-
Echo SRM-210 - page 1
Grass T rimmer/Brush Cutter Operator's Manual MODEL SRM-210 Serial Number 05001001 - 05999999 W ARNING DANGER Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual and a Safety Manual. Both must be read and understood for proper and safe operation. X7712270301 X771000041 11/02 ...
-
Echo SRM-210 - page 2
2 T ABLE OF C ONTENTS Introduction ........................................................................ 2 - The Operator's Manual ............................................... 2 - The Safety manual ....................................................... 2 Manual Safety Symbols and Important Information ......... 3 Safety ................ ...
-
Echo SRM-210 - page 3
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 3 The circle with the slash symbol means whatever is shown within the circle is prohibited. M ANUAL S AFETY S YMBOLS AND I MPORT ANT I NFORMA TION IMPORTANT The enclosed message provides information necessary for the protection of the unit. NOTE This enclosed message provides tips for use, ...
-
Echo SRM-210 - page 4
4 Shaft Decal W ARNING DANGER • This unit can be dangerous and cause serious injury if improperly used. To reduce injury risk to operator, helpers and bystanders, read and understand the Operator's and Safety manuals. • Blindness can occur from objects that are thrown or ricocheted even with shield in place. Operators, helpers and bystande ...
-
Echo SRM-210 - page 5
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 5 S AFETY I NSTRUCTIONS PERSONAL CONDITION AND SAFETY EQUIPMENT W ARNING DANGER Trimmer/Brush Cutter users risk injury to themselves and others if the trimmer/brush cutter is used improperly or safety precautions are not followed. Proper clothing and safety gear must be worn when operating ...
-
Echo SRM-210 - page 6
6 Repetitive Stress Injuries It is believed that overusing the muscles and tendons of the fingers, hands, arms and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI). An extreme RSI condition is Car ...
-
Echo SRM-210 - page 7
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 7 SAFE OPERA TION W ARNING DANGER Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Provide all operators of this equipment with the Operator's Manual and instructions for safe op ...
-
Echo SRM-210 - page 8
8 D ESCRIPTION The ECHO product you purchased has been partially assembled for your convenience. Due to packaging restrictions, installation of the plastic debris shield, nylon line head, and positioning of the front handle are necessary. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missi ...
-
Echo SRM-210 - page 9
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 9 12 18 Safety Video 20 11 13 14 15 16 17 19 1 2 5 6 7 8 9 10 4 3 ...
-
Echo SRM-210 - page 10
10 1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter. 2. GRIP - Rear (right hand) handle. 3. THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout lever is engaged. 4. STOP SWITCH - "SLIDE SWITCH" mounted ...
-
Echo SRM-210 - page 11
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 11 S PECIFICA TIONS * Install and use U-Handle when operating any model with blade. MODEL ----------------------------------------------------- SRM-210 Length ------------------------------------------------------- 1778 mm (70.0 in.) Width -------------------------------------------------- ...
-
Echo SRM-210 - page 12
12 PLASTIC SHIELD INST ALLA TION (for Nylon Line Operation) Tools Required: Screwdriver. Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm screws. NOTE The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic or metal blades. 1 . Remove plastic sleeve and upper plate (A) from PTO shaft. 2 ...
-
Echo SRM-210 - page 13
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 13 NYLON LINE INST ALLA TION Tools Required: None Parts Required: Two (2) Pre-cut Nylon Line 8 in. X .095 in. 1 . Shut engine off. Lay unit on the ground with head assembly up. 2 . Remove old nylon line through center recess of head. 3 . Thread new lines through outside holes (A) in housin ...
-
Echo SRM-210 - page 14
14 P RE - O PERA TION OPERA TION WITH BLADES Preparing the Trimmer/Brush Cutter for Blade Use W ARNING DANGER Blade use DEMANDS specific Brush Cutter configuration. Operation without specified shield, harness, and handle can result in serious personal injury. A B C Light-Duty Use - Plastic, Nylon, or Metal Blades: Install Blade Conversion Kit, P/N ...
-
Echo SRM-210 - page 15
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 15 Plastic/Nylon Blades may be used where ever the nylon line head is used. DO NOT use this blade for heavy weeds or brush! 8 Tooth Weed/Grass Blade P/N 69600120331 is designed for grass, garden debris and thick weeds. DO NOT use this blade for brush or heavy woody growth, 19 mm (3/4 in.) ...
-
Echo SRM-210 - page 16
16 FUEL Fuel Requirements Gasoline - Use 89 Octane [R+M/2] (mid grade or higher) gasoline or gasohol known to be good quality. Gasohol may contain up to 10% Ethyl (grain) alcohol or 15% MTBE (methyl tertiary-butyl ether). Gasohol containing methyl (wood) alcohol is NOT approved. Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD (ISO/CD 137 ...
-
Echo SRM-210 - page 17
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 17 B O PERA TION ST ARTING COLD ENGINE W ARNING DANGER Cutting attachment will move at high speed when engine is started. Inspect starting area for hazards such as rocks, glass, debris etc. which could be contacted by the cutting attachment when starting. Keep helpers and bystanders at lea ...
