-
Tripp Lite 230/400 - page 1
Owner’ s Man ual 1111 W. 35th Street • Chicago, IL 60609 USA (773) 869-1234 • www .tripplite.com Copyright ©2005 T ripp Lite. All rights reserved. SmartOnline™ is a trademark of Tripp Lite. Smar tOnline ™ 3-Phase 20kV A & 30kV A Intellig ent T rue On-Line UPS Systems Input/Output* V oltage: 220/380, 230/400, 240/415V AC, 3ø, 4 wire ...
-
Tripp Lite 230/400 - page 2
2 Impor tant Safety W arnings SA VE THESE INSTRUCTIONS. This manual contains important instructions and warnings that should be followed during the installation and maintenance of all T ripp Lite SmartOnline 3-Phase 20kV A and 30kV A UPS Systems and their batteries. UPS Location W arnings • Install your UPS indoors, away from heat, direct sunligh ...
-
Tripp Lite 230/400 - page 3
1 2 3 4 13 12 7 10 11 9 8 5 6 3 Contr ol P anel There are two separate UPS system modules: a power module and a battery module. Familiarize yourself with the location and function of the features on each module before installing and operating your UPS system. The power module is the only module which includes front panel features. FRONT P ANEL 1. ? ...
-
Tripp Lite 230/400 - page 4
4 Rear P anels 1. Manual Bypass Switch: This dial is used in one step of putting the UPS in "BYP ASS” mode, which must be done before performing any maintenance on the UPS with the connected load supported. [See “Operation (Special Conditions)” for step-by-step instructions for going into “BYP ASS.”] While this switch is on “BYP AS ...
-
Tripp Lite 230/400 - page 5
5 Rear P anels (continued) Refer to the Battery Module's Owner's Manual f or all safety warnings and connection instructions. 14. Fuse Holder (externally accessible): fuses protect against short circuit damage. If a heavy overload or short circuit is encountered, a fuse will blow . A Battery Module with a blown fuse will not deliver any o ...
-
Tripp Lite 230/400 - page 6
6 Installation UPS LOCA TION Move your UPS over short distances using its wheels. Stabilize the UPS by releasing the stabilizers on each side of the unit. N OTE: Do not stack the UPS System power module or external battery modules. UPS PO WER MODULE INPUT AND OUTPUT HARD WIRE CONNECTION In addition to the instructions listed below , follow all warn ...
-
Tripp Lite 230/400 - page 7
7 Installation (continued) Operation (Normal Conditions) TURNING THE UPS ON • Make sure the UPS is properly installed (see Installation section) and the Manual Bypass Switch is set to NORMAL. • T urn the AC Input and Bypass AC Input Circuit Breakers ON. • If your AC input is providing power normally within your selected range, your connected ...
-
Tripp Lite 230/400 - page 8
8 Operation (Normal Conditions) (continued) SELF-TESTING When you turn the UPS ON, it will perform a brief self-test. See charts below for display sequences. Display sequence when AC input power is present: Display sequence when AC input power is absent: SELF TESTING ... (possible only with the "Battery Start" Switch) RECTIFIER OK SELF TE ...
-
Tripp Lite 230/400 - page 9
9 INVERTER ON W ARNINGS When the inverter is ON, the LCD Display may show any one of the following warnings: Condition LCD Display Message UPS Output Overload OVERLOAD 1 10% UPS Charger Failure CHARGER F AILURE Abnormal Input Frequency FREQUENCY ERROR Abnormal Input Phase PHASE ABNORMAL! Battery is Depleting* ON BA TTER Y Battery Charge is Nearly D ...
-
Tripp Lite 230/400 - page 10
10 Condition LCD Display Message Overload Shutdown ON BYP ASS OVERLOAD 150% SHUTDOWN... VERSION: XXXXXXX UPS Output Short Circuit ON BYP ASS SHOR T CIRCUIT! SHUTDOWN... VERSION: XXXXXXX Overtemperature ON BYP ASS HIGH TEMP! SHUTDOWN... VERSION: XXXXXXX DC BUS Overvoltage ON BYP ASS DC BUS O.V .P .! SHUTDOWN... VERSION: XXXXXXX DC BUS Failure ON BYP ...
-
Tripp Lite 230/400 - page 11
DR Y CONT ACT INTERF A CE This female DB9 contact-closure port allows your UPS to send contact-closure signals to indicate that it is in battery back-up mode and that its batteries are running low . The port can also receive a remote shutdown signal. DR Y CONT ACT INTERF ACE T ABLE UPS Operating Mode Pin 8,3 Pin 1,3 Normal OPEN OPEN Back Up CLOSE * ...
-
Tripp Lite 230/400 - page 12
12 Comm unications (continued) REMO TE EMERGENCY PO WER OFF (EPO) This optional feature is only for those applications which require connection to a facility's Emergency Power Of f (EPO) circuit . When the power module is connected to this circuit, it enables emergency shutdown of the output. Using the included cable, connect the p ower mod- u ...
-
Tripp Lite 230/400 - page 13
Model: SU20K3/3X Includes: • Power Module • Battery Module Model: SU20K3/3INTPM Model: BP240V33 Input Input V oltage: 220/380, 230/400, 240/415V AC , 3ø , 4 wire (plus ground), wye Input F requency 50/60 Hz ± 3 Hz (auto-selectable) V oltage Correction Range: 156-280/270-485V A C Input Current (P er Phase, On-Line) 30A/29A/28A Inrush Current & ...
-
Tripp Lite 230/400 - page 14
1111 W . 35th Street, Chicago, IL 60609 USA 773.869.1234 (USA) • 773.869.1212 (International) www .tripplite.com 2009XXXXX 93-2260_ES ...
¿Tienes una pregunta acerca de Tripp Lite 230/400?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Tripp Lite 230/400, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Tripp Lite 230/400 probablemente compartirá una forma de solucionarlo.