-
Logik LDW45S11 - page 1
S l i m l i n e D i s h w a s h e r I n s t a l l a t i o n / I n s t r u c t i o n M a n u a l L D W 4 5 S 1 1 LDW45S11_IB_110331.indd 1 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 2
LDW45S11_IB_110331.indd 2 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 3
3 C onten ts Unpacking ..................................................................................................................................... 5 Installation .................................................................................................................................... 6 Location .................................. ...
-
Logik LDW45S11 - page 4
4 Fr ost Precaution ......................................................................................................................... 26 Moving the Dishw asher ............................................................................................................. 26 Maintenance A fter a Prolonged P eriod of Non-Operation ............. ...
-
Logik LDW45S11 - page 5
5 Unpacking Remove all packaging from the unit. Retain the pack aging . If you dispose of it please do so accor ding to local regulations. The following items ar e included: The Main Unit Detergent Measuring Spoon x 1 1 full spoon = 20g (approx.) P .N.: 673002200079 Instruction Manual X 1 P .N.: LDW45S11-000 U-shape Hose Holder X 1 P .N.: 673006200 ...
-
Logik LDW45S11 - page 6
6 INST ALL A TION 450 580 unit in mm 850 30 850 450 620 min.100 80 450 580 850 30 850 450 620 min.100 80 level level level level Power Delay Start 1/2 Load 3in1 Intensive Normal Eco Rinse Glass Rapid Power Delay Start 1/2 Load 3in1 Intensive Normal Eco Rinse Glass Rapid 1. Please ensure the dishwasher is installed by a qualified technician. Refer t ...
-
Logik LDW45S11 - page 7
7 INST ALL A TION 4. The condensation str ip must be fitted to the underside of the worktop above your dishwasher to protect it against an y moisture. Its purpose is to protect your w orktop ’ s underside from steam rising from the dishwasher . • Ensure the surface is clean prior to stick ing the condensation strip to the underside of the wo ...
-
Logik LDW45S11 - page 8
8 INST ALL A TION 7. Make sure your plumbing is suitable for use with the dishwasher . If in doubt contact a qualified plumber . This unit MUST BE connected to C OLD W A TER MAINS using the new water inlet hose. OLD HOSE SETS MUST NOT BE RE-USED. The water pressure from the water mains needs to be at a minimum of 0.04 MPa and a maximum of 1.00MPa. ...
-
Logik LDW45S11 - page 9
9 INST ALL A TION water drain hose U-shaped drain hose holder • Y ou may use the U-shaped drain hose holder to secure your drain hose and to avoid bending it. • Secure the water drain hose to the waste pipe to av oid it coming off during the washing process. The waste pipe must only be connected to the foul drains and not the sur face wat ...
-
Logik LDW45S11 - page 10
10 Pr oduc t Overview Fr ont Vie w Rear View 1. Control P anel 2. Door Handle Power Delay Start 1/2 Load 3in1 Intensive Normal Eco Rinse Glass Rapid 2 3 1 5 4 3. Drain Hose 4. W ater Inlet (Connect T o Supply Hose) 5. Mains Cable (Connect T o Electrical Mains Outlet) LDW45S11_IB_110331.indd 10 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 11
11 Upper Basket Internal Vie w Low er Basket 6 10 11 12 13 14 15 16 7 8 9 6. Upper Basket 7. Salt R eservoir 8. Low er Basket 9. Detergent Dispenser 10. Cup Rack 11. Spray Arm 12. F ilter 13. Rinse Aid Reservoir 14. F iltering System 15. Spray Arm 16. Salt Reser voir LDW45S11_IB_110331.indd 11 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 12
12 1. ON / OFF Button • T o turn the dishwasher on and off. 2. Power On Light • Illuminates when On/Off button is pressed. 3. Display W indow ( Con trol Panel) • Prog ramme remaining time , delay time and fault codes etc . 4. Delay Start Button • Press to preset the wash timer and delay the starting time by up to 24 hours. •? ...