-
Echo SRM-210 - page 18
18 ST ARTING W ARM ENGINE The starting procedure is the same as Cold Start except DO NOT close the choke, and do not depress throttle trigger to wide open position. W ARNING DANGER The cutting attachment should not move at idle. If attachment moves, readjust carburetor according to "Carburetor Adjustment" instructions in this manual or se ...
-
Echo SRM-210 - page 19
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 19 A M AINTENANCE Your ECHO trimmer is designed to provide many hours of trouble free service. Regular scheduled maintenance will help your trimmer achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an ECHO Service Dealer fo ...
-
Echo SRM-210 - page 20
20 MAINTENANCE INTER V ALS / T N E N O P M O C M E T S Y S E C N A N E T N I A M E R U D E C O R P D ' Q E R L L I K S L E V E L R O Y L I A D E R O F E B E S U Y R E V E L E U F E R 3 S H T N O M 0 9 R O S R U O H 6 S H T N O M 0 7 2 R O S R U O H Y L R A E Y 0 0 6 S R U O H s e r u d e c o r P e c n a n e t n i a M r e l a e D o h c E d e d ...
-
Echo SRM-210 - page 21
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 21 AIR FIL TER Level 1. Tools required: 25 - 50 mm (1 - 2 in.) Cleaning Brush Parts required: 90008 REPOWER TM AIR & FUEL FILTER KIT. 1 . Close choke (Cold Start Position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt fro ...
-
Echo SRM-210 - page 22
22 SP ARK PLUG Level 2. Tools required: T-Wrench, Feeler gauge (preferably a wire gauge), Soft metal brush Parts Required: Spark Plug, NGK BPM-8Y P/N 15901019830 1 . Remove spark plug and check for fouling, worn and rounded center electrode. 2 . Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine. ...
-
Echo SRM-210 - page 23
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 23 A B C D 1 . Disconnect spark plug lead from spark plug. 2 . Release stored energy in power spring by removing spark plug. 3 . Remove three (3) screws (A) from starter assembly and remove starter. NOTE DO NOT disassemble the starter assembly. 4 . Remove the four screws that retain the en ...
-
Echo SRM-210 - page 24
24 8 . Use a brush to remove dirt from the cylinder fins. IMPORTANT DO NOT use a metal scraper to remove dirt from the cylinder fins. 9 . Remove grass and leaves from the grid between the starter and fuel tank. 1 0 . Reassemble parts in reverse order of removal. When installing the cover, be certain: • the tabs of the deflector shield (E) are in ...
-
Echo SRM-210 - page 25
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 25 EXHAUST SYSTEM Spark Arrestor Screen Level 2. Tools required: Cross-head screwdriver, soft metal brush. Parts Required: Screen P/N 14586240630, Gasket P/N 14586642031 1 . Remove engine cover. See “Cleaning Cooling System” pages 22 & 24 for instructions. 2 . Remove spark arrestor ...
-
Echo SRM-210 - page 26
26 CARBURETOR ADJUSTMENT Engine Break-In New engines must be operated for a minimum of two tanks of fuel before carburetor adjustments can be made. During the break-in period, your engine performance will increase and exhaust emissions will stabilize. Idle speed can be adjusted as required. High Altitude Adjustment High altitude adjustment is not r ...
-
Echo SRM-210 - page 27
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 27 LUBRICA TION Level 1. Tools required: 8 mm Open End Wrench, Screwdriver, Clean rag Parts Required: ECHO ® LUBE TM 8 oz. (P/N 91014) or Lithium Base Grease. Gear Housing 1 . Clean all loose debris from gear box. 2 . Remove plug (A) and check level of grease. 3 . Add grease if necessary, ...
-
Echo SRM-210 - page 28
28 SHARPENING MET AL BLADES Three styles of metal blades are approved for use on the ECHO Brush Cutter. The 8-tooth blade can be sharpened during normal maintenance. The clearing blade and 80 tooth blade require professional service. Before sharpening, CLOSELY inspect blade for cracks (look at the bottom of each tooth and the center mounting hole c ...
-
Echo SRM-210 - page 29
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 29 T ROUBLESHOOTING W ARNING DANGER Fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark near an open spark plug opening, otherwise serious personal injury may result. T R A H C G N I T O O H S E L B U O R T M E L B O R P E N I G N E m e l ...
-
Echo SRM-210 - page 30
30 S TORAGE W ARNING DANGER During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result. Long Term Storage (over 30 days) Do not store your unit for a prolonged period of t ...
-
Echo SRM-210 - page 31
G RASS T RIMMER /B RUSH C UTTER O PERA TOR ' S M ANUAL 31 NOTES ...
-
Echo SRM-210 - page 32
S ER VICING I NFORMA TION P ARTS Genuine ECHO Parts and ECHO REPOWER™ Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number and Serial Number of the unit with you. You can find these numbers on the engine housing. For future reference, write them i ...
¿Tienes una pregunta acerca de Echo SRM-210?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Echo SRM-210, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Echo SRM-210 probablemente compartirá una forma de solucionarlo.