-
Sanyo ECD-T1137S - page 1
PLL Synthesized Stereo Radio with Digital Compact Disc Player 1pair of RCA output CD-R/CD-R W Compatibility 4 preset Equalization Auxiliary Input OWNER'S MANUAL ECD-T1 137S ...
-
Sanyo ECD-T1137S - page 2
2 INSTALLA TION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sur e it is all connected up properly and the unit and the system works properly. • Use only the parts included with the unit to ...
-
Sanyo ECD-T1137S - page 3
3 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 14mm) 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. Removing the unit 1. Frame 2. Insert fingers into the gr oove in the front of frame and pull out to remove the frame. (When reattaching the frame, po ...
-
Sanyo ECD-T1137S - page 4
4 HOW TO REMOVE AND INST ALL THE FRONT P ANEL (OPTIONAL) 1. Pr ess the release button and pull-of f the front panel. Store front panel in the case. 2. T o install the fr ont panel, insert the panel into the housing and make sur e the panel is properly installed, otherwise, abnormalities may occur on the display or some keys may not function properl ...
-
Sanyo ECD-T1137S - page 5
5 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT Rch SPEAKER REAR Rch SPEAKER Rch RED Lch WHITE (GREY) RCA CABLE ANTENNA CONNECT OR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B-) MEMORY BACK-UP IGNITION SWITCH (B+) ...
-
Sanyo ECD-T1137S - page 6
6 25 26 7 3 1 4 14 20 11 9 19 8 15 24 10 12 2 5 18 13 21 22 23 6 16 17 OPERA TION GENERAL OPERATION ON/OFF Switch on the unit by pressing any button [except button (7) and eject button (4)]. When system is on, press PWR button (9) to turn off the unit. FACEPLA TE RELEASE Press button (7) to detach the removable faceplate. ...
-
Sanyo ECD-T1137S - page 7
7 The adjustment mode will change in the following order: By pressing VOL button + (11) or VOL button - (12), it is possible to adjust the desired sound level. LOUDNESS Pr ess BND/LOU button (13) for several seconds to reinforce the bass output and display will show "LOUD" . Pr ess it for several seconds again to r elease this function. S ...
-
Sanyo ECD-T1137S - page 8
8 RADIO OPERATION BAND SELECTION At tuner mode, press BND/LOU button (13) to select the desired band. The reception band will change in the following order: STA TION SELECTION Pr ess MANU/SKIP button (16) or MANU/SKIP button (17) to activate automatic seek function. T o select manual tuning mode, pr ess for several seconds until "MANUAL" ...
-
Sanyo ECD-T1137S - page 9
9 CD OPERA TION SELECT TRACKS Pr ess MANU/SKIP button (16) or MANU/SKIP button (17) to move to the previous track or the following track. Track number shows on display . Hold MANU/SKIP button (16) or MANU/SKIP button (17) to fast reverse or fast forward. CD play starts from when you release the button. PAUSE PLA YING Pr ess PA U button (20) to paus ...
-
Sanyo ECD-T1137S - page 10
Note: A. Notes on discs: 1. Attempting to use non-standar d shape discs (e.g. squar e, start, heart) may damage the unit. Be sur e to use round shape CD discs only for this unit. 2. Do not stick paper or tape etc., onto the label side or the recording side of any discs, as it may cause a malfunction. 3. Dirt, dust, scratches and warping discs will ...
-
Sanyo ECD-T1137S - page 11
11 SPECIFICATION GENERAL Po w er Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) T one Contr ols - Bass (at 100 Hz) : + 10 dB / - 10 dB - Treble (at 10 KHz) : + 10 dB / - 10 dB Maxim um Output P o w er : 40W x 4 (ch) Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise Ratio : Mor e than 55 ...
-
Sanyo ECD-T1137S - page 12
12 TROUBLE SHOOTING Befor e going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your near est service dealer . Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not r ...
-
Sanyo ECD-T1137S - page 13
SANYO MOBILE AUDIO MODEL ECD-T1137S LIMITED W ARRANTY OBLIGA TIONS In or der to obtain warranty service, the pr oduct must be deliver ed to and picked up fr om an Authorized Sanyo Factory Service Center at the user's expense, unless specifically stated otherwise in this warranty . The names and addr esses of Authorized Sanyo Service Centers ma ...
-
Sanyo ECD-T1137S - page 14
...
-
Sanyo ECD-T1137S - page 15
...
-
Sanyo ECD-T1137S - page 16
88-C1007-11 21605 Plummer Str eet Chatsworth, CA91311 ECD-T1137S. Issue Number 1. Printed in Hong Kong ...
¿Tienes una pregunta acerca de Sanyo ECD-T1137S?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sanyo ECD-T1137S, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sanyo ECD-T1137S probablemente compartirá una forma de solucionarlo.