Bedienungsanleitung Sima Products SSW-4

8 Seiten 0.14 mb
Download

Zur Seite of 8

Summary
  • Sima Products SSW-4 - page 1

    Speaker Selectors Models SSW-4 and SSW-6 User Manual (SSW-4) (SSW-6) ...

  • Sima Products SSW-4 - page 2

    Page 2 Table of Contents Important Safety Precautions ............................................................. 2 What’s Included ................................................................................... 2 Introduction.......................................................................................... 3 Front Panel ........... ...

  • Sima Products SSW-4 - page 3

    Introduction The Sima speaker selectors have been designed to let you add additional speakers around your home or office and turn them on and off without purchasing additional amplifiers. The Sima speaker selectors have the following features: • Ability to add up to 4 (SSW-4) or 6 (SSW-6) speaker pairs to your amplifier • Left and right “comm ...

  • Sima Products SSW-4 - page 4

    Typical Hook up The diagram below shows a overview of a typical sy stem with the SSW-6 using 6 speaker pairs. Figure 3, Overview of typi cal system (SSW-6 shown) Installation Tips • It is recommended to use 18 or 16 AWG gauge stranded wire. For runs longer than 50’, 14 gauge is recommended. • You can mix 4, 6, 8 and 16 ohm speakers. • Since ...

  • Sima Products SSW-4 - page 5

    • Push the tab and simultaneously insert the wire into the correct hole. • Verify that there are no wire frays. Connect the wires from the speaker output from your receiver or amplifier to the SSW-4/6 terminals m arked AMPLIFIER. Pay attention and connect the “+” output from the right front output on the amplifier to the right “+” input ...

  • Sima Products SSW-4 - page 6

    Page 6 Refer to your amplifier or receiver’s user manual or on the rear panel of the amplifier to determine the minimal speak er impedance that your amplifier can handle. If your amplifier can handle 4 ohm loads 4 ohm speakers 6 ohm speakers 8 ohm speakers 16 ohm speakers 1 selected Protection OFF Protection OFF Protection OFF Protection OFF 2 se ...

  • Sima Products SSW-4 - page 7

    Page 7 Trouble Shooting Problem Solution No sound Make sure correct speaker is selected. Make sure no wires are touching each other or the case of the amplifier or SSW-4/ S SW-6 selector. One or both speakers turn off when music is playing Reduce volume level and unit will automatically reset. Internal protection circuit is detecting overload or ex ...

  • Sima Products SSW-4 - page 8

    Limited Warranty Limited Warranty Sima Products Corp. (“Com pany” ) warrants th at is the accom panying product proves to be defective to the original purch aser in material or workm anship within 90 days from the original retail purchase, the Co mpany will, at the Company’s op tion, either repair or replace same without charge (but no cash r ...

Produzent Sima Products Kategorie Speaker

Dokumente, die wir vom Produzenten des Geräts Sima Products SSW-4 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Sima Products
- Bedienungsanleitungen SSW-4
- Produktkarten Sima Products
- Informationsbroschüren
- oder Energieetiketten Sima Products SSW-4
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Sima Products SSW-4.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Sima Products SSW-4, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Sima Products SSW-4. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Sima Products SSW-4 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Sima Products SSW-4, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Sima Products SSW-4 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Sima Products SSW-4 verständlich ist.

Eine gänzliche Bedienungsanleitung von Sima Products sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Sima Products SSW-4 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Sima Products SSW-4 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Sima Products SSW-4, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Sima Products SSW-4 - die uns die ersten Schritte während der Nutzung von Sima Products SSW-4 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Sima Products SSW-4 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Sima Products SSW-4 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Sima Products SSW-4?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Sima Products SSW-4 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Sima Products SSW-4 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)