-
Carrier 50GX - page 1
50GS, 50GX Single Packaged Electric Cooling Units Installation, Start-Up, and Operating Instructions 50GS Sizes 018-060, 50GX Sizes 024-060 NOTE: Read the entire instruction manual before starting the installation. This symbol → indicates a change since the last issue. TABLE OF CONTENTS SAFETY CONSIDERATIONS ...................................... ...
-
Carrier 50GX - page 2
Before performing service or maintenance operations on system, turn off power to unit. Turn off accessory heater power switch, if applicable. Electrical shock can cause personal injury. Recognize safety information. This is the safety-alert symbol . When you see this symbol in instructions or manuals, be alert to the potential for personal injury. ...
-
Carrier 50GX - page 3
Accessory lifting kit is only to be used with Small Packaged units which have a composite base pan with molded rigging holds. INSPECTION Prior to initial use, and at monthly intervals, all rigging brackets and straps should be visually inspected for any damage, evidence of wear, structural deformation, or cracks. Particular attention should be paid ...
-
Carrier 50GX - page 4
2. Place each of the four (4) metal lifting brackets into the rigging holds in the composite pan. 3. Tighten the ratchet strap unit tight. Lifting brackets should be secure in the rigging holds. 4. Attach the clevis or hook of sufficient strength to hole in the lifting bracket (See Fig. 6). 5. Attach safety straps directly to the field supplied rig ...
-
Carrier 50GX - page 5
Fig. 4A— Roof Curb Dimensions UNIT SIZE ODS CATALOG NUMBER A IN. (MM) B IN. (MM) C IN. (MM) D IN. (MM) 50GS018-042 50GX024-036 CPRFCURB006A00 8 (203) 11(279) 16-1/2 (419) 28-3/4 (730) CPRFCURB007A00 14 (356) 11(279) 16-1/2 (419) 28-3/4 (730) 50GS048-060 50GX042-060 CPRFCURB008A00 8 (203) 16-3/16 (411) 17-3/8 (441) 40-1/4 (1022) CPRFCURB009A00 14 ...
-
Carrier 50GX - page 6
Fig. 4B—50GS and 50GX Unit Corner Weights CORNER # 50GS 50GX 018 024 030 036 042 048 060 024 030 036 042 048 060 1 58 60 59 62 76 69 84 76 84 85 71 78 85 2 47 50 48 50 50 45 54 49 60 60 55 56 66 3 55 56 56 58 71 88 106 57 61 64 85 80 108 4 94 94 95 98 97 122 145 88 86 90 110 112 140 TOTAL WEIGHT 254 260 258 268 294 324 389 270 291 299 321 326 399 ...
-
Carrier 50GX - page 7
Lifting point should be directly over the center of gravity for the unit. Step 6—Connect Condensate Drain NOTE: When installing condensate drain connection be sure to comply with local codes and restrictions. Models 50GS and 50GX dispose of condensate water through a 3/4 in. NPT fitting which exits through the base on the evaporator coil access s ...
-
Carrier 50GX - page 8
CONFIGURING UNITS FOR DOWNFLOW (VERTICAL) DIS- CHARGE Before performing service or maintenance operations on the system, turn off main power to unit and install lockout tag or electrical shock could result. 1. Open all electrical disconnects and install lockout tag before starting any service work. 2. Remove return duct cover located on duct panel ...
-
Carrier 50GX - page 9
5. It is recommended that the unit base insulation around the perimeter of the vertical return-air opening be secured to the unit base with aluminum tape. Applicable local codes may require aluminum tape to prevent exposed fiberglass. 6. Cover both horizontal duct openings with the duct covers from the accessory duct cover kit. Ensure opening is ai ...
-
Carrier 50GX - page 10
Failure to follow these precautions could result in damage to the unit being installed: 1. Make all electrical connections in accordance with NEC ANSI/NFPA (latest edition) and local electrical codes governing such wiring. In Canada, all electrical connec- tions must be in accordance with CSA standard C22.1 Canadian Electrical Code Part 1 and appli ...
-
Carrier 50GX - page 11
Table 4—Electrical Data—50GS UNIT 50GS SIZE V-PH-HZ VOLTAGE RANGE COMPRESSOR OFM IFM ELECTRIC HEAT POWER SUPPLY Min Max RLA LRA FLA FLA Nominal Kw* FLA MCA Max Fuse orCkt Bkr MOCP 018 208/230–1–60 187 254 9 45 0.8 1.8 -/- 3.8/5.0 5.4/7.2 7.5/10.0 -/- 18.1/20.8 26.0/30.0 36.1/41.7 13.9/13.9 24.8/28.3 34.7/39.8 47.4/54.3 20/20 25/30 35/40 50/ ...
-
Carrier 50GX - page 12
Table 5—Electrical Data—50GX UNIT 50GX SIZE V-PH-HZ VOLTAGE RANGE COMPRESSOR OFM IFM ELECTRIC HEAT POWER SUPPLY Min Max RLA LRA FLA FLA Nominal Kw * FLA MCA Max Fuse or Ckt Bkr MOCP 024 208/230–1–60 187 253 10.9 54.0 0.9 2.0 -/- 3.8/5.0 5.4/7.2 7.5/10.0 -/- 18.1/20.8 26.0/30.0 36.1/41.7 16.5/16.5 25.1/28.5 35.0/40.0 47.6/54.6 20/20 30/30 35 ...
-
Carrier 50GX - page 13
Run the low-voltage leads from the thermostat, through the inlet hole, and into unit low-voltage splice box. Locate five 18-gage wires leaving control box. These low-voltage connection leads can be identified by the colors red, green, yellow, brown, and white (See Fig. 10). Ensure the leads are long enough to be routed into the low-voltage splice b ...
-
Carrier 50GX - page 14
leak. Leak test all refrigerant tubing connections using electronic leak detector, halide torch, or liquid-soap solu- tion. If a refrigerant leak is detected, see Check for Refrigerant Leaks section. c. Inspect all field- and factory-wiring connections. Be sure that connections are completed and tight. d. Ensure electrical wiring does not contact r ...
-
Carrier 50GX - page 15
Fig. 12—Wiring Diagram (208/230-60-1) C99003 15 ...
-
Carrier 50GX - page 16
Fig. 13—Wiring Diagram (208/230-60-3) C99004 16 ...
-
Carrier 50GX - page 17
Fig. 14—Wiring Diagram (460-60-3) C99005 17 ...
-
Carrier 50GX - page 18
When evaluating the refrigerant charge, an indicated adjust- ment to the specified factory charge must always be very minimal. If a substantial adjustment is indicated, an abnormal condition exists somewhere in the cooling system, such as insufficient airflow across either coil or both coils. Proceed as follows: 1. Remove caps from low- and high-pr ...
-
Carrier 50GX - page 19
inspected at least once each year by a qualified service person. To troubleshoot heating or cooling of units, refer to tables at the back of the book. The following are 50GS Cooling Charging Charts: The following are 50GX Cooling Charging Charts: NOTE TO EQUIPMENT OWNER: Consult your local dealer about the availability of a maintenance contract. Ta ...
-
Carrier 50GX - page 20
The ability to properly perform maintenance on this equip- ment requires certain expertise, mechanical skills, tools, and equipment. If you do not possess these, do not attempt to perform any maintenance on this equipment other than those procedures recommended in the User’s Manual. FAILURE TO HEED THIS WARNING COULD RESULT IN SERI- OUS PERSONAL ...
-
Carrier 50GX - page 21
Errors made when reconnecting wires may cause improper and dangerous operation. Label all wires prior to disconnec- tion when servicing. The minimum maintenance requirements for this equipment are as follows: 1. Inspect air filter(s) each month. Clean or replace when necessary. 2. Inspect indoor coil, drain pan, and condensate drain at least each c ...
-
Carrier 50GX - page 22
AIR FILTER Never operate the unit without a suitable air filter in the return-air duct system. Always replace the filter with the same dimensional size and type as originally installed. See Tables 1 and 2 for recommended filter sizes. Inspect air filter(s) at least once each month and replace (throwaway-type) or clean (cleanable-type) at least twic ...
-
Carrier 50GX - page 23
c. On all units remove blower assembly from unit. Remove screws securing blower to blower partition and slide assembly out. Be careful not to tear insulation in blower compartment. d. Ensure proper reassembly by marking blower wheel and motor in relation to blower housing before disassembly. e. Loosen setscrew(s) that secures wheel to motor shaft, ...
-
Carrier 50GX - page 24
CONDENSER COIL, EVAPORATOR COIL, AND CONDEN- SATE DRAIN PAN Inspect the condenser coil, evaporator coil, and condensate drain pan at least once each year. The coils are easily cleaned when dry; therefore, inspect and clean the coils either before or after each cooling season. Remove all obstructions, including weeds and shrubs, that interfere with ...
-
Carrier 50GX - page 25
System under pressure. Relieve pressure and recover all refrigerant before system repair or final unit disposal to avoid personal injury or death. Use all service ports and open all flow-control devices, including solenoid valves. If oil is detected or if low cooling performance is suspected, leak-test all refrigerant tubing using an electronic lea ...
-
Carrier 50GX - page 26
Table 10—Troubleshooting—Cooling SYMPTOM CAUSE REMEDY Compressor and condenser fan will not start. Power Failure Call power company Fuse blown or circuit breaker tripped Replace fuse or reset circuit breaker Defective thermostat, contractor, transformer, or control relay Replace component Insufficient line voltage Determine cause and correct In ...
-
Carrier 50GX - page 27
START-UP CHECKLIST (REMOVE AND STORE IN JOB FILE) I. PRELIMINARY INFORMATION Model No ............................................................................................................................................................. Serial No ................................................................................................ ...
-
Carrier 50GX - page 28
Copyright 2003 CARRIER Corp. • 7310 W. Morris St. • Indianapolis, IN 46231 50gsgx4si Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 6 Tab 6 8 PC 101 Catalog No. 535–00130 Printed in U.S.A. Form 50GS,GX-4SI Pg 28 9–03 Replaces: 50GS,GX- ...
¿Tienes una pregunta acerca de Carrier 50GX?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Carrier 50GX, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Carrier 50GX probablemente compartirá una forma de solucionarlo.