Bedienungsanleitung Trek 11i

27 Seiten 0.9 mb
Download

Zur Seite of 27

Summary
  • Trek 11i - page 1

    C L K T M E A V G M A X T R P A V G M P H F             This manual explains the installa- tion and use of the Trek Incite 9i and 11i bicycle computer . Please read this manual carefully and ...

  • Trek 11i - page 2

       Safety and general guidelines .................................................. 1 F unctions .................................................................................. 2 Installation ................................................................................ 4 Placing the computer on the handlebar .... ...

  • Trek 11i - page 3

          While riding your bicycle, do not stare at the computer for long periods of time (Figure 1). If you do not watch the road, you could hit an obstacle, which may cause you to lose control and fall. Make sure the computer wire cannot contact the tire or whe ...

  • Trek 11i - page 4

                      ...

  • Trek 11i - page 5

                   ...

  • Trek 11i - page 6

         T ools needed: • Electrical tape • Slot-type screwdriver • Phillips-type screwdriver • Scissors  Stem mount Handlebar mount Speed sensor  ? ...

  • Trek 11i - page 7

            The Trek Incite 9i or 11i computer can be mounted on the handlebar or on the stem (Figure 3).        1. Select the bar c ...

  • Trek 11i - page 8

      Check that the computer base cannot be rotated around the handlebar , and that the computer cannot slide backwards on the computer base (Figure 5).         1. Insert the rubber friction pad into the compu ...

  • Trek 11i - page 9

        The wheel magnet must be aligned so that it passes across the sensor . As the magnet passes the sensor , it must be no further from the sensor than 1 to 3mm (1/32 to 1/8 inch). The wheel magnet has a ‘T’ shaped slot with two configura- tions: round spokes and flat or bladed spokes (Fi ...

  • Trek 11i - page 10

        The computer wire is usually longer than needed. Extra wire length can be diverted by wrapping it around the brake housing prior to routing it down the fork blade or down tube (Figure 8). Make sure the computer wire is not pulled tight when the handlebar is turn ...

  • Trek 11i - page 11

         The magnet must pass across the line on the sensor (Figure 9). These instructions are written for the front wheel, but apply equally to installing the magnet and cadence sensor which go on the lef t crank and the frame’s chainstay (Figure 10).   ? ...

  • Trek 11i - page 12

     and magnet by spinning the wheel and noting if the computer is displaying speed. If the computer shows current speed, the sensor is r eading the magnet. If the computer is not displaying a value, realign the sensor and magnet until one is displayed. 5. Tighten the nylon ties and trim the excess length (Figure 11).  ...

  • Trek 11i - page 13

          Y ou can program the starting values of your computer in a single, easy procedure: • Units • Clock • Wheelsize • Odometer The Units setting tells the computer which conversion to use: metric or SAE (“English”): MH = miles KMH = kilometers Y ou can set the clock for 12 or ...

  • Trek 11i - page 14

         CL K TME A VG MA X TRP A VG MPH F       Mode Set When setting the computer , t ...

  • Trek 11i - page 15

     CLK TME AVG MAX TRP ODO MH Mode Set 3. Cycle Mode MH and KMH inter change on the screen. 4. Push Set• to select. The temperature icon display . 5. Cycle Mode to C or F 6. Push Set• to select. The computer returns to the start scr een.     1. Cycle Mode to ODO (Figure 13). 2. Hold S ...

  • Trek 11i - page 16

     CLK TME AVG MAX TRP ODO MH Mode Set     Both the 9i and 1 1i allow you to use two differ ent wheel sizes. The icon for Wheel 1 is a small cir cle. The icon for Wheel 2 is a partial circle surr ounding the Wheel 1 icon (Figure 14).   1. Cy ...

  • Trek 11i - page 17

     CLK TME AVG MAX TRP ODO MH Mode Set      1. Cycle Mode to TRP 2. Hold the lef t Mode and the right Mode together . The Wheel Select icon changes (Figure 14). Repeat step 2 to change again.   ...

  • Trek 11i - page 18

    CLK TME AVG MAX TRP ODO MH Mode Set    1. Cycle Mode to CLK (Figure 15). 2. Hold Set• “12” or “24” flashes.   CL K TM E AV G MAX TR P A VG MPH F   3. Cycle Mode 12 and 24 inte ...

  • Trek 11i - page 19

     CLK TME AVG MAX TRP ODO MH Mode Set          Y our computer stores data for two intervals- since last ReSet and since last R eStart. R eSet sets ALL data to zero. R eStart sets only the Trip data to zero. The trip modes include • TRP • TME • MAX T ...

  • Trek 11i - page 20

     CLK TME AVG MAX TRP ODO MH Mode Set       Once the computer is programmed and installed, it is very easy to use. To change to different modes (functions), simply Cycle the Mode button until the desired function appears, shown by the spell ...

  • Trek 11i - page 21

       The Incite 9i computer is designed to be easy to install and maintain. However , computers occasionally have problems. T able 3 shows some possible problems, causes, and solutions:      ...

  • Trek 11i - page 22

           If the computer is giving erratic information, the computer or hear rate strap battery may be running low on power (normally accompanied by the low battery icon, Figure 16). R eplace the batteries whenever the computer malfunctions, or every 6 months. When purchasing new ba ...

  • Trek 11i - page 23

      4. Lif t the battery cover , exposing the battery . Be careful to avoid losing the rubber O-ring seal. 5. R emove the old battery . It may be possible to shake the battery out. Otherwise, carefully pry the battery up with a thin tool or knife blade. 6. Insert the new battery wit ...

  • Trek 11i - page 24

     CLK TME AVG MAX TRP ODO MH Mode Set       The procedure is almost the same as the basic setup on pages 13-14, except instead of picking a wheel size from the menu, you can program in a 4-digit number .  ? ...

  • Trek 11i - page 25

     CLK TME AVG MAX TRP ODO MH Mode Set 4. Push Mode to select. Wheel size appears. Note : If you want to set a cus tom wheel size, go to pa ge 24 now . 5. Cycle Mode through the wheel sizes tro the 4-digit number . 6. Push Set• The left-hand digit flashes. 7. Cycle Mode to the desired value. 8. Push Set• to select. The next digit flashes. 9 ...

  • Trek 11i - page 26

               T able 1 approximates the circ ...

  • Trek 11i - page 27

          Tr ek Bi cyc le Co rpo ra ti on war ra nt s ea ch new In ci te c om pu ter ag ai ns t de fe ct s in wo rk man sh ip and ma te ria ls .    Tr ek In cit e c om put er mo del s 6 i, 8i, ...

Produzent Trek Kategorie Bicycle

Dokumente, die wir vom Produzenten des Geräts Trek 11i erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Trek
- Bedienungsanleitungen 11i
- Produktkarten Trek
- Informationsbroschüren
- oder Energieetiketten Trek 11i
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Trek 11i.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Trek 11i, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Trek 11i. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Trek 11i ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Trek 11i, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Trek 11i hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Trek 11i verständlich ist.

Eine gänzliche Bedienungsanleitung von Trek sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Trek 11i bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Trek 11i befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Trek 11i, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Trek 11i - die uns die ersten Schritte während der Nutzung von Trek 11i erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Trek 11i hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Trek 11i im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Trek 11i?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Trek 11i nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Trek 11i hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)