-
Enterasys SecureStack C2 C2RPS-POE - page 1
SecureS t ack C2 PoE Redundant Power Supply C2RPS-POE Inst allation Guide C2RPS-POE POWER 9033995-0 1 Caution: Do not use this product with Se cureS tack C2 non-PoE devices. Any SecureS tack C2 device without a “P” suffix in the model number (C2xxxx-xx) indicates a SecureS tack C2 PoE non-compliant device and is not compatible with this power s ...
-
Enterasys SecureStack C2 C2RPS-POE - page 2
...
-
Enterasys SecureStack C2 C2RPS-POE - page 3
i Notice Enterasys Networks reserv es the right to make changes in specifica tions and other information containe d in this document and its web site without prior notice. The reader should in all cases consult Enterasys Netw orks ...
-
Enterasys SecureStack C2 C2RPS-POE - page 4
ii Regulatory Compliance Information Federal Communications Commission (FCC) Notice This device co mplies with Pa r t 15 of the FCC rules. Operation is subjec t to the following two conditions: (1) this device may not cause harmfu l interference, ...
-
Enterasys SecureStack C2 C2RPS-POE - page 5
iii Electromagnetic Compatibility (EMC) This product complies with the following: 47 CF R Pa r t s 2 and 15, CSA C108.8, 89/336/EEC, EN 55022, EN 61000 ‐ 3 ‐ 2, EN 61000 ‐ 3 ‐ 3, EN 55024, AS/NZS CISPR 22, VCCI V ‐ 3. Compatibilidad Electromágnetica ( ...
-
Enterasys SecureStack C2 C2RPS-POE - page 6
iv Declaration of Conformity Application of Co uncil Directiv e(s): 89/336/EEC 73/23/EEC Manufacturer’s Na me: Enterasys Networks, Inc. Manufacturer ’ s Address : 50 Minuteman Road Andover, MA 01810 USA European Representativ e Address: Enterasys Networks, Ltd. Nexus House, Newbury Bus ...
-
Enterasys SecureStack C2 C2RPS-POE - page 7
v Enterasys Networks, Inc. Firmware License Agreement BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT , CAREFULL Y READ THIS LICENSE AGREEMENT . This document is an agreement (“ Agreement”) betwee n the end user (“Y ou”) and Enterasys Netw orks, Inc. ? ...
-
Enterasys SecureStack C2 C2RPS-POE - page 8
vi 3. APPLICABLE LAW. This Agreem ent shal l be interpreted and governed under the laws and in the state and federal cour ts of the Commonwealth of Massachusetts wi thou t regard to its conflicts of laws provisions. You ac ...
-
Enterasys SecureStack C2 C2RPS-POE - page 9
vii 8. AUDIT RIGHTS. You here by acknowl edge that the intellectual property rights associated with the Program are of critical value to Enterasys and, accordingly, You hereby agree to maintain complete books, records and accounts ...
-
Enterasys SecureStack C2 C2RPS-POE - page 10
viii ...
-
Enterasys SecureStack C2 C2RPS-POE - page 11
ix Contents About this Guide Using This Guide ......... ................ ............. ............. ............. ................ ............. ............. .... ................... xi Structure of This Guide ............. ................ ............. ................ ............. ............. ................ ... ................ . xi Using ...
-
Enterasys SecureStack C2 C2RPS-POE - page 12
x Tables 1-1 Powered Device (PD) PoE Pow er Classification s... ............. ............. ................ ............. ........ 1-3 2-1 Contents of N-POE Chassis Carton . ............. ............. ................ ............. ................ ............. .. 2-2 2-2 C2RPS-POE Status LED Indications and R ecommended Actions ...... ......... ...
-
Enterasys SecureStack C2 C2RPS-POE - page 13
SecureStack C2 Installation Guide xi About this Guide This guide provide s an overview , installation and troubleshooting instructions, and specifications for the Enterasys SecureStack C2RPS ‐ POE power supply, which can provide a redundant power sourc ...
-
Enterasys SecureStack C2 C2RPS-POE - page 14
Using the SecureStack C2 Manual Set xii About this Guide Using the SecureS t ack C2 Manual Set Other manuals have been develope d for the SecureStack C2 Po E swi tch devices that can be connected to the C2RPS ‐ POE pow er supply for power redundancy . The ...
-
Enterasys SecureStack C2 C2RPS-POE - page 15
Conventions Used in This Guide SecureStack C2 Installation Guide xiii Conventions Used in This Guide The following conventions are used in this guide: Note: Calls the reader ’s attention to any item of information that may be of special import ance. Caution: Contains information essential to avoid damage to the equipme ...
-
Enterasys SecureStack C2 C2RPS-POE - page 16
Conventions Used in This Guid e xiv About this Guide ...
-
Enterasys SecureStack C2 C2RPS-POE - page 17
SecureStack C 2 Installation Gui de 1-1 1 Introduction This chapter provides the following information: For information about... Refer to page... C2RPS-POE Overview 1-2 C2RPS-POE S tatus LED 1-2 Power Classifications and Deployment 1-2 Getting Help 1-4 ...
-
Enterasys SecureStack C2 C2RPS-POE - page 18
C2RPS-POE Overview 1-2 Introduction C2RPS-POE Overview The purpose of the C2RPS ‐ POE is to provide power backup to an Enterasys SecureStack C2 Po E ‐ compliant stacka ble switch. If for some reason the switch looses power from its in ...
-
Enterasys SecureStack C2 C2RPS-POE - page 19
Power Classificati ons and Deployment SecureStack C 2 Installation Gui de 1-3 The num ber of PDs that can be supported by the connected SecureStack Po E switch can be estimated by ad ding up the maximum power requirement of each connected PD ...
-
Enterasys SecureStack C2 C2RPS-POE - page 20
Getting Help 1-4 Introduction The SecureStack PoE switch has six of its P oE/data ports conne cted to PDs with the following Class ratings: •O n e does not support PoE (no pow er) •O n e has no Class rating (Defaults to Cl ...
-
Enterasys SecureStack C2 C2RPS-POE - page 21
SecureStack C2 Installation Guide 2-1 2 Installation This chapter provides the installation instructions to install all the components of a C2RPS ‐ POE. To correctly install the C2RPS ‐ POE, follow the order of information list ed below . Required T ...
-
Enterasys SecureStack C2 C2RPS-POE - page 22
Unpacking the C2RPS-POE 2-2 Installation Unp a cking the C2RPS-POE To unpack the C2RPS ‐ POE, proceed as follows: 1. Open the box and remov e the packing material protecting the devices. 2. V erify the contents of each carton and compare the conten ...
-
Enterasys SecureStack C2 C2RPS-POE - page 23
Installing the C2RPS-POE on a Flat Surface SecureStack C2 Installation Guide 2-3 Inst alling the Rubber Feet To install the rubber feet, refer to Figure 2 ‐ 1 and proceed as follows: 1. Place the C2RPS ‐ POE on its back on a stur dy flat surface to gain ...
-
Enterasys SecureStack C2 C2RPS-POE - page 24
Installing the C2RPS-POE on a Flat Surface 2-4 Installation Guidelines for Inst allation Locate the C2RPS ‐ POE within 152 cm (5 ft) of its power source and on a surface as shown in Figure 2 ‐ 2 . If the switch is being instal led as a st ...
-
Enterasys SecureStack C2 C2RPS-POE - page 25
Rack Mounting the C2RPS-POE SecureStack C2 Installation Guide 2-5 Rack Mounting the C2RPS-POE To install the switch in a 19 ‐ inch rack, yo u need: •T w o rackmount brackets and mounting screws (rackmount kit) shipped with the switch. •F o u r user ‐ sup ...
-
Enterasys SecureStack C2 C2RPS-POE - page 26
Rack Mounting the C2RPS-POE 2-6 Installation Att aching Bracket s and Inst alling in Rack Proceed as follows to install the switch into a 19 ‐ inch rack: 1. Attach the rac kmoun t brackets to the switch, as shown in Figure 2 ‐ 3 , using the eight M3 ...
-
Enterasys SecureStack C2 C2RPS-POE - page 27
Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-7 Connecting C2RPS-POE Cable and AC Power C ord The C2RPS ‐ POE is connected to the SecureStack PoE switch using a C2RPS ‐ POE cable, as follows: 1. Connect one end of the C2RPS ‐ POE ...
-
Enterasys SecureStack C2 C2RPS-POE - page 28
Connecting C2RPS-POE Cable and AC Power Cord 2-8 Installation If you need additional help, contact Enterasy s Networks. Refer to “ Getting Help ” on page 1 ‐ 4 for instructions. Figure 2-5 C2RPS-POE Cable Figure 2-6 Power Connector on C2RPS-POE (rear view) 1 AC power plug 3 Redun ...
-
Enterasys SecureStack C2 C2RPS-POE - page 29
Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-9 Figure 2-7 C2RPS-POE Cable and AC Power Cord Connection s If you need additional help, contact Enterasy s Networks. Refer to “ Getting Help ” on page 1 ‐ 4 for instructions. 1 Switch device 4 Switch de ...
-
Enterasys SecureStack C2 C2RPS-POE - page 30
Connecting C2RPS-POE Cable and AC Power Cord 2-10 Installation ...
-
Enterasys SecureStack C2 C2RPS-POE - page 31
SecureStack C2 Installation Guide A-1 A Specifications This appendix provides information about the f ollowing: Enterasys Netw orks reserves the right to change the specifications at any time without notice. C2RPS-POE S pecifications The following sections desc ...
-
Enterasys SecureStack C2 C2RPS-POE - page 32
C2RPS-POE Redundant Power Supply Output Connector A-2 Specifications C2RPS-POE Redundant Power Supply Output Connector For pin location and function, refer to Figu re A ‐ 1 and Ta b l e A ‐ 2 , respectively . Figure A-1 C2RPS- POE Redundant Power Supp ly Connector Pin Location s Physical Dimensions 4. ...
-
Enterasys SecureStack C2 C2RPS-POE - page 33
Compliance Standards SecureStack C2 Installation Guide A-3 Compliance S t andards The C2RPS ‐ POE meets the safety an d electromagnetic compatibility (EMC) requirements listed in Ta b l e A ‐ 3 : T able A-2 C2RPS-POE Redundant Power Supply Connector Pin Functi ons Pin Number Function 1 - 50 V retu ...
-
Enterasys SecureStack C2 C2RPS-POE - page 34
Compliance Standards A-4 Specifications ...
¿Tienes una pregunta acerca de Enterasys SecureStack C2 C2RPS-POE?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Enterasys SecureStack C2 C2RPS-POE, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Enterasys SecureStack C2 C2RPS-POE probablemente compartirá una forma de solucionarlo.