your dealer regarding this product. Retain for your files: Model Number __________________________ Date of Purchase ________________________ Date of Manufacture _________________ Serial #_____________________ LIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER The manu ...
-
England's Stove Works 12-FPG - page 23
23 WARRANTY REGISTRATION for England’s Stove Works Purchased by (Name) ______________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ Telephone _______________________________________________________ Email Address _______________ ...
Haben Sie eine Frage bezüglich England's Stove Works 12-FPG?
Nutzen Sie das untere Formular
Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit England's Stove Works 12-FPG nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit England's Stove Works 12-FPG hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.