-
Smeg SSA91MFX - page 1
Contents 1. INSTRUCTIONS FOR SAF E AND PROPER USE _______________________________4 2. INSTALLATION OF THE APPLIANCE_________________________________________6 3. ADAPTATION TO DIFFERENT TYPES OF GAS ________________________________9 4. FINAL OPERATIONS _____________________________________________________12 5. DESCRIPTION OF CONTROLS _______________ ...
-
Smeg SSA91MFX - page 2
Introduction 1. INSTR UCTIONS FOR SA FE AND PR OPER USE THIS MANUAL IS AN INTEGRAL PART OF TH E APPLIANCE AND THEREFOR E MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PL ACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANU AL AND AL L THE IN STRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIE ...
-
Smeg SSA91MFX - page 3
Introduction DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE HOB GRIDS. DURING USE THE APPLIANCE BE COMES VERY HOT . TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT USE CONTAINERS OR BROI LERS THAT EXTEND BEYOND THE OUTE R PERIMETER OF THE HOB. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS . DO NOT ALLO W CHILDREN ...
-
Smeg SSA91MFX - page 4
Instructions for the installer 2. INST ALLA TION OF THE APPLIANCE It is the law that all ga s appliances are installed by competent persons . Corgi gas i nstallers ar e approved to work to safe and satisfactory standards . All gas in stallation, servicing and repair wor k must be in accordance wit h the gas safety regulation s 198 4 (in stallation ...
-
Smeg SSA91MFX - page 5
Instructions for the installer 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on th ...
-
Smeg SSA91MFX - page 6
Instructions for the installer 2.3 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance using flexible bayonet style hose in accordance to B.S. 669. The hose connection at the rear of the appliance has a ½” BSP internal thread. Please use seal C between the flexible connection L and the appliance ...
-
Smeg SSA91MFX - page 7
Instructions for the installer 3. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenanc e work, disconnect the appliance from the mains. The cooker hob is preset for natural gas G20 (2H) at a pressure of 2 0 mbar. In the case of operation with other types of gas the burner nozzles must be changed and the minimum flam ...
-
Smeg SSA91MFX - page 8
Instructions for the installer 3.2 Burner and nozzle characteristics tab le (Mod. 90 cm.) Burner Rated heating capacity (kW) LPG – G30/G31 28/37 mbar Nozzle diameter 1/100 mm By-pass mm 1/100 Reduced flowrate (W) Flowrate g/h G30 Flowrate g/h G31 Auxiliary 1.0 50 30 350 73 71 Semi rapid 1.75 65 33 450 127 125 Rapid 3.0 85 45 800 218 214 Triple cr ...
-
Smeg SSA91MFX - page 9
Instructions for the installer 3.4 Burner and nozzle characteristics tab le (Mod. 60 cm.) Bruciatore Portata termica nominale (kW) LPG – G30/G31 28/37 mbar Diametro Ugello 1/100 mm By-pass mm 1/100 Portata ridotta (W) Portata g/h G30 Portata g/h G31 Auxiliary 1.0 50 30 350 73 71 S Semi rapid 1.75 65 33 450 127 125 Rapid 3.0 85 45 800 218 214 Trip ...
-
Smeg SSA91MFX - page 10
Instructions for the installer 4. FINAL OPERA TIONS After replacing the nozzles, reposition the fl ame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with t ...
-
Smeg SSA91MFX - page 11
Instructions for the installer 4.4 W all fixing • Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. • Mark the wall in the position where the hole is to be drilled. • Drill the hole, insert a wall plug and attach the ch ain. • Move the cooker up against the wall. 1 3 ...
-
Smeg SSA91MFX - page 12
Instructions for the installer 5. DESCRIPTION OF CONTR OLS 5.1 Front contr ol panel All the cooker controls and commands are on the front panel. If the cooker is equipped with an electronic programmer, before using the oven make sure that the symbol ; appears on the display. See paragraph “8. ELECTRONIC PROGRAMMER”. DESCRIPTION OF SYMBOLS FRONT ...
-
Smeg SSA91MFX - page 13
Instructions for the user VARIABLE GRILL KNOB This allows to vary heat intensity w hen cooking with the grill. The knob can be set with continuity between “ 0 ” and the st op release position, which corresponds to maximum heat. ELECTRIC OVEN CONTROL K NOB Each of the functions listed below can be use d (except the oven light and the small grill ...
-
Smeg SSA91MFX - page 14
Instructions for the installer 6. USE OF THE HOB 6.1 Lighting of the hob b urners Before lighting the hob burners check that the fl ame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. The optional grid B is for use with “woks? ...
-
Smeg SSA91MFX - page 15
Instructions for the user 6.3 Diameter of the vessels to be used on each b urner BURNERS 1 Auxiliary 2 Semi rapid 3 Rapid 4 Triple crown Ø min. and max. (in cm) 12-14 16-24 18-26 18-26 17 ...
-
Smeg SSA91MFX - page 16
Instructions for the installer 7. USE OF THE O VEN For the models with electronic programmer, before using the oven make sure that t he display shows the symbol . 7.1 W arnings and g eneral advice Using the oven and the grill for the first time, heat them to the maximum temperature ( 260° C) for as long as it takes to burn off any production oil r ...
-
Smeg SSA91MFX - page 17
Instructions for the user 7.2.2 Using the rotisserie in cookers with maxi oven Fit the supporting frame onto the se cond runner up from the bottom so that the seat to take the rod projects outside the o ven. Place the rod as shown in the diagram (1) and push the frame into the oven until the end of the rod reaches the hole in the rotisserie motor. ...
-
Smeg SSA91MFX - page 18
Instructions for the installer 7.3 Using the pIzza functi on (only on some models) This appliance Is equipped with a function spe cially developed for cookin g pizza. This function is identified by the symbol on the oven functions knob. To cook a pizza, proceed as describ ed b elow. With the oven cold, remove the round cover from the bottom of the ...
-
Smeg SSA91MFX - page 19
Instructions for the user 8. ELECTR ONIC PROGRAMMER (ONL Y ON EQUIPPED MODELS) LIST OF FUNCTIONS MINUTE-COUNTER KEY COOKING TIME KEY END-OF-COOKING KEY DECREASE TIME KEY INCREASE TIME KEY 8.1 Cloc k adjustment When using the oven for the first time, or after a power failu re, the display flashes regularly and indicates . Press the keys and at the s ...
-
Smeg SSA91MFX - page 20
Instructions for the installer 8.4 End of cooking When cooking is over, the oven w ill automatically switch off and, at the same time, an intermittent alarm will sound. After swit ching off the alarm, the display will once again sho w the right time together with the symbol , indicating that the oven has returned to manual operation mode. 8.5 Minut ...
-
Smeg SSA91MFX - page 21
Instructions for the user 9. A V AILAB LE A CCESSORIES The oven has 4 support for positioning pla tes and racks at various heights. Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip. Oven plate: useful for catching fat from foods on th ...
-
Smeg SSA91MFX - page 22
Instructions for the installer 10. CLEANING AND MAINTENANCE 10.1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition clean it regularly after each use, on ce it has cooled down. 10.1.1 Ordinary daily cleaning To clean and preserve the stainless steel surfaces, always use only specific produ cts that do not ...
-
Smeg SSA91MFX - page 23
Instructions for the user 10.3 Cleaning of o ven For best oven upkeep clean regularly after having allowed to cool. Take out all removable parts. • Clean the oven grill with hot water and non-abrasive detergent. Rinse an d dry. • Do not allow residues of sugary foods (such as jam) to set inside the o ven. If left to set for too long, they might ...
-
Smeg SSA91MFX - page 24
Instructions for the installer 11. EXTRA ORDINAR Y MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device. 11.1 Repla ...
¿Tienes una pregunta acerca de Smeg SSA91MFX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Smeg SSA91MFX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Smeg SSA91MFX probablemente compartirá una forma de solucionarlo.