-
Hoshizaki B-1650SS - page 1
1 Hoshizaki “A Superior Degree of Reliability” www .hoshizaki.com Model B-1150SS B-1300SS B-1500SS B-1650SS Ice Bin Hoshizaki America, Inc. Issued: 2-15-2005 Revised: 8-28-200 6 I N S T R U C T I O N M A N U A L ...
-
Hoshizaki B-1650SS - page 2
2 FOREW ORD IMPOR T ANT Only qualified ser vice technicians should attempt to install, ser vice or maintain this ice bin. No such installation, ser vice or maintenance should be under taken until the technician has thoroughly read this Instruction Manual. Lik ewise , the owner/manager should not proceed to use this ice bin until the installer has ...
-
Hoshizaki B-1650SS - page 3
3 • Please re vie w this manual. It should be read carefully bef ore the ice bin is installed and used. Only qualified ser vice technicians should install, ser vice and maintain the ice bin. This manual should be made a vailab le to the technician prior to installation, maintenance or ser vice. • K eep this manual with the bin f or later ref e ...
-
Hoshizaki B-1650SS - page 4
4 I. Specifications A. Dimensions 1. B-1150SS units: mm [in.] ...
-
Hoshizaki B-1650SS - page 5
5 2. B-1300SS units: mm [in.] ...
-
Hoshizaki B-1650SS - page 6
6 3. B-1500SS units: mm [in.] ...
-
Hoshizaki B-1650SS - page 7
7 4. B-1650SS units: mm [in.] ...
-
Hoshizaki B-1650SS - page 8
8 II. Installation Instructions A. Checks Bef ore Installation IMPOR T ANT 1. This ice bin is designed and intended to be used in combination with a Hoshizaki Modular Icemaker . If used with another manuf acturer's icemaker , care must be tak en to properly suppor t and secure the icemaker in accordance with the manuf acturer's recommenda ...
-
Hoshizaki B-1650SS - page 9
9 C. Setup CA UTION It is especially impor tant that the ice bin is lev eled in both left-to-r ight and front- to-rear directions. If it is not le v el, the result could be the production of smaller or irregular shaped cubes or of ov erflow into the ice bin. See the "LOCA TION" instructions on the icemaker . 1. Unpacking the Ice Bin and ...
-
Hoshizaki B-1650SS - page 10
10 Single Icemaker Unit Dual Icemaker Units 2. Installing the Icemaker 1) Unpack the icemak er , and remov e all shipping car tons, tape(s) and pac kaging. 2) Ref er to the char ts below and also to the "SET UP" instructions on the icemaker when installing the icemaker . 3) Apply the gasket (included) to the top of the bin and around the ...
-
Hoshizaki B-1650SS - page 11
11 Fig. 3 D . Drain Connections See Fig. 3 • A drain outlet, 1" f emale thread, is located on the bottom of the ice bin. • The drain must ha ve a 1/4" f all per foot on horizontal runs to get a good flow . • The ice bin drain connection must be made separ ately from the icemak er drains . See the "W A TER SUPPL Y AND DRAIN CON ...
-
Hoshizaki B-1650SS - page 12
12 E. Final Check List 1) Is the icemaker/ice bin le v el? 2) Is the icemaker/ice bin in a site where the ambient temper ature is within +45°F to +100°F all year around? (A void sites with direct sunlight.) 3) Is there at least 6" clearance around the icemak er/ice bin f or easy maintenance and ser vice, and f or good ventilation? 4) Hav e t ...
-
Hoshizaki B-1650SS - page 13
13 III. Operating Instructions See Fig. 4 A. Baffle The baffle pre v ents ice in the bin from flo wing out onto the floor while the bin door is open. 1. Remov al 1) Rotate the back edge of the baffle up about 6 inches (15 cm). 2) Pull the baffle f orw ard. 3) Raise the baffle up to remov e. 2. Installation 1) Place the baffle into the bin t ...
-
Hoshizaki B-1650SS - page 14
14 C. Probe (Optional Accessory) The probe is used to break apar t ice when it has br idged inside the bin and will not flow into the snout. T o break apar t ice, f ollow the steps below . 1) Open the bin door . 2) Inser t the probe through the hole in the snout (just abov e the baffle). 3) Carefully mov e the probe back and f or th until ice f a ...
-
Hoshizaki B-1650SS - page 15
15 IV . Cleaning and Maintenance Instructions IMPOR T ANT Ensure all components, f asteners and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment. A. Cleaning Instructions W ARNING 1. HOSHIZAKI recommends cleaning this unit at least once a year . (See the "CLEANING INSTR UCTIONS" on the icemaker) ...
-
Hoshizaki B-1650SS - page 16
16 2. Sanitizing Procedure - Follo wing Cleaning Procedure 1) W ash all par ts cleaned in the cleaning procedure using the f ollowing sanitizing solution: 1/2 fl. oz. of a 5.25% sodium hypochlorite solution (chlorine bleach) diluted in 1 gallon of water . 2) Rinse all par ts thoroughly with clean water . 3) Reassemble in the re v erse order of the ...
-
Hoshizaki B-1650SS - page 17
17 HOSHIZAKI AMERICA, INC. 618 Hwy . 74 S., Peachtree City , GA 30269 USA TEL (770) 487-2331 F AX (770) 487-3360 www .hoshizaki.com 91A4LA10D ...
¿Tienes una pregunta acerca de Hoshizaki B-1650SS?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hoshizaki B-1650SS, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hoshizaki B-1650SS probablemente compartirá una forma de solucionarlo.