-
Roland CUBE-60 - page 1
Owner’s Manual Thank you, and congratulations on your choice of the Roland CUBE-60 Guitar Amplifier. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s manual should be read in its e ...
-
Roland CUBE-60 - page 2
2 30 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to ...
-
Roland CUBE-60 - page 3
3 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. .......................................................................................................... 002a • Do not open or perform any internal modifica- tions on the unit. ............................................. ...
-
Roland CUBE-60 - page 4
4 015 • Do not force the unit’s power-supply cord to share an outlet with an unreasonable number of other devices. Be especially careful when using extension cords—the total power used by all devices you have connected to the extension cord’s outlet must never exceed the power rating (watts/amperes) for the extension cord. Excessive loads c ...
-
Roland CUBE-60 - page 5
5 IMPORTANT NOTES 291b In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2, 3 and 4, please read and observe the following: Power Supply 301 • Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as ...
-
Roland CUBE-60 - page 6
6 Panel Descriptions Control Panel fig.01 1. INPUT Jack Connect your guitar here. 2. SELECT Switch Switches you between the JC CLEAN and LEAD channels. You can confirm which channel is selected by checking the indicator’s color (JC CLEAN: green; LEAD: red). The channel can be switched using the optional BOSS FS-5U foot switch. JC CLEAN Channel Th ...
-
Roland CUBE-60 - page 7
7 Panel Descriptions * All product names mentioned in this document are trademarks or registered trademarks of their respective owners, and are not related to Roland Corporation. In this manual, these names are used as appropriate ways to indicate sounds that are simulated using COSM technology. 6. GAIN Knob Adjusts the LEAD channel’s distortion ...
-
Roland CUBE-60 - page 8
8 Panel Descriptions Rear Panel 1. FOOT SW (Foot Switch) Jack Foot switches (the optional BOSS FS-5U) are connected here. * Set the polarity switch as shown below. fig.06 (CH SELECT) Switches JC CLEAN/LEAD channels. (EFX) Switches on and off of EFX. (DELAY/REVERB) Switches on and off of DELAY/REVERB. 2. EXT SPEAKER (External Speaker) Jack You can c ...
-
Roland CUBE-60 - page 9
9 Sample Settings Alternative Metal The perfect sound for heavy, sharp riffs. Select the high-gain R-FIER amp, then use the equalizer to boost the low end even more. You can add even more to the distortion’s edge by raising the presence. Used with a humbucking pickup in the rear position, it results in an extreme distortion effect. Plus, you can ...
-
Roland CUBE-60 - page 10
10 Sample Settings Dynamic Style DYNA AMP is an original amp that uses relative picking strength to create changes in distortion depth. First, adjust the GAIN knob so that a clean tone is obtained with soft picking and deep distortion is obtained when you pick hard. Now, mixing arpeggios played with a gentle touch along with firmly picked chords an ...
-
Roland CUBE-60 - page 11
11 Main Specifications Rated Power Output 60 W Nominal Input Level (1 kHz) INPUT: -10 dBu/1 M Ω Speaker 30 cm (12 inches) Controls POWER Switch, SELECT Switch <JC CLEAN Channel> BRIGHT Switch, VOLUME Knob <LEAD Channel> TYPE Switch (ACOUSTIC, BLACK PANEL, BRIT COMBO, TWEED, CLASSIC STACK, METAL STACK, R-FIER STACK, DYNA AMP), GAIN Kno ...
-
Roland CUBE-60 - page 12
SD000453 1GT Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. As of November 1, 2003 (Roland) ARGENTINA Instrumentos Musicales S.A. Av.Santa Fe 2055 (1123) Buenos Aires ARGENTINA TEL: (011) 4508-2700 BRAZIL Roland Brasil Ltda Rua San Jose, 780 Sala B P ...
¿Tienes una pregunta acerca de Roland CUBE-60?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Roland CUBE-60, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Roland CUBE-60 probablemente compartirá una forma de solucionarlo.