-
Univex 79838 - page 1
IMPORTANT MANUAL Do Not Throw Away Operator's Manual Model No. 358.798380 I HOURS (CST) ) Mort. - Sat, 7 a.m. - 7 p.m. Sun. 10 a,m. - 7 p.m. !_ ARNING READ THE OPERATOR'S MANUAL AND FOLLOW ALL WARNINGS AND SAFETY INSTRUCTIONS. FAILURE TO DO SO CAN RESULT IN SERIOUS INJURY. Always Wear Eye Protection ® . CRRFTSMRN 12 AMP MOTOR . 165 MPH A ...
-
Univex 79838 - page 2
,, , , , ................. ii iiiiiiil,llll IH I IIIl,l,ll I II I II I IIII " II II ............. , ............... IMPORTANT WARNINGS & SAFETY INSTRUCTIONS , ,,,,,,,, ................................. _ ................ _ ................................ WARNING I The warnings and safety instructions in this manual must befollowed to redu ...
-
Univex 79838 - page 3
IMPORTANT WARNINGS & SAFETY INSTRUCTIONS ....................... open'ing, damaging the unit, property, or causing seri_ ous injury to bystanders or operator. • Stop the motor and disconnect the power source before opening the air inlet door or attempting to insert • Do not overreach or use from unstable surfaces or remove the vacuum t ...
-
Univex 79838 - page 4
CONGRATULATIONS on your purchase of a Sears Craftsman Electdc Blower/vac. It has been d(tsigned, engineered and manufactured to give you the best possible dependability and performance. Should you experience.any problems you,cannot.easily remedy, please contact your nearest Sears Service Center/Department. Sears has competent, well trained technici ...
-
Univex 79838 - page 5
i ii ii ii ii iii ....... _nl iiii iii iiiii L TABLE OF CONTENTS .............. J ...................... Safety Rules .................................. 2 Product Specifications .......................... 4 Customer Responsibilities .................... 4,12 Warranty ..................................... 4 Accessories .............................. ...
-
Univex 79838 - page 6
HARDWARE CONTENTS IL II= I Ill II Operator's Manual III Jllllllll III IL I IIIIIIIIIIIIIIIII IIIIIIII I II UJJ _ ....... PARTS PACKED SEPARATELY IN CARTON NOT SHOWN ACTUAL SIZE Concentrator Nozzle Upper Vacuum Tube Blower Tube Lower Vacuum Tube Flare Nozzle ASSEMBLY REMOVE BLOWER FR'bM CARTON - Remove loose parts included with Blower/vac. ...
-
Univex 79838 - page 7
ASSEMBLY L]] n , ,,n III I,,I n lU l, ...... ,I I II I ,_TTACHING coLLEcTION BAG (Fig. 5) • Slide the opening of the collection bag over the blower outlet. Pull the strap with Velcro tightlythroughthe buckle and secure the Velcro tabs. NOTE: Make sure the strap with Velcm is located between the motor housing and the collar on the blower outlet. S ...
-
Univex 79838 - page 8
....................................................................................... ASSEMBLY ii jilL // CHECK LIST ° Check all.fasteners. Make sure they are tight and there are no loose parts. • Make sure the blower tube is firmly seated in the blower outlet. • If you are using the unit as a blower, make sure the inlet cover is latched and ...
-
Univex 79838 - page 9
KNOW YOUR ELECTRIC BLOWER (Fig. 10) READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING "fOUR ELECTRIC BLOWER. Compare the illustrationswith your unit to famUiadze yourself with the location of the various controls and adjustments. Save this manual for future reference. TOP HANDLE / ONIOFF SWITCH COLLECTION BAG SIDE HANDLE INLET ...
-
Univex 79838 - page 10
OPERATION - SAFETY O'PERATOR SAFETY' ..... " ....... _ WARNING DO NOT ASSEMBEE OR'DISASSEMBLE THE VACUUM TUBES WHILE THE UNIT IS RUNNING, INSERTING OR REMOVING THE VACUUM= TUBES WHILE THE UNIT IS RUNNING CAN RESULT IN SERIOUS INJURY. ALWAYSSTOP THE UNIT AND DISCONNECT THE POWER SOURCE BEFORE UNCLOGGING THE UNIT OR PERFORMING ANY ...
-
Univex 79838 - page 11
STOPPING YOUR UNIT • Slide the switch to the OFF position. STARTING YOUR UNIT • Slide the switch to the LOW or HIGH position. OPERATING YOUR UNIT WARNING DO NOT USE THE UNIT WITHOUT THE BLOWER TUBES PROPERLY AT- TACHED TO AVOID FLYING DEBRIS AND/OR IMPELLER CONTACT WHICH CAN CAUSE SERIOUS INJURY. ALWAYS WEAR EYE PROTECTION TO PREVENT ROCKS OR D ...
-
Univex 79838 - page 12
,I,L,ILILIIllJIlll ' II,,lllllll,lllll I Illll Illlllllll I I ........................ ,....... CUSTOMER RESPONSIBILITIES iiii illl i =l MAINTENANCE SCHEDULE Fill in dates as you complete regular service. Check for damaged or worn parts. ,,,,, ,,,,,,, .......................... Clean unit and labels. ...... i ,,,,,,, ..... , .............. Che ...
-
Univex 79838 - page 13
Immediately prepare your unit for storage at the end of the season. STORAGE INSTRUCTIONS If our blower is to be stored for a pedod of time, clean it thoroughly before storage. Remove any dirt, leaves, debris, etc, Store in a clean dry area. • Disconnect from the power source. • Clean the entire unit. • Open Inlet coverand clean any dirt, gras ...
-
Univex 79838 - page 14
Operator's Manual Model No. 358.798380 IF YOU NEED REPAIR SERVICE OR PARTS: REPAIR SERVICE 1-800-4-REPAIR (1-800-473-7247) ORDERING PARTS 1-800-FON-PART (1-800-366-7278) i .... HOURs (csn i ! Mon.-Sat. 7a.m.-7 p.m. ! I Sun. 10 a.m. - 7 p.m. j II CRRFTSMRN o 12 AMP MOTOR 165 MPH Air Velocity E BLOWER/VAC Each Electric BlowerNac has its own mode ...
¿Tienes una pregunta acerca de Univex 79838?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Univex 79838, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Univex 79838 probablemente compartirá una forma de solucionarlo.