-
Patton electronic 2130 - page 1
USER MANUAL MODEL 2124/2130 Ethernet Micr oBridge SALES OFFICE (301) 975-1000 TECHNICAL SUPPOR T (301) 975-1007 P ar t# 07M2124-UM Doc# 08306U2-001, Rev . B Revised 10/27/06 An ISO-9001 Certified Company ...
-
Patton electronic 2130 - page 2
1 T AB LE OF CONTENTS 1.0 Warranty Information ................................................................. 2 1.1 Radio and TV Interference............................................................ 2 1.2 CE Notice...................................................................................... 3 1.3 Service ............................. ...
-
Patton electronic 2130 - page 3
2 1.0 W ARRANTY INFORMATION P atton Electronics warrants all Model 2124/2130 components to be free from def ects, and will—at our option—repair or replace the product should it f ail within one year from the first date of shipment. This warranty is limited to def ects in w orkmanship or mater ials, and does not cov er customer damage, ab use o ...
-
Patton electronic 2130 - page 4
3 1.2 CE NOTICE The CE symbol on your P atton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low V oltage Directiv e (L VD) of the Union European (EU). A Cer- tificate of Compliance is av ailable b y contacting P atton T echnical Sup- por t. 1.3 SERVICE All warranty and non-w ...
-
Patton electronic 2130 - page 5
4 2.0 GENERAL INFORMATION Thank you f or y our purchase of this P atton Electronics product. This product has been thoroughly inspected and tested and is warranted f or One Y ear par ts and labor . If any questions or problems arise during installation or use of this product, please do not hesitate to contact P at- ton Electronics T echnical Suppor ...
-
Patton electronic 2130 - page 6
5 3.0 PPP OPERATIONAL BACKGR OUND PPP is a protocol used f or multi-ple xed tr anspor t ov er a point-to-point link. PPP oper ates on all full duplex media, and is a symmetric peer-to- peer protocol, which can be broken into three main components: 1. A standard method to encapsulate datagrams o ver serial links; 2. A Link Control Protocol (LCP) to ...
-
Patton electronic 2130 - page 7
6 Figure 1. Cisco router with serial interface, configured as PPP Half Bridge. F or example , the customer site is assigned the addresses 192.168.1.0/ 24 through 192.168.1.1/24. The address 192.168.1.1/24 is also the def ault gatewa y f or the remote network. The above settings remo ve an y routing/f orwarding intelligence from the CPE. The associ ...
-
Patton electronic 2130 - page 8
7 Figure 2. T ransparent bridging between two routers ov er a serial link. ...
-
Patton electronic 2130 - page 9
8 4.0 INSTALLATION The 2124/2130 is equipped with Network, DTE, and power interf aces. This section briefly descr ibes connnection to each interf ace. 4.1 CONNECT TO 10BASET ETHERNET PORT The shielded RJ-45 Ethernet por t on the Model 2124/2130 is designed to connect directly to a 10BaseT network. Figure 3 sho ws the 10BaseT RJ- 45 por t pin descr ...
-
Patton electronic 2130 - page 10
9 4.2 POWER CONNECTION The Model 2124/2130 off ers either an AC or DC po wer supply . The 2124/2130 provides a strap selectab le pow er supply . A C P ower Suppl y (100-240V AC) The Model 2124/2130 uses a 5VDC , 2A universal input 100-240V A C, power supply (center pin is +5V). The universal input po wer supply is equipped with a male IEC-320 conne ...
-
Patton electronic 2130 - page 11
10 DC P ower Figure 4. Strap positions 7 and 8 on J3 Supply DC power directly to the po wer supply jac k. DC pow er supplied must be +5VDC ±5%, 500mA minimum, center positiv e, and can be sup- plied via a barrel type plug with 2.1/5.5/10mm I.D ./O.D ./Shaft Length dimensions. For this pow ering option, set J3 to position 7 and 8 as shown in figur ...
-
Patton electronic 2130 - page 12
11 P ower -up 2124 via DB-25 Connector on Pin 25 Place strap position 1 and 2 on J3 f or DC power supply . See Figure 6 below . P ower -up 2130 via DB-25 Connector on Pin 25 Place strap position 1 and 2 on J3 f or DC power supply . See Figure 6 below . Figure 6. Strap positions 1 and 2 on J3 P ower -up 2124 via DB-25 Connector on Pin 21 Place strap ...
-
Patton electronic 2130 - page 13
12 Figure 7. Strap positions 3 and 4 on J3 ...
-
Patton electronic 2130 - page 14
13 5.0 CONFIGURATION All configuration is done through software auto-detection f or the Model 2124/2130. Once y ou hav e configured your m ux or other equipment to be connected to the 2124/2130, the unit is ready f or operation. Observe that the serial por t of the 2124/2130 is configured as a DTE and must connect to a DCE. The LAN por t also re ...
-
Patton electronic 2130 - page 15
14 LED Descriptions Figure 8. 2124/2130 rear view The status LED blinks y ellow from one to ele v en times to indicate system status. Each pulse patter n is separated by a 2 second "off " period. Greater pulse patterns have higher priority (buff er saturation has greater prior ity than an empty MA C table). V alid system statuses are: Aft ...
-
Patton electronic 2130 - page 16
15 Figure 9. F ront of Model 2124/2130, showing LED indicators TXD- T rasmit data LED (green) b links to indicate data transitions and remains OFF when no data is transmitted (idle). RXD- Received data LED (g reen) blinks to indicate data transitions and remains OFF when no data is received (idle). DTR- Control LED (yello w)- turns ON at power up t ...
-
Patton electronic 2130 - page 17
16 APPENDIX A PATTON ELECTR ONICS MODEL 2124 SPECIFICATIONS LAN Connection: RJ-45, 10BaseT , 802.3 Ethernet supported by T ransparent LAN bridging DTE connection: DB-25 connector , V .24 (DTE orientation) Protocol: PPP (RFC 1661) with Bridging Control Pro- tocol (RFC 1638) MAC Address T able Size: 4096 entries MAC Address Aging: MAC addresses delet ...
-
Patton electronic 2130 - page 18
17 APPENDIX B PATTON ELECTR ONICS MODEL 2130 SPECIFICATIONS LAN Connection: RJ-45, 10BaseT , 802.3 Ethernet sup- por ted by T ransparent LAN bridging DTE connection: DB-25 connector , EIA-530 (DTE orienta- tion) Protocol: PPP (RFC 1661) with Bridging Control Protocol (RFC 1638) MAC Address T able Size: 4096 entr ies MAC Address Aging: MAC addresses ...
-
Patton electronic 2130 - page 19
18 APPENDIX C 2124/2130 FACTORY REPLACEMENT PARTS Part # Description 07M2121/2135C 2124/2130 User Manual 0805DCUI 100-250 V A C Univ ersal P ower Supply ...
-
Patton electronic 2130 - page 20
19 APPENDIX D 10BASET INTERFACE PIN ASSIGNMENT (RJ-45 FEMALE CONNECTOR) (DTE CONFIGURATION) Pin # Signal 1 TD + (data output from 2124/2130) 2 TD - (data output from 2124/2130) 3 RD + (data input to 2124/2130) 4 no connection 5 no connection 6 RD - (data input to 2124/2130) 7 no connection 8 no connection ...
-
Patton electronic 2130 - page 21
20 APPENDIX E V .24 T ER MINAL INTERFACE PIN ASSIGNMENT (DB-25 MALE CONNECTOR) Pin # Signal 1 Shield GND/F rame GND 2T D 3R D 4R T S 5 CTS 7 SIG GND 8C D 15 TX CLK 17 RCV CLK 20 DTR 21 DC P ower (+5VDC) 25 DC P ower (+5DC) ...
-
Patton electronic 2130 - page 22
21 APPENDIX F EIA-530 T ER MINAL INTERFACE PIN ASSIGNMENT (DB-25 MALE CONNECTOR) Pin# Signal 1 Shield GND/F rame GND 2 TD A 3 RD A 4 RTS A 5 CTS A 7 SIG GND 8 CD A 9 RCV CLK B 10 CD B 12 TX CLK B 13 CTS B 14 TD B 15 TX CLK A 16 RD B 17 RCV CLK A 19 RTS B 20 DTR A 21 +5VDC 23 DTR B 25 +5VDC ...
-
Patton electronic 2130 - page 23
22 APPENDIX G POWER SUPPLY INTERFACE Via 5VDC power jac k (J1) Center Pin: +5VDC @ 500 mA minimun Outer Barrel: Ground ...
-
Patton electronic 2130 - page 24
23 Notes _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ ___________________________________________________ ...
¿Tienes una pregunta acerca de Patton electronic 2130?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Patton electronic 2130, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Patton electronic 2130 probablemente compartirá una forma de solucionarlo.