-
NEC MultiSync LCD2180UX - page 1
MultiSync LCD2180UX User’ s Manual ...
-
NEC MultiSync LCD2180UX - page 2
Inde x W arning, Caution ............................................................................................................... ............ English-1 Declaration ..................................................................................................................................... English-1 Canadian Depar tment of Comm unica ...
-
NEC MultiSync LCD2180UX - page 3
English English-1 W ARNING CA UTION CA UTION: T O REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE PO WER CORD IS UNPLUGGED FROM W ALL SOCKET . TO FULL Y DISENGA GE THE POWER T O THE UNIT , PLEASE DISCONNECT THE POWER CORD FR OM THE AC OUTLET .DO NOT REMO VE COVER (OR BA CK). NO USER SER VICEABLE P ARTS INSIDE. REFER SER VICING T O QUALIFIED SER VICE P ...
-
NEC MultiSync LCD2180UX - page 4
English-2 Canadian Depar tment of Comm unications Compliance Statement DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations . C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22.2 No . 60950-1. FCC Inf ormation 1 . Use the attached ...
-
NEC MultiSync LCD2180UX - page 5
English English-3 Contents Y our new NEC MultiSync LCD monitor box* should contain the f ollowing: • MultiSync LCD2180UX monitor with tilt/swiv el/pivot/height adjust stand • P ower Cord • Video Signal Cable (15-pin mini D-SUB male to D VI-A) • Video Signal Cable (D VI-D to D VI-D cable) • User ’ s Manual • CD-ROM • Cable Cover P ow ...
-
NEC MultiSync LCD2180UX - page 6
English-4 Quic k Star t T o attach the MultiSync LCD monitor to your system, f ollow these instr uctions: 1. T ur n off the power to y our computer. 2. For the PC or MA C with DVI digital output: Connect the D VI signal cable to the connector of the displa y card in your system ( Figure A.1 ). Tighten all screws. For the PC with Analog output: Conn ...
-
NEC MultiSync LCD2180UX - page 7
English English-5 Figure C.1 Figure C.2 Figure D .1 Figure RL.1 INPUT2 INPUT1 V acation Switch P ower Button NEC optional product attachment. Do not use this connector unless specified. INPUT2 INPUT1 Raise and Lower Monitor Screen The monitor may be r aised or low ered in either P or trait or Landscape mode. T o raise or lower screen, place hands o ...
-
NEC MultiSync LCD2180UX - page 8
English-6 Tilt Grasp top and bottom sides of the monitor screen with your hands and adjust the tilt as desired ( Figure TS.1 ). Figure TS.1 Figure S.1 Swivel Grasp both sides of the monitor screen with your hands and adjust the swiv el as desired ( Figure TS.2 ). NO TE: Handle with care when tilting the monitor screen. Remove Monitor Stand f or Mou ...
-
NEC MultiSync LCD2180UX - page 9
English English-7 Contr ols OSM (On-Screen Manager) contr ol buttons on the fr ont of the monitor function as follo ws: T o access OSM menu, press any of the control b uttons (EXIT , , , – , +). T o change signal input, press the SELECT button. NO TE: OSM must be closed in order to change signal input. NO TE: When RESET is pressed in the main and ...
-
NEC MultiSync LCD2180UX - page 10
English-8 FINE (Analog input only) Improves focus, clarity and image stability by increasing or decreasing this setting. If the “ A uto Adjust function ” and the “ H.Size ” function do not give you a satisf actor y picture setting, a fine tuning can be performed using the “ Fine ” function. It improves focus, clearity and image stabilit ...
-
NEC MultiSync LCD2180UX - page 11
English English-9 Note: Depending on the PC and Video card used, or when another Video signal cable is attached, this function ma y not operate. OFF TIMER: Monitor will automatically pow er-down when the end user has selected a pre-determined amount of time. T ools 2 LANGU A GE: OSM control menus are av ailable in se ven languages. OSM LEFT/RIGHT : ...
-
NEC MultiSync LCD2180UX - page 12
English-10 Recommended use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NO TE THE FOLLOWING WHEN SETTING UP AND USING THE MUL TISYNC LCD COLOUR MONITOR: • DO NO T OPEN THE MONIT OR. There are no user serviceable par ts inside and opening or removing cov ers may e xpose you to dangerous shoc k hazards or other r isks. Refer a ...
-
NEC MultiSync LCD2180UX - page 13
English English-11 CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK F A TIGUE. CHECK THE FOLLOWING WHEN Y OU POSITION THE MONIT OR: • F or optimum perf ormance, allow 20 minutes f or warm-up. • Adjust the monitor height so that the top of the screen is at or slightly below e ye le vel. Y our eyes should look sli ...
-
NEC MultiSync LCD2180UX - page 14
English-12 Specifications Monitor Specifications MultiSync LCD2180UX Monitor Notes LCD Module Diagonal: 54 cm/21.3 inches Active matrix; thin film transistor (TFT) liquid View able Image Size: 54 cm/21.3 inches cr ystal display (LCD); 0.270 mm dot pitch; Native Resolution (Pix el Count): 1600 x 1200 250 cd/m 2 white luminence; 500:1 contr ast ratio ...
-
NEC MultiSync LCD2180UX - page 15
English English-13 Features ambix T echnology: Dual input technology allowing both analog and digital inputs off of one connector (D VI-I) as well as additional legacy analog suppor t off of a traditional 15-pin VGA connector . Provides traditional MultiSync technology compatibility f or analog as well as D VI-based digital compatibility for digita ...
-
NEC MultiSync LCD2180UX - page 16
English-14 T r oubleshooting No picture • The signal cable should be completely connected to the displa y card/computer . • The display card should be completely seated in its slot. • Check the V acation Switch should be in the ON position. • F ront P ower Switch and computer po wer s witch should be in the ON position. • Check to mak e s ...
-
NEC MultiSync LCD2180UX - page 17
English English-15 Appendix If you need detailed inf or mation about the controls, please use the advanced men u. <How to use the adv anced menu> • T ur n off your monitor . • T ur n on your monitor b y pushing the “ POWER ” and “ SELECT ” button at the same time f or at least one second simultaneously . • Y ou will see the Adva ...
-
NEC MultiSync LCD2180UX - page 18
English-16 Auto SW Determines the automatic adjustment lev el for A uto Adjust. The choices are “ SIMPLE ” , (Analog input only) “ FULL ” and “ DET AIL ” . Press “ + ” or “ - ” to select. Refer to the below tab le. Determines the automatic adjustment lev el as shown in the below tab le. T ag4 A uto Automatically adjusts the Imag ...
-
NEC MultiSync LCD2180UX - page 19
English English-17 T ag6 Colour Control Colour Control Systems: Six colour presets select the desired colour setting (sRGB, NA TIVE and PROGRAMMABLE colour presets are standard and cannot be changed). Colour temperature increases or decreases, in each preset. R,Y ,G,C,B,M,S: Increases or decreases Red, Y ellow , Green, Cyan, Blue, Magenta and Satur ...
-
NEC MultiSync LCD2180UX - page 20
English-18 OSM Lock Out This control completely locks out access to all OSM control functions . When attempting to activate OSM controls while in the Loc k Out mode, a screen will appear indicating the OSM controls are lock ed out. There are two types of OSM LOCK OUT: OSM LOCK OUT with BRIGHTNESS and CONTRAST control: T o activate the OSM Loc k Out ...
-
NEC MultiSync LCD2180UX - page 21
English English-19 Congratulations! Y ou have just purchased a TCO ’ 99 approv ed and labelled product! Y our choice has provided you with a product de veloped for prof essional use. Y our purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. Wh ...
-
NEC MultiSync LCD2180UX - page 22
English-20 TCO ’ 03 (White model) Congratulations! The displa y you hav e just purchased carr ies the TCO ’ 03 Displa ys label. This means that your displa y is designed, manufactured and tested according to some of the strictest quality and environmental requirements in the world. This makes f or a high performance product, designed with the u ...
-
NEC MultiSync LCD2180UX - page 23
English English-21 Disposing of y our old NEC product Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical and electronic products carr ying the mark (left) must be disposed of separately from normal household waste. This includes monitors and electr ical accessories, such as signal cabl ...
¿Tienes una pregunta acerca de NEC MultiSync LCD2180UX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con NEC MultiSync LCD2180UX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con NEC MultiSync LCD2180UX probablemente compartirá una forma de solucionarlo.