-
Dual XDVD1002CM - page 1
INSTALLATION/OWNER'S MANUAL XDVD1002CM ...
-
Dual XDVD1002CM - page 2
D V D O p e r a t i o n . . . . . . ...................................... C D O p e r a t i o n ............................................. M P 3 O p e r a t i o n ........................................... D i v X O p e r a t i o n . . . . ........................................ W a r r a n t y . . . . . . . . . . . . . . . .................. ...
-
Dual XDVD1002CM - page 3
3 XDVD1002CM PREPARATION Before You Begin Cautions To prevent damage or injury: 1. Make sure to ground the unit securely to the vehicle chassis ground. 2. Do not remove the top cover of the unit. 3. Do not install the unit in a spot exposed to excessive heat or the possibility of water splashing. 4. Do not subject the unit to excessive shock. 5. Wh ...
-
Dual XDVD1002CM - page 4
4 5 XDVD1002CM PREPARATION Contents Main Unit Remote Control Recommended Tools and Equipment • Upholstery hook tool (for removal of panels, if necessary) • #1 and #2 Phillips screwdrivers • Utility knife, razor knife, or shears • Misc. electrical connectors (to connect to vehicle power source – requirement will vary form vehicle to vehicl ...
-
Dual XDVD1002CM - page 5
4 5 XDVD1002CM INSTALLATION Wiring Diagram - Main Unit Yellow Black Red Brown Brown/Black Green Aux 2 Input (Red Jacket) A/V Output (Black Jacket) Connect to battery circuit or constant 12 volt source Connect to chassis ground Connect to ignition circuit or switched 12 volt source Dome light - See notes below Dome light + See notes below Dome light ...
-
Dual XDVD1002CM - page 6
XDVD1002CM INSTALLATION Mounting 6 1. Test fit the mounting bracket and unit on the ceiling of the vehicle, verify- ing that it is not going to interfere with the safe operation of the vehicle and is physically safe for the driver and passengers. 2. Once the mounting location is determined, carefully mark the location with masking tape. 3. Lower th ...
-
Dual XDVD1002CM - page 7
XDVD1002CM OPERATION Control Locations - Main Unit 7 9 10 11 2 3 6 4 5 Power Source Select Chapter/Track Down Dome Light Switch Screen Release Aux1 Inputs 1 2 3 4 Rear IR Sensor Motorized Disc Slot Front IR Sensor/Transmitter Chapter/Track Up Play/Pause Disc Eject 5 7 8 9 8 7 10 11 1 12 12 6 ...
-
Dual XDVD1002CM - page 8
XDVD1002CM OPERATION Control Locations - Remote 8 9 Power Return Fast Reverse Enter Chapter/Track Down Root Menu Setup Menu Step Subtitle Dimmer Angle 1 Shuffle Goto Video/Source Repeat LCD Screen Menu Program Screen Mode Screen Zoom FM Transmitter Title Repeat A-B Mute Audio Volume Up/Down Display Stop Play/Pause Chapter/Track Up Fast Forward Clea ...
-
Dual XDVD1002CM - page 9
XDVD1002CM OPERATION General Operation To turn on the unit, press the power button on the main unit or on the remote. Press again to turn the unit off. Pressing the screen release lock will unlock the LCD screen, and it will drop down slightly. Move the screen to the desired viewing angle, and the internal hinge assembly will hold the screen in pos ...
-
Dual XDVD1002CM - page 10
Press SOURCE on the main unit to select between the following sources: AUX1 > AUX2 > DVD. Press SOURCE on the remote to select between AUX1 > AUX2 > DVD. Adjust volume using VOLUME / on the remote (0-16). Press MUTE on the remote to silence the audio. Press MUTE or VOLUME / to cancel. Press DISPLAY on the remote to selec ...
-
Dual XDVD1002CM - page 11
XDVD1002CM OPERATION General Operation - Setup Menu 10 11 In the AUDIO SETUP menu, the following menus are availble: Select SPDIF from the AUDIO SETUP menu. Press to make selection. Press or to adjust (ON/OFF). Select OP MODE from the AUDIO SETUP menu. Press to make selection. Press or to adjust (LINE OUT/RF REMOD). Select D ...
-
Dual XDVD1002CM - page 12
XDVD1002CM OPERATION DVD Operation 12 13 Press SOURCE on the remote or the main unit to select DVD mode. Press EJECT on the remote control or on the main unit to open the motorized disc slot, insert disc. Press EJECT on the remote control or on the main unit to eject the disc. Press ROOT on the remote control to select DVD root menu. Press ...
-
Dual XDVD1002CM - page 13
XDVD1002CM OPERATION DVD Operation 12 13 Press A-B on the remote for more than 2 seconds to set point “A”. Press A-B for more than 2 seconds to set point “B”. The points between “A” and “B” will continually repeat. Press A-B to cancel repeat A-B. Press ZOOM on the remote to select between ZOOM X1.5, X2, X3 and OFF (normal). Press AU ...
-
Dual XDVD1002CM - page 14
14 15 XDVD1002CM OPERATION CD Operation Press SOURCE on the remote or the main unit to select DVD mode. Press EJECT on the remote control or on the main unit to open the motorized disc slot, insert disc. Press EJECT on the remote control or on the main unit to eject the disc. Press on the remote control to stop playback and retain last ...
-
Dual XDVD1002CM - page 15
14 15 XDVD1002CM OPERATION Additional MP3 Operation When an MP3 encoded disc is first inserted, SMART NAVI will show on screen. The disc will automatically begin playback . NOTE: It may take a few seconds for the unit to read disc. Disc playback must be stopped by pressing on the remote. Press or or to select between ROOT, FOLDE ...
-
Dual XDVD1002CM - page 16
16 17 XDVD1002CM OPERATION DivX ® Operation When a DivX encoded disc is first inserted, playback will begin with the first file auto- matically, To access the SMART NAVI menu screen, stop playback by pressing on the remote . Disc playback must be stopped by pressing on the remote. Press or or to select between ROOT, FOLDER, ...
-
Dual XDVD1002CM - page 17
16 17 XDVD1002CM WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and work - manship for a period of one year from the date of the origi - nal purc ...
-
Dual XDVD1002CM - page 18
18 19 XDVD1002CM OPERATION Troubleshooting Copyright Notes This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technol - ogy must be authorized by Macrovis ...
-
Dual XDVD1002CM - page 19
18 19 XDVD1002CM OPERATION Specifications Signal-to-noise: >92dB Dynamic range: >85dB Frequency response: 20Hz-20kHz Panel size: 10.2 ” Diagonal measurement Format: Widescreen 16:9 View area: 8.74 ” x 5.24 ” (222 x 133 mm) Display system: Color TFT active matrix LCD View angle (up/down/left/right): 50/65/65/65 Resolution: 800 x 480 Pixe ...
-
Dual XDVD1002CM - page 20
Dual Electronics Corp. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-382-5476 www.dualav.com ©2005 Dual Electronics Corp. All rights reserved. NSA0805-V01 ...
¿Tienes una pregunta acerca de Dual XDVD1002CM?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Dual XDVD1002CM, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Dual XDVD1002CM probablemente compartirá una forma de solucionarlo.