-
Logik LDW45S11 - page 13
13 W ash C y cle T able Programme C ycle Selec tion Information Process Detergent Amount (Pre-wash/ Main wash) Running Time (min.) Energy Consumption (K wh) W ater Consumption (I) Rinse Aid 3 I n 1 • P ots, utensils and cutler y . • Highly soiled. • Pr e -wash (50°C) • W ash (50°C ) • Rinse (70°C ) • Drying • 3 ...
-
Logik LDW45S11 - page 14
14 ● ● Small plastic items (Milk bottle nipple) Plastic items that are not dishwasher safe Crystal glasses Silverware V aluable vases Copper pots and pans Cast iron pans Cracked / Chipped china Scratched non-stick cookware T owels and sponges The Following Items Are Not Suitable Before Oper ating T o Open the Door • Pull the door handle. ? ...
-
Logik LDW45S11 - page 15
15 Y ou can choose to add a detergent tablet alone or to add deter gent powder to both the main wash detergent chamber and the pre -wash detergent chamber for your selected wash cycle. All prog rammes with pre-wash need an additional detergent dosage that must be placed in the pre-wash deter gent chamber (please refer to the wash cycle table). This ...
-
Logik LDW45S11 - page 16
16 Alternatively , you can judge the amount of rinse aid by check ing the r inse aid indicator right next to the reservoir ’ s cap . When the indicator is black, it means it is full . When it is clear , it means it is almost empty. Adjusting the Rinse Aid Reservoir The rinse aid reservoir has six settings . Both the recommended setting and the fa ...
-
Logik LDW45S11 - page 17
17 Adding Salt If the water in your area is hard, deposits will form on your dishes and utensils. This appliance con tains a salt reser voir for you to reduc e the hardness of the water . Please follow the steps below to pour the salt into the salt reservoir and it must be set to correspond to the water hardness level in your area. 1. Remove the lo ...
-
Logik LDW45S11 - page 18
18 Adjusting Salt C onsumption Salt consumption must be adjusted to correspond to the water hardness lev el in your area. I f you don’ t know how hard the wa ter in your home is, please ask the company that supplies water in your area. It is recommended that adjustments should be made in accor dance with the following char t. W ater Hardness Sele ...
-
Logik LDW45S11 - page 19
19 Loading the Dish washer Before L oading the Dishwasher Please obser ve the following notes befor e loading your cutler y and crocker y into the basket. • Remove lipstick stains and any f ood residues from crockery and dishes. Rinse if necessar y . • Dishes and cutlery must not lay inside one another , or cover each other . • Load ...
-
Logik LDW45S11 - page 20
20 Long items such as soup ladles, mixing spoons and long knives should be placed lying down across the front of the upper basket. Upper Basket Please use the upper basket for small and lightweight items such as cups, saucers, glasses, desser t bowls, etc. Shallow pans or casserole dishes can also be placed in the upper basket. remove the stop lift ...
-
Logik LDW45S11 - page 21
21 Low er Basket W e recommend that large and the most difficult to clean items are placed in the lower basket, such as plates, ser ving platters, saucepans, serving bowls, pots, pans, lids etc. W e recommend placing serving dishes and lids at the side of the basket to av oid block ing the rota tion of the spray arms. Hinged Cup Rack T o make room ...
-
Logik LDW45S11 - page 22
22 Loading the Low er Basket F or loading the lower basket, please refer to the table below. Number Item 6 Oval platter 7 Dinner plat es 8 Soup plates 9 Desser t dishes 10 Cutlery basket Cutlery Basket Loading the C utlery B ask et T o make unloading much easier , cutlery should be grouped in zones and placed in the cutler y basket. Please refer to ...
-
Logik LDW45S11 - page 23
23 Star ting a W ash C ycle Please follow the steps below to start a wash c ycle . 1. Ensure the unit is connec ted to the mains power and the water supply is on (water pressur e bet w een 0.04MPa and 1.00MPa). 2. Open the door . P ull out the lower and upper baskets, load the dishes and push the baskets back. I t is recommended that the lower bask ...
-
Logik LDW45S11 - page 24
24 S witching O the Unit T o save energy, remember to switch the dishwasher off using the ON/OFF button. The dishwasher will continue to use electricity until it is switched off with the ON/OFF button. If the dishwasher is not going to be used f or a long period of time, e.g. whilst on holiday , disconnec t the unit from the mains supply. Unload ...
-
Logik LDW45S11 - page 25
25 Internal Car e Filtering S ystem The filtering system in the base of the wash cabinet captures large par ticles of suds solution. Build up of these par ticles may cause the filters to block. Check the condition of the filters regularly and clean them if necessary under running wat er . F ollow the steps below to clean the filters in the wash cab ...
-
Logik LDW45S11 - page 26
26 Spray A rms Particles of food can get stuck in the spray arm jets and bearings. T he spray arms should ther efore be checked and cleaned regularly. • Use a pointed object, eg . a cocktail stick, to loosen f ood particles in the spray arms’ jets. F rost P recaution Av oid placing the dishwasher in a location where the temperature is below ...
-
Logik LDW45S11 - page 27
27 Hints and Tips F ault Code Codes Possible Causes Remedy E1 W ater tap is not turned on. T urn on the water tap. Low water pressure (<0.04MPa) T urn on the water tap and ensure it is in full position. Flow meter is broken. • Disconnect from the mains. • Disconnect the water inlet. • Call a qualified technician. The wire terminal ...
-
Logik LDW45S11 - page 28
28 General Problems Problem Possible Causes Remedy Detergent residue is left in the dispenser at the end of the programme . The detergent dispenser was still damp when detergent was added. Make sure the dispenser is dr y before adding detergent. The detergent dispenser lid cannot be closed properly . Clogged detergent residue is blocking the catch. ...
-
Logik LDW45S11 - page 29
29 Disposal of the Dishw asher • When disposing your old dishwasher , first make it unusable. Disconnect the hoses and unplug the mains cable. C ut off the mains cable from the dishwasher . Make the door lock inoperative, so that children cannot accidentally shut themselves in. Make appropriate arrangements for the disposal of the dishwasher . ...
-
Logik LDW45S11 - page 30
30 Specications Model LDW45S11 Dimensions 450 mm ( W ) x 580 mm (D) x 850 mm (H) Capacity 9 Place Settings W ater Pressure Required 0.04 - 1.00MP a Po wer Consumption 1930W Rated V oltage 230V/50Hz F eatures and specifications are subject to change without prior notice . LDW45S11_IB_110331.indd 30 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 31
31 Safety W arnings F or your continued safety and to reduce the risk of injur y or electric shock, please follow all the safety precautions listed below. • Read all instructions carefully befor e using the dishwasher and keep them for future referenc e. • Retain the manual. If you pass the dishwasher onto a third party, make sur e to inc ...
-
Logik LDW45S11 - page 32
32 • F or energy saving , always remember to switch the dishwasher off when you have finished using it. T he dishwasher should not be lef t unattended when in use. • Remove the door to the washing compartment when removing an old dishwasher from ser vice or discarding it. • During installation, the power supply cord must not be exces ...
-
Logik LDW45S11 - page 33
NOTE: If you requir e a replacement for any of the items listed below , please quote their corresponding part numbers: Replacement Part Part Number Cutlery Basket 673002200080 W ater Supply Hose 673000900060 Detergent Measuring Spoon 673002200079 Measuring C up 673006200004 Condensation Strip 675001300715 Salt Funnel 673002200043 U-shape Hose Holde ...
-
Logik LDW45S11 - page 34
LDW45S11_IB_110331.indd 34 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 35
LDW45S11_IB_110331.indd 35 3/31/11 5:04 PM ...
-
Logik LDW45S11 - page 36
LDW45S11_IB_110331.indd 36 3/31/11 5:04 PM ...
¿Tienes una pregunta acerca de Logik LDW45S11?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Logik LDW45S11, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Logik LDW45S11 probablemente compartirá una forma de solucionarlo.