-
Haier WMS650 - page 1
WMS650 T win-tub Washing Machine with Pump User's manual Names of the parts.............the 2 nd cover Safety precautions ...............................1 Installation and adjustment ..................3 Introduction of the major functions .......5 Preparation before washing ................6 The musts in washing .........................7 Usag ...
-
Haier WMS650 - page 2
Before Using Before Using Names of the par ts Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the personal saf ...
-
Haier WMS650 - page 3
If the supply cord is damaged, it must be replaced by the manufacturer, it s service agent or similarly qualified persons in order to avoid a hazard. ' Keep the pin of the power plug clean. The washing machine must be positioned so that the plug is accessible. . Be sure to pull the plug off when there's power failure, or the machine is be ...
-
Haier WMS650 - page 4
Before Using Before Using Safety precautions Do not put hand into the rotating tub. It is dangerous even if the rotation speed is slow . T ake special care of the children. Keep children away from the washing machine to avoid them climbing on it. Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items (such as t ...
-
Haier WMS650 - page 5
Before Using Before Using Installa tion and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the dr ...
-
Haier WMS650 - page 6
Select the water level Before Using Before Using Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. T ake off the drain hose from the cab ...
-
Haier WMS650 - page 7
Intr oduction of the major function The machine has good comprehensive performance, and nice appearance. It adopts streamline appearance and full plastic shell, which will never get rust. For the design on safety and reliability , it adopts the wash shelf, spin shelf and water inlet groove design, and reduces the unfavorable influence on the electr ...
-
Haier WMS650 - page 8
Using process Using process Pr epar a tion bef or e washing Pay attention to followings before washing the laundries Check if the laundries has special requirement on washing Clear the pocket. Take out the coins, sand, hairpins etc. Tie the long strips; fasten the buttons; close zippers. When the pulsator is running , the buttons of the laundries m ...
-
Haier WMS650 - page 9
Reference weight of the laundries Working suit up,down Jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness ,size , type of ...
-
Haier WMS650 - page 10
Selection of the quantity of the washing powder list 1 Selection of the current , water level and washing time list 2 How to use the washing powder How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to ...
-
Haier WMS650 - page 11
OFF OFF DRAIN STRONG Washing sequence Figure 1 Figure 2 Figure 3 Figure 4 WOOL WOOL WOOL SPIN TIMER WASH TIMER WASH TIMER WASH SELECTOR LINEN LINEN Using process Using process Wash SILK SILK SILK COTTON COTTON DRAIN STRONG WASH SELECTOR WASH SELECTOR 1. Fill the water and add the dissolved washing powder to make the water level reach the preset pos ...
-
Haier WMS650 - page 12
Midway spinning 1. 2. 3. Put the laundries into the spin tub evenly and smoothly . Spin Run the foam-removing spinning. Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland Using process Using process (1) Put the gland in properly. Please put in the gland properly even if the laun ...
-
Haier WMS650 - page 13
Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use SOFT current. If you use "STRONG" current, it m ...
-
Haier WMS650 - page 14
Selection of the spin time list 3 Laundries Spin time (minutes) About 4~5 Bed sheet or blanket About 2~4 Underwear (knitwear) Swear (chemical fiber) About 1~2 Within 1 minute Blending thin laundries Using process Using process 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and out ...
-
Haier WMS650 - page 15
After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. 1 T ake off the overflow filter. As indicated in the figure, nip the elastic fixing claw and pull it to the direction of ...
-
Haier WMS650 - page 16
Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Using process Using process Cleaning the overflow filter 2. T ake off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow fi ...
-
Haier WMS650 - page 17
2~3L Trouble-shooting Ans wers to question Below 50 When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "W ASH SELECTOR" at STRONG or SOFT . If it is set at "DRAIN", it will be rather difficult for the frozen water to melt. When the water ...
-
Haier WMS650 - page 18
T rouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do ...
-
Haier WMS650 - page 19
User's manual One One One One One Water inlet hose Water-filling jointer Gland Twin-tub washing machine Packing list Lint filter One ...
-
Haier WMS650 - page 20
Type Model Power source Water level Water quantity about Rated washing capacity kg Rated input power W Dimension(mm) Wash pattern Weight kg Injection pressure Rated spinning capacity kg Twin-tub washing machine WMS650 Maximum/43L Medium/36L Minimum/30L 6.5 5.0 Wash 320 Spin 150 L760 W440 H900 New current 23.5 0.02MPa~0.2MPa Specification Rated volt ...
¿Tienes una pregunta acerca de Haier WMS650?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Haier WMS650, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Haier WMS650 probablemente compartirá una forma de solucionarlo.