-
Hoover 53425 - page 1
. /I d HOOVER@ Deluxe Uprtght Cleaner Read this manual before operating the cleaner Owner’s Manual ENGLISH + pp.l-14 ESPAflOL + p&g 15-22 FRANGAlS -8 p. 23-29 This cleaner was inspected and packaged carefully before being shipped from the factory. If you should happen to need assistance during assembly or operation call l-900-944-9200 for an ...
-
Hoover 53425 - page 2
Fill in and retain The model’and serial number are located on the bottom of the cleaner. For your personal records, please enter the COMPLETE model and serial number In the spaces provided and.retain this information. Your cleaner is model and has serial number It is suggested that you attach your sales receipt to this owner’s manual. Vertficat ...
-
Hoover 53425 - page 3
it is extremely important to read and follow all the instruction steps in order. The assembled cleaner will look like this drawing. If you need assistance with any step of the assembly, call I-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) or - l-330-499-9499 to speak with a representative in our Consumer ...
-
Hoover 53425 - page 4
’ Stats& Assemble Note: The white switch lock above the ON/Off switch, aids in assembly of your cleaner. Assembly can be continued if the switch lock is missing. However, do not remove the switch lock until assembly is completed. Align upper handfe and lower handle as shown. D B- I Place upper (C) and lower (D) handle parts on a fiat surface, ...
-
Hoover 53425 - page 5
I I I Pull bracket toward bottom of handle slightly to make sure bracket is locked in place. Make sure hole in bracket aligns with hole in handle. With ON/OFF switch to the front, place assembled handle down onto extension on cleaner base. Rock handle side to side while pushing down firmly. Extra pushing effort may be required. Push bolt into hole ...
-
Hoover 53425 - page 6
. Sqep 5 AHach paper bag Align opening in paper bag with dirt tube (S) inside bag compartment. Push paper bag firmly onto tube. Tuck top and bottom of paper bag into bag compartment. To replace bag door, insert the 2 tabs on bottom of bag door into the 2 slots on bag compartment. Make sure all edges of paper bag are completely inside the bag compar ...
-
Hoover 53425 - page 7
cleaner description 16 ld Operate cleaner only at voltage specified on data plate on bottom of cleaner. This cleaner is intended for household use. The assembled cleaner will look like the drawing. 1. Handte 2. ONIDFF switch 3. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release. 4. Furn ...
-
Hoover 53425 - page 8
$sr&et height adjust- For ease in sliding the control, the han- dle should be in the upright position. When it is necessary to raise and lower the front of the- cleaner (A) for various carpet pile heights, slide the carpet height control (3) to the correct setting. The front of the cleaner will not move into the adjusted position until the hand ...
-
Hoover 53425 - page 9
B. Select proper clean- C. Attach wand and ing tool tools A. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, Venetian blinds, baseboards, shutters, and registers. B. Furniture nozzle may be used for upholstered furniture, draperies, tapestries, mattresses, dothing, automobile interiors, and carpeted stai ...
-
Hoover 53425 - page 10
Changing ,filter ,bag Disconnect cleaner from electrical outlet. Removing-bag door Pull bag door latch forward and remove door from cleaner. Grasp bag collar and pull collar from tube. Note: Do not clean out old bag and reuse. Discard used bag. Mxwing and installing filter Align opening in new filter bag with dirt tube (B) inside bag compartment. P ...
-
Hoover 53425 - page 11
Belt. replacement, The -belt on your .HOOVER cleaner causes the agitator to rotate- and is important-for the effective operation of the cleaner.- The belt is located under the bottom-plate of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace L To check belt, remove bottom plate as How to replace ...
-
Hoover 53425 - page 12
b Edge groomer Lubrication - I- replacement When to replace The edge groomers, located on both sides of the front of the cleaner, should be replaced when they no longer extend past the surface of the bottom plate. What to buy When purchasing edge groomers, ask for HOOVER part No. 39511004. Replacing edge groomers Disconnect cleaner from electrical ...
-
Hoover 53425 - page 13
Clearing blockages Remove large items from surfaces before vacuuming to prevent blockages and to maintain cleaning effectiveness of your cleaner. Refer to the following steps to check for- blockages continuing with each step until the blockage is found. A. lf a blockage occurs during tool use: Turn cleaner OFF and disconnect it from the electrical ...
¿Tienes una pregunta acerca de Hoover 53425?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hoover 53425, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hoover 53425 probablemente compartirá una forma de solucionarlo.