-
Snapper 11305 - page 1
Safety Instructions & Operator’s Manual for TWO STAGE LARGE FRAM E SNOW THROWER SERIES 5 MODELS 8245 9265 11305 MODEL NUMBER EXPLA NA TION 11 30 5 ENGINE HP SERIES DESIGNATION A UGER WIDT H 8 – 8.0 Engine HP (En gine Horse Pow er 24 – 24” A uger Width 5 – Series Designation 9 – 9.0 Engine HP (En gine Horse Pow er) 26 – 26” A uge ...
-
Snapper 11305 - page 2
2 IMPORTA NT SA FETY INST RUC TIONS WARNING: This pow erful mach ine is capable of amp utating hands and f eet and can throw objects that can cause injury a nd d a m ag e ! Failure to comply with the follow ing instruct ions may result in se rious injury to the operator or other persons. The ow ner of the snow thrower must understand these instruct ...
-
Snapper 11305 - page 3
3 IMPORTA NT SA FETY INST RUC TIONS OPERA TIONA L PRECA UTIONS (Continued From Pre vious Page) 7. DO NOT put hands or feet nea r or under rotatin g parts. Keep clear o f the discharge opening at all times. 8. St art engine only where exhaust fu mes will be safely dissipated. A llow a brief warm-up pe riod, and practice operation of controls outside ...
-
Snapper 11305 - page 4
4 TABLE OF CONTENTS SECTION 1 - IMPORTA NT SA FETY INSTRUCTIONS .......................... 2-3 TA BLE OF CO NTENTS ............................................................................ 4 SECTION 2 - OPERA TIN G INSTRUCTIONS ....................................... 5-10 Introduc tion............................................................. ...
-
Snapper 11305 - page 5
5 Section 2 - OPERA TING INSTRUCTIONS 1.1 INTRODUCT ION Before s tarting m achine, vis ually check location of all operational contr ols and identify major parts discuss ed in Operator’s Manual. FIGURE 1.1 NOMENCLATURE TRA CTION CLUTCH CONT ROL LEVER HIGH SPEED IMPELLER COLLECT OR AUGERS DISCHARGE DEFLECTOR CA P HEA D LIGHT (26” & 30” M O ...
-
Snapper 11305 - page 6
6 Section 2 - OPERA TING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the f ollowing check s and per form the ser vice required bef ore each star t-up. 2.1.1. Check engine oil and add oil as needed to bring level up to the FULL m ark . Refer to engine owner’s m anual for oil specif ications 2.1.2. Check guards, c hutes, deflec tors and c overs to m ...
-
Snapper 11305 - page 7
7 Section 2 - OPERA TING INSTRUCTIONS 2.1 PRE-START CHECK LIST 2.1.9. Check the AC elec trical outlet that will be used and m ak e sure it is a polar ized outlet. The ma chine has a polarized plug (one blade of plug is wider than the other) that will accept a polarized extension co rd. The ex tension cor d will f it into a polarized outlet (r ecept ...
-
Snapper 11305 - page 8
8 Section 2 - OPERA TING INSTRUCTIONS 2.2 ST A RTING , OPERATION & ST OPPING (RECOIL STA RT MODELS) (Go t o Page 9 for Elect ric Start M odels) (Continued From Pre vious Page) 2.2.2. PROPELLING SNOW THROWER IMPO RTANT: T his snow thrower has six forward speeds and one rever se speed. 1. Move ground speed contr ol to the desired speed position. ...
-
Snapper 11305 - page 9
9 Section 2 - OPERA TING INSTRUCTIONS 2.2 STARTING, OPERA TION & ST OPPING (RECOIL STA RT MODELS) 2.2.6. STOPPING - ENGINE , A UGER & WHEEL DRIVE Stop the auger /im peller and wheel drive by releasing the auger/im peller and wheel drive control levers . Stop the engine by m oving the engine speed control to the s top position or rem oving t ...
-
Snapper 11305 - page 10
10 Section 2 - OPERA TING INSTRUCTIONS 2.2 ST A RTING , OPERATION & ST OPPING (ELECTRIC STA RT M ODELS) (Go to Page 7 for Recoil Start Models) (Continue From Pre vious Page) WA RNING Objects can b e thrown b y the snow throw er wh ile it is in operation. Thrown objects could caus e ser ious injury to the operator or by standers. Alway s wear sa ...
-
Snapper 11305 - page 11
11 Section 3 - MA INTENA NCE 3.1 INTRODUCT ION To retain the quality of the snow thrower, use only genuine SNAPPER replacem ent parts. Contac t a local SNAPPER dealer for par ts and ser vice assistanc e. For the cor rect part or inform ation for a particular s now thrower, alway s m ention model and serial num ber. 3.2 SERVICE - A FT ER FIRST 5 HOU ...
-
Snapper 11305 - page 12
12 Section 3 - MA INTENA NCE 3.4 ANNUA LLY (END OF EA CH SEA SON) Perfor m all m aintenanc e as desc ribed in the maintenanc e schedule. 3.4.1. Engine Refer to engine owner’s manual f or service instru ctio ns. 3.4.2. Spark Plug Refer to engine owner’s manual f or service instru ctio ns. 3.5 STORA GE PROCEDURE Refer to the Engine O wner’s Man ...
-
Snapper 11305 - page 13
13 Section 4 - REPA IR & A DJUSTMENTS WA RNING DO NOT attempt any adjustments, maintenan ce, service, or repair s, with engine running. Stop auger. Stop engine. Remove key. Dis connect spark plug wire an d secure w ire away from sp ark plug. 4.1 A UGER/IMPELLER and WHEEL DRIVE BELT A D JUSTM ENT /REPL A C EM ENT W hen operating m achine releas ...
-
Snapper 11305 - page 14
14 Section 4 - REPA IR & A DJUSTMENTS WA RNING DO NOT attempt any adjustments, maintenan ce, service, or repair s, with engine running. Stop auger. Stop engine. Remove key. Dis connect spark plug wire an d secure w ire away from sp ark plug. Bef ore tilting machine, drain all the fuel f rom fuel tan k. A llow engine to run, outdoors where fumes ...
-
Snapper 11305 - page 15
15 Section 4 - REPA IR & A DJUSTMENTS WA RNING DO NOT attempt any adjustments, maintenan ce, service, or repair s, with engine running. Stop auger. Stop engine. Remove key. Dis connect spark plug wire an d secure w ire away from spark plug. Be for e tilting machin e, drain all the fu el from fuel tank. A llow engine to run, outdoors where fumes ...
-
Snapper 11305 - page 16
16 Section 4 - REPA IR & A DJUSTMENTS 4.1.5. SKID SHOE A DJUSTM ENT NOTE: It is recom m ended to raise the auger /impeller housing when c learing rough or gr aveled surfac es. To raise auger/im peller the sk id shoes should be lowered. 1. Tilt m achine up and plac e a wooden block under auger/im peller housing. 2. Loosen bolts on both sk id sho ...
-
Snapper 11305 - page 17
17 Section 4 - REPA IR & A DJUSTMENTS 4.1.6. SINGLE HA NDLE CONTROL A DJUSTM ENT IMPO RTANT: Standing in the oper ator’s position, the lef t handle bar lever is f or wheel drive engagement and disengagem ent. The r ight handle bar lever is f or auger/im peller engagem ent and disengagem ent. Hold both levers down to handle bar f or engagem en ...
-
Snapper 11305 - page 18
18 Section 4 - REPA IR & A DJUSTMENTS 4.1.7. AUGE R SHEA R BOLT REPLACE MENT IMPO RTANT: If engine is operating cor rectly and auger/im peller drive belt is not dam aged or severed, but the auger/im peller does not rotate it is possibly the auger/impeller s haft shear bolt. 1. Rem ove shear bolt and nut f rom auger. Discar d old shear bolt and ...
-
Snapper 11305 - page 19
19 TROUBLESHOOTING PROBL EM PROBA BLE CA USE CORRECTIVE A CTION Engine Will Not Start 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel or fuel/oil mix . Using Recoil Starter 2. Engine needs choking and priming. 2. Mov e choke control to “CHOKE” position. Push primer bulb three times. 3. Spark plug wire disconnected. 3. Place spark plug wir ...
-
Snapper 11305 - page 20
20 3 YEA R LIMITED WA RRA NTY For thr ee ( 3) years from purc hase date f or the original purc haser's residential, non- com m erc ial use, SNAPPER , through any authorized SNA PPER dealer will replace, f ree of c harge (ex cept f or taxes where applicable), any part or parts found upon exam ination by the factory at McDonough, Georgia, to be ...
-
Snapper 11305 - page 21
21 NOTES _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _____ ...
-
Snapper 11305 - page 22
22 NOTES _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _____ ...
-
Snapper 11305 - page 23
23 NOTES _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _______________________________________________ _____ ...
-
Snapper 11305 - page 24
24 Safety Instructions & Operator’s Manual for TWO STAGE LARGE FRAM E SNOW THROWER SERIES 5 IMPORTA NT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufac tured. The labels on those e ngines contain ver y important e missions infor mation and critical safety warn ings. Read, U ...
¿Tienes una pregunta acerca de Snapper 11305?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Snapper 11305, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Snapper 11305 probablemente compartirá una forma de solucionarlo